Stihl KM 110 R Support Question
Stihl KM 110 R Support Question
Find answers below for this question about Stihl KM 110 R.Need a Stihl KM 110 R manual? We have 1 online manual for this item!
Question posted by Anonymous-135985 on May 7th, 2014
Throttle Cable Replacement
i removed old cable and springs fell out . need diagram for spring position.
Current Answers
Related Stihl KM 110 R Manual Pages
Product Instruction Manual - Page 2
... the Throttle Cable 13 Mounting the Loop Handle 14 4-MIX Engine 15 Fuel 15 Fueling 16 Starting / Stopping the Engine ........ 17 Operating Instructions 20 Cleaning the Air Filter 21 Motor Management 21 Adjusting the Carburetor 21 Spark Arresting Screen in Muffler ... 23 Checking the Spark Plug 24 Replacing Starter Rope and Rewind Spring 25...
Product Instruction Manual - Page 8
...position.
a loose boot may damage the starter mechanism. For specific starting -throttle, engine speed will be absolutely sure that could ignite combustible fumes and cause a fire. Place the power tool on Starting in the instruction manual of control, be fast enough for the clutch to engage and move freely and always spring... as possible.
KM 110, KM 130
7
Keep...
Product Instruction Manual - Page 9
...odorless. Wrap your power tool using the starting throttle lock, as the engine is running working ...machine indoors or in poorly ventilated locations. Remove excess lubricant and all debris such as...or sparks, thereby increasing the risk of a felled tree) away from loss of an emergency,... control / stop switch to left-handers.
8
KM 110, KM 130
You may be damaged and cause an increase...
Product Instruction Manual - Page 10
...the upright position and never locate it where the muffler is near dry brush, grass, wood chips or other combustible materials while it is still hot.
!Warning!
KM 110, KM 130
9 ...maintained by any nonroad engine repair establishment or individual. MAINTENANCE, REPAIR AND STORING
Maintenance, replacement, or repair of performance and you make a warranty claim for maintenance and repair. ...
Product Instruction Manual - Page 13
... as far as stop and then screw it in the control handle (11).
: Push the control handle - Throttle Cable Adjustment On control handles with the wing screw at a right angle to Using this Manual"
12
KM 110, KM 130
onto the handlebar (7) so that the holes (13) line up the handlebar at the engine side...
Product Instruction Manual - Page 14
... push the slide to the bottom of the slot (see illustration). Adjust the throttle cable only after the unit is the precondition for correct operation in the normal operating position.
this sets the throttle cable correctly. STOP
2 1
: Press down the wing screw firmly. KM 110, KM 130
13
the control handle must be turned clockwise.
: Turn the handlebar...
Product Instruction Manual - Page 18
KM 110, KM 130
17 a quarter turn ).
: Remove the filler cap.
: Fold the grip flush with the top of the cap.
: If the grip does not lie completely flush with the cap and the detent on bike handle
Throttle trigger interlock (1), throttle trigger (2) and slide control (3). Controls
Control handle on the grip does not engage the recess...
Product Instruction Manual - Page 19
... start START (6) - the engine is still filled with fuel.
002BA181 KN 249BA007 KN
18
KM 110, KM 130 Starting Procedure : Hold down the throttle trigger
interlock and squeeze the throttle trigger. : While holding both levers in the direction of Slide Control STOP-O (4) - Positions of the arrow on , the engine can start
STOP- This is the starting...
Product Instruction Manual - Page 20
... it slowly and vertically into the housing so that the
slide control moves to the normal run position # -
KM 110, KM 130
19 English / USA
: Crank engine until you have a firm footing.
: Hold the... a brief period. At very low outside temperatures:
As soon as engine runs : Blip the throttle trigger so that the starter rope can rewind properly. and the engine settles down to e and...
Product Instruction Manual - Page 21
... Turn the choke knob to e. : Set slide control, interlock lever and
throttle trigger to starting throttle position. : Start the engine by flow of nuts and screws (not adjusting screws...to bed in during this period. Check tightness of cooling air. Throttle cable adjustment : Check adjustment of the throttle
cable -
After finishing work
Wait for engine to STOP-O. : Pull ...KM 110, KM 130
Product Instruction Manual - Page 22
... it out. : Fit a new filter element.
KM 110, KM 130
21 Do not wash. : Replace any major hardware.
266BA009 KN 266BA008 KN
Dirty air filters reduce engine power, increase fuel consumption and make starting more difficult. If there is only possible to g. : Take out the screw (1) and remove
the filter cover (2). : Clean away loose dirt...
Product Instruction Manual - Page 23
... and warm up engine for every 3300 ft (1000 meter) change the setting of throttle cable
and readjust if necessary - Rule of the high speed screw (H) may be reached with...replace if necessary. : Carefully turn for about
3 minutes. see "Adjusting the Throttle Cable" : "Check the spark arresting screen (not installed in engine speed It is possible that the tool does not move .
22
KM 110, KM...
Product Instruction Manual - Page 25
...Remove spark plug as described in chapter "Starting / Stopping the Engine".
: Clean dirty spark plug. : Check the electrode gap (A) and
readjust if necessary - Rectify problems which may create arcing that could ignite combustible fumes and cause a fire.
24
KM 110, KM...To reduce the risk of the spark plug.
operating at part throttle etc.) affect the condition of fire and burn injury, use ...
Product Instruction Manual - Page 26
KM 110, KM 130
25 Replacing Starter Rope and Rewind Spring
English / USA
249BA012 KN 249BA013 KN 249BA014 KN
1
1
3 4
6
5 2
1
Replacing the starter rope
: Move slide control in the new rope (see "Specifications") and then thread it through the top of c -
arrow to STOP-O.
: Take out the screws (1). : Lift the starter cover (2) off the
housing.
: Remove the spring clip (3). : Remove...
Product Instruction Manual - Page 27
... work gloves.
: Remove spring housing and the parts of the spring.
: Lubricate the new spring with a few drops of rewind spring.
249BA015 KN 249BA013 KN
3 4
5
Replacing a broken rewind spring
: Remove the rope rotor as shown in the rotor.
: Fit the washer (4) on the starter post.
: Use a screwdriver or suitable pliers to "Tensioning the rewind spring".
26
KM 110, KM 130 The bits...
Product Instruction Manual - Page 29
...clean and inspect it. : Store the machine in the fuel
tank replaced every year. out of the reach of about 3 months or longer:... carburetor diaphragms sticking together. : Thoroughly clean the machine - Inspections and Maintenance by authorized STIHL dealers.
28
KM 110, KM 130 English / USA
Storing the Machine
For periods of children and other unauthorized persons. pay special attention to...
Product Instruction Manual - Page 30
... hours of operation
Decarbonize after first 139 hours of operation, then every 150 hours of operation
Inspect
X
Replace
Retighten
Check Have replaced by dealer1) replace
1) STIHL recommends the STIHL dealer
* see "Guide to Using this Manual"
KM 110, KM 130
before starting work after finishing work area etc.), shorten the specified intervals accordingly
Complete machine Control...
Product Instruction Manual - Page 31
... Throttle Trigge 8 Slide Control 9 Throttle Trigger Interlock 10 Throttle Cable ...Retainer 11 Clamp (carrying ring) 12 Fuel Pump 13 Choke Knob 14 Air Filter Cover 15 Fuel Tank 16 Machine Support 17 Handle Support 18 Wing Screw 19 Loop Handle 20 Barrier Bar 21 Coupling Sleeve 22 Wing Screw # Serial number
* see "Guide to Using this Manual"
KM 110, KM...
Product Instruction Manual - Page 32
...Throttle Cable Retainer Secures the throttle cable to the harness.
12. Fuel Pump Provides additional fuel feed for easier engine starts.
14. Machine Support For resting machine on the ground.
17. Handle Support Connects the shaft and bike handle.
18. Wing Screw Locks handlebar in selected position...brushcutter to the drive tube.
11. KM 110, KM 130
31 Coupling Sleeve Connects the ...
Product Instruction Manual - Page 34
... this manual.
Maintenance and Repairs
Users of this unit should carry out only the maintenance operations described in some cases, by authorized STIHL service shops. KM 110, KM 130
English / USA 33 Other repair work may appear alone on small parts. Warranty claims following repairs can be accepted only if the repair has...
Similar Questions
Kombi Km-110 R
power head rotates on drive shaft when using pole pruner HT-KM
power head rotates on drive shaft when using pole pruner HT-KM
(Posted by whatacats 3 years ago)
How To Change The Throttle Cable
Directions on how to install a new throttle cable
Directions on how to install a new throttle cable
(Posted by Deanwcline 6 years ago)
Replacing Throttle Cable
How do i remove old throttle cable to replace it?
How do i remove old throttle cable to replace it?
(Posted by Anonymous-162532 6 years ago)
Km 110 R
Where do I find a parts break down for the KM 110 R Trimmer ?
Where do I find a parts break down for the KM 110 R Trimmer ?
(Posted by ihabstreey 8 years ago)