Singer One Support Question
Singer One Support Question
Find answers below for this question about Singer One.Need a Singer One manual? We have 19 online manuals for this item!
Question posted by cfife9056 on June 27th, 2016
Error
what is the c6 error on my singer sewing machine it's driving me crazy
Current Answers
Answer #1: Posted by tfarner7 on June 27th, 2016 6:28 PM
tfarner7
Member since:
April 2nd, 2011 Points: 429,890
Member since:
April 2nd, 2011 Points: 429,890
You are getting a thread breakage error. I'm presuming that you are getting repeated error 06 codes to write in. Before I start, though, you also get that error code if your bobbin is out of thread. The thread sensor thinks your thread has broken because your thread is not seated at all, or not seated enough, between your tension disks, which are on the right side of your tension dial. Take the cover off the thread path (page 52 in your user's manual), lower your presser foot, and turn the tension dial to zero. Use UNWAXED dental floss, and floss between those disks. Chances are there is loose threads and/or lint between the disks, preventing the thread from seating properly. When threading, make sure that your presser foot is UP (tension disks are spread to accept thread), and apply tension to your thread, both at the top and bottom, to make sure your thread gets between those disks. Thread it a few times with the cover off, if necessary; you don't need to have it on to embroider, although you can't use your needle threader with it off. Hope this helps you!
Related Singer One Manual Pages
Instruction Manual - Page 2
... a hazard." 6. If it to repair or replace at once." 21.
SINGER is damaged, you should always be replaced by or near children." 2. "This sewing machine should be safely recycled in this sewing machine. To unplug, grasp the plug, not the cord." 13. "Caution -
Return the sewing machine to persons: " 1. "Read all moving parts. Unplug the foot controller...
Instruction Manual - Page 5
... ambient temperature: Normal temperature Acoustic noise level: less than 70 db(A)
3 CARING FOR YOUR MACHINE Cleaning hook area and feed dogs 50 - 51
Cleaning the sewing machine and foot controller
4. TABLE OF CONTENTS
1. PERFORMANCE CHECKLIST 54 - 55 Helpful messages, System error 56 - 57
For European version
Dimensions: 33 cm x 26 cm x 54.5 cm Mass...
Instruction Manual - Page 52
... highest position.
2
2. Remove two screws on the hook race as it is suggested.
3. CARING FOR YOUR MACHINE
CLEANING HOOK AREA AND FEED
DOGS
Always disconnect the machine from power
1
supply by the arrows. (A, B)
NOTE: Singer brand sewing machine oil is necessary to remove dust from the electrical
CAUTION outlet. NOTE: U se dry rags to its...
Instruction Manual - Page 54
... de la largeur Control ancho
Toward right Vers la droite Hacia derecha Turning off the machine returns the machine to selecting a pattern. Use a backing of parallel stitches for single needle sewing.
STRAIGHT STITCH NEEDLE POSITION
The position of a Singer brand 3mm (Style 2025) twin needle is an attractive stitch used to back.
2. Twin needle...
Instruction Manual - Page 58
... you have selected. Position the bobbin winder shaft to the left position for sewing and to remove top thread from bobbin winder shaft. It only indicates the connection or ... The buttonhole lever is pushed. Select a stitch pattern that caused the system error to stop.
1. Machine does not operate due to thread tangles in bobbin case or jamed fabric. Turn...
Instruction Manual 2 - Page 1
S. A. Form 18416 Rev. (1151)
SINGER*
ELECTRIC SEWING MACHINES 101-4 and 101-12
WITH ATTACHMENTS 120606
HORIZONTAL ROTARY HOOK, FOR FAMILY USE
* A Trademark of THE SINGER MANUFACTURING COMPANY
THE SINGER MANUFACTURING COMPANY
PRINTED IN U.
Instruction Manual 2 - Page 3
18416
SINGER
ELECTRIC SEWING MACHINES 101-4 and 101-12
WITH ATTACHMENTS 120606
HORIZONTAL ROTARY HOOK, FOR FAMILY USE
CABINET 40
THE SINGER MANUFACTURING COMPANY
Instruction Manual 2 - Page 32
..., SHOWING GREASE CUPS REMOVED
with the machine and sold only by turning it toward. you. To remove the motor. (a) Remove the motor cover (C, Fig. 2, page 5). (b) Remove the screw (F, Fig. 27, page 28) which holds the motor. (c) Withdraw the entire motor (J, Fig. 30) from the machine by Singer Sewing Machine Company. 30 To Lubricate the Motor...
Instruction Manual 2 - Page 34
... refilled, inasmuch as they can only be reached when the motor has been withdrawn' from the sewing machine head).
(h) Replace the grease cups, being sure that the wicks (GG, Fig. 30)... the well (K, Fig. 31) in which the spiral pinion (L, Fig. 31) revolves, with SINGER MOTOR LUBRICANT, (not oil).
(g) Apply SINGER MOTOR LUBRICANT to the teeth of the two bevel gears (M, Fig. 32) next the spiral gears...
Instruction Manual 2 - Page 37
INSTRUCTIONS
FOR USING
ATTACHMENTS
120606
WITH
SINGER
ELECTRIC SEWING MACHINES 101-4 and 101-12
Instruction Manual 3 - Page 1
INSTRUCTION MANUAL AND ACCESSORIES
Full zig-zag sewing machine free-arm
Model 1022
or Flat-bed
Model 1021
SINGER
Instruction Manual 3 - Page 55
GENERAL THESE WARRANTIES MAY ONLY BE USED BY TILE ORIGINAL CONSUMER OWNER OF THE SEWING MACHINE;
These warranties give you specific legal rights, and you may write to:
SINGER SEWING COMPANY 200 METRE PLEX DRIVE EDISON, NJ 08817
This sewing machine is warranted only in normal household (non-commercial) use provided for it any obligation or liability in...
Instruction Manual 4 - Page 12
... package for correct style and size of needle for twin-needle decorative stitching. IMPORTANT: Your SINGER sewing machine has been designed to obtain best results with large punctures, yet heavy enough to the back... Remember, too, that of the needle to pierce the fabric without being marred with SINGER* needles. SPOOL HOLDER
Place spool or tube of the needle must be placed against spool...
Instruction Manual 4 - Page 16
... unhook thread from needle threader. Release thread.
4. Holding approximately 3 inches (7.6cm) of thread between your local Singer Sewing Center. Flo 3.
10
USING THE NEEDLE THREADER
The needle threader may be purchased separately at your hands, loop thread...the right hand, position U-shaped part of hook. Thread the machine in thread on each side of threader under metal hook.
Instruction Manual 4 - Page 36
...allowing the entire line of stitching to be placed in the machine bobbin case to produce a chainstitch.
ADJUSTING TENSION
To find chainstitching useful.
• Sewing temporary hems and tucks to extend the life of children's .... Select needle and thread according to your local Singer Sewing Center. If the loops in the chain on the underside of insert positioned under the feed.
4.
Instruction Manual 4 - Page 47
...
• Attach right side of zipper foot to shank (needle will contain easy-to the machine.
CAUTION: Use the pattern selector to select straight stitch before attaching zipper foot to -follow ...the zipper. This eliminates the possibility of the needle:
• Attach left notch in your Singer Sewing Center, you will find many different kinds of zippers, one of the zipper. And, if...
Instruction Manual 4 - Page 72
... Machine surface. (If necessary, dampen the
cloth and use it . Remove lint or fluff from electrical supply-
cleaning the machine
CAUTION: Before cleaning your sewing machine requires servicing. Your machine... to clean the machine will examine the permanently lubricated parts whenever your machine, disconnect power-line plug from exposed parts.
Your SINGER representative, or Approved...
Instruction Manual 4 - Page 74
... when you have any questions, please write to electrical supply.
• Power and light switch is connected to : The Singer Company
Consumer Affairs Department 321 First Street
Elizabeth, N.
If the machine does not start to sew.
• Bobbin-case area is free of lint and loose thread ends.
• Bobbin is not damaged.
Instruction Manual 4 - Page 75
... is especially well adapted to stitching lightly padded fabrics. special accessories for special jobs
Sewing Aids have been designed to increase the versatility of straight stitching in block, floral,...and accuracy. The ruffler is ideal for the placement of your sewing machine and enable you to give your local Singer Sewing Center. Gathering Foot
No. 161169
The gathering foot can be used...
Instruction Manual 4 - Page 77
If you record the serial number of your machine. Serial No
Enjoy Sewing! Dear Customer:
We recommend that for location of serial number on your Sewing Machine in U.S.A. Refer to illustration at right for future reference you have any questions, please write to: The Singer Company
Consumer Affairs Department 321 First Street
Elizabeth, N.J. 07207
'A Trademark of...
Similar Questions
How Do I Clear E7 Error Code On Singer Fashion Mate Model 7256 Sewing Machine
(Posted by cathyhowden1 2 years ago)
I Get E7 Error Message On My Singer Model 7258 Sewing Machine. There Is No Refe
Error message E7 is up on my Singer Stylist model 7258 sewing machine. It is not working at all. I t...
Error message E7 is up on my Singer Stylist model 7258 sewing machine. It is not working at all. I t...
(Posted by ebellamybellamy9 5 years ago)
C6 Error Continues. Re-threaded The Machine Multiple Times Ensuring The Thread W
have rethreaded the machine sooooo many times following the video to ensure the thread was "under th...
have rethreaded the machine sooooo many times following the video to ensure the thread was "under th...
(Posted by Kblakey11 7 years ago)
Getting C Error Ten Machine Quits Sewing Pause Will Sew A Few Stocked Ten C Erro
getting C error I pause it sews a couple seconds and Cerror again the stitches seem fine
getting C error I pause it sews a couple seconds and Cerror again the stitches seem fine
(Posted by Christychristensen58 7 years ago)
C6 Error
I keep getting a c6 error on my singer one machine. I lost my manual and I can't keep figure it out.
I keep getting a c6 error on my singer one machine. I lost my manual and I can't keep figure it out.
(Posted by Kpunderwood 9 years ago)