Singer Expert Finish Support Question
Singer Expert Finish Support Question
Find answers below for this question about Singer Expert Finish.Need a Singer Expert Finish manual? We have 2 online manuals for this item!
Question posted by Mcameron52 on May 21st, 2017
Iron Won't Start
when I try to turn on the temp it goes to max 8 and won't hea
Current Answers
Answer #1: Posted by Odin on May 21st, 2017 4:36 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
Possible solutions:
- The temperature setting is too low - set the temperature to a higher setting.
- Auto-Off has been engaged - move or shake the iron gently to de-activate Auto-Off.
If the problem persists or if you require further explanation, you'll have to consult Singer: use the contact information here--https://www.contacthelp.com/singer/customer-servic....
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Singer Expert Finish Manual Pages
Instruction Manual - Page 1
EF
Household Steam Iron
instruction manual
Instruction Manual - Page 2
...READ ALL INSTRUCTIONS BEFORE USING. Do not leave appliance unattended while plugged in, on an ironing board, or while it must be replaced by children. Burns can result in the reservoir....liquids.
3. When iron is used.
8. LCD Display Panel 5. Use caution when you turn a steam iron upside down as there may overheat.
This appliance should always be turned to touch hot ...
Instruction Manual - Page 3
... will show all symbols and then turn off with additives, including scents, starches, or fabric
conditioners, as described above.
• Consult the garment's label for recommendations.
4
Filling the Water Tank
• Ensure iron is especially hard or if you
return to ironing, make sure the iron reheats to the MAX mark. • Close the Water...
Instruction Manual - Page 4
... will stop flashing and an audible beep will sound. Temperature UP/ON-OFF Button
7 WE RECOMMEND USING THE CHART BELOW AS A GUIDE. Turning the Iron Off
• To turn the iron off with an audible beep
sound. • Press the Temperature UP/ON-OFF button. Selecting the Temperature
CONSULT THE GARMENT'S LABEL FOR TEMPERATURE...
Instruction Manual - Page 5
... few times to start this function. The iron is ready to use. It may be necessary to press the Burst of Steam button a few times to start this iron with an empty ... tank as described in succession. ironing your garments
Dry Ironing
• To iron without steam, turn the Variable Steam Control Dial to the "no steam" position .
• Plug the iron into a grounded electrical outlet.
...
Instruction Manual - Page 6
... off, the Auto-Off symbol will start flashing on its heel on a flat surface. • Plug the iron into a grounded outlet. • The LCD Display will show all symbols and then turn off . You may make a loud clicking sound during steam ironing, thereby extending the life of your SINGER Expert Finish Iron. STEAM AND WATER are VERY...
Instruction Manual - Page 7
... an audible beep will sound.
• Unplug the iron.
• Hold the iron horizontally over a sink with a damp cloth and wiped dry.
set to clean the iron. NOTE: Before using a quality iron soleplate cleaner. The LCD Display will turn the Variable Steam Control/SelfCleaning Dial to MAX
• Over use abrasive household cleaners or other chemical...
Instruction Manual - Page 8
..., TN 37068 or through the Customer Service Area of purchase. SINGER® SEWING COMPANY LIMITED WARRANTY EXPERT FINISH™ STEAM IRON
IMPORTANT: SAVE THIS DOCUMENT AND KEEP IT IN A SAFE PLACE
What Does ... legal rights, and you have other parts will be transferred or assigned. The SINGER Expert Finish™ Steam Iron is for a period of ninety (90) days from the date of two (2) years...
Instruction Manual 2 - Page 1
lean
Household Steam Iron
Auto c
EFSNG917.4 instruction manual
Instruction Manual 2 - Page 2
... water in any appliance being used near children. Disconnect the plug from the electrical outlet when filling with water before storing. Use caution when you turn a steam iron upside down as there may overheat. Do not leave the appliance exposed to touch hot surfaces.
SAVE THESE INSTRUCTIONS
WARNING: THE POWER CORD ON...
Instruction Manual 2 - Page 3
.... Temperature UP Button 13. Smart Auto-Off Indicator
B. Fabric Guide
TECHNICAL SPECIFICATIONS: Voltage: 120V, 60 Hz Power: 1700 Watts
WARNING: TO AVOID FIRE, NEVER LEAVE IRON UNATTENDED WHILE PLUGGED IN.
3 Spray Nozzle
2. Temperature DOWN Button E
B A. Burst of Steam Button 6. 360º Swivel Cord
LCD PANEL DESCRIPTION
7. Soleplate with Steam Vents C
12...
Instruction Manual 2 - Page 4
... indicate the temperature setting. This will indicate the iron is used as described in the "Filling the Water Tank" section.
• To turn the iron on page 6 of smoke and a light odor...the first time the iron is on the LCD Display will sound.
• On an ironing board or protected surface, iron an old towel or other heavy material until the display indicates MAX •••...
Instruction Manual 2 - Page 5
When you use a water softener, try using inexpensive bottled spring water.
• Never use water with regular tap water.
• If your water is unplugged. • Open the Filler Door located on the base of the iron. • Using the filling cup provided, fill the water chamber to the max mark. • Close the...
Instruction Manual 2 - Page 6
... the LCD Display no longer shows a temperature setting. NOTE: Never yank the cord to disconnect. Temperature UP Button
Temperature DOWN Button
6 Turning the Iron On and Off
• To turn the iron completely off, unplug from outlet. Always grasp plug and pull to disconnect from the grounded electrical outlet.
The LCD Display will illuminate...
Instruction Manual 2 - Page 9
... direct steam at the area. • Steam will penetrate into the garment, removing the wrinkles. • For stubborn wrinkles, wait 4 to start this function.
Burst of Steam 9 WARNING: NEVER IRON OR STEAM CLOTHES WHILE THEY ARE BEING WORN. NEVER DIRECT THE STEAM JET AT PEOPLE OR ANIMALS.
• Follow the instructions as...
Instruction Manual 2 - Page 10
... Expert Finish™ II Iron is not an on/off switch.
The Smart Auto-Off switches the iron off if it will take about 60 seconds to reach the previous soleplate temperature.
• Turn the iron ...completely off . NOTE: Auto-Off is equipped with an automatic shut-off as usual. • DO NOT SPRAY SILK. The iron will shut off , the will start flashing on...
Instruction Manual 2 - Page 11
...substances in the "Turning the Iron On and Off" section. • Select the MAX ••• 200º C temperature setting by pressing the Temperature
UP (+) button. • The MAX ••&#.... • Place the iron on its heel on a flat surface. • Plug the iron into a grounded outlet. • Turn the iron on the hardness of your SINGER® Expert Finish™ II...
Instruction Manual 2 - Page 13
Cleaning the Soleplate
In normal use, a coating may build up on water tank.
• The iron may not be hot enough - When the iron is cold and unplugged, the iron can be easily removed by using a quality iron soleplate cleaner. set to MAX ••• 200º C .
• Over use .
• Water may be on...
Instruction Manual 2 - Page 14
.... If the electronic parts and/or the other parts in material and workmanship. Who Is Covered By This Limited Warranty?
SINGER® SEWING COMPANY LIMITED WARRANTY EXPERT FINISH™ II STEAM IRON
IMPORTANT: SAVE THIS DOCUMENT AND KEEP IT IN A SAFE PLACE
What Does This Limited Warranty Cover?
The warranty for a period of the...
Instruction Manual 2 - Page 15
...incidental or consequential
damages, so the above limitation or exclusion may not apply to :
SINGER Sewing Company ATTN: Service Department 1224 Heil Quaker Boulevard LaVergne, TN 37086 What If I Get... Warranty? This original warranty document; Service under the warranty may be obtained by returning the IRON with: 1. Does State Law Affect My Rights? • This warranty gives you specific ...
Similar Questions
My Iron Leaves White Chips When Steaming.
Prior to leaving town for 3 months I emptied my iron. Today I filled it with "spring water" and when...
Prior to leaving town for 3 months I emptied my iron. Today I filled it with "spring water" and when...
(Posted by susanbishop 2 years ago)
Won't Turn On
Why won't my Singer Expert Finish iron turn on? It just keeps showing 8 8 8 .
Why won't my Singer Expert Finish iron turn on? It just keeps showing 8 8 8 .
(Posted by mamasi 3 years ago)
I Get E7 Error Message On My Singer Model 7258 Sewing Machine. There Is No Refe
Error message E7 is up on my Singer Stylist model 7258 sewing machine. It is not working at all. I t...
Error message E7 is up on my Singer Stylist model 7258 sewing machine. It is not working at all. I t...
(Posted by ebellamybellamy9 5 years ago)
Singer Expert Finish Iron Manual
I would like to know what type of water to use in this iron for steam like should it be steam or oth...
I would like to know what type of water to use in this iron for steam like should it be steam or oth...
(Posted by lindakketchum 9 years ago)
Beeping From Singer Sewing Machine Stylist Ii 5625
My sewing machine will beep and stop sewing after three inches of sewing. I have taken it to be repa...
My sewing machine will beep and stop sewing after three inches of sewing. I have taken it to be repa...
(Posted by arusheria 9 years ago)