Sharp XR-30S Support Question
Sharp XR-30S Support Question
Find answers below for this question about Sharp XR-30S - SVGA DLP Projector.Need a Sharp XR-30S manual? We have 1 online manual for this item!
Question posted by josetequila3 on January 1st, 2016
Sharp Projector Xr 30s
I Ned one part.. I donot now you name..but can send : p/c:pfilwa120wjzzP/n:OC.cw4bx.ad127E182394 12v 0.3A(Small disc 4 colores this have small motor)
Current Answers
Answer #1: Posted by TommyKervz on January 2nd, 2016 6:06 AM
TommyKervz
Member since:
January 10th, 2013 Points: 17,776,813
Member since:
January 10th, 2013 Points: 17,776,813
For all Sharp Parts and Service, please call Sharp toll free number 1-800-BE SHARP (1-800-237-4277).
Related Sharp XR-30S Manual Pages
Operation Manual - Page 1
MULTIMEDIA PROJECTOR
MODEL
XR-40X XR-30X XR-30S
OPERATION MANUAL
Introduction Quick Start
Setup
Connections
Basic Operation
Useful Features
Appendix
Operation Manual - Page 5
...RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
Be especially careful that SHARP may be required to give under the 1972
Consumer Product Safety Act, PLEASE READ CAREFULLY THE IMPORTANT
"LIMITED ... the parts, service and labor warranty applicable to your new SHARP Projector, using the projector, please read this operation manual carefully.
Operation Manual - Page 6
...SHARP ELECTRONICS CORPORATION Sharp Plaza, Mahwah, New Jersey 07430-2135 TEL: 1-800-BE-SHARP (1-800-237-4277)
U.S.A. ONLY
PRODUCT DISPOSAL
This projector utilizes tin-lead solder, and a pressurized lamp containing a small... radio communications.
This SHARP projector uses a DLP® chip. This very sophisticated panel contains 786,432 (XR40X/XR-30X) / 480,000 (XR-30S) pixels (micromirrors). ...
Operation Manual - Page 8
... 9 Accessories 10 Part Names and Functions 11
Inserting the Batteries 14 Usable Range 15
Quick Start
Quick Start 16
Setup
Setting up the Projector 18 Setting up the Projector 18 Standard Setup (Front... Menu) .. 39
Selecting the Picture Mode 39
Adjusting the Image 40 Adjusting the Color Temperature ......... 40 Progressive 40 Lamp Setting 40 Adjusting the Projected Image ("SCR - ...
Operation Manual - Page 12
... not to avoid personal injury caused by a Sharp Authorized Projector Dealer or Service Center.
Caution regarding placing of the projector ■ Place the projector on a level site within the
adjustment range ... washes out the colors, making viewing difficult.
Do not block the exhaust and intake vents. ■ Allow at least 11 13/16 inches (30 cm) of the projector ■ For ...
Operation Manual - Page 14
... manual (this manual and CD-ROM )
Note • Codes in "< >" are Replacement parts codes. Optional accessories
■ 3 RCA to the wall outlet in your nearest Sharp Authorized Projector Dealer or Service Center.
10
Operation Manual - Page 17
...operations.
37 MENU/HELP button 46 For displaying
adjustment and setting screens, and help screen.
30 RESIZE button
For switching the picture size (NORMAL, BORDER, etc.).
33 PICTURE MODE
button ...
(using a USB cable or the
optional remote receiver). STANDBY button
25
For putting the
projector into the
standby mode. POINTER button
32
For displaying the
pointer.
KEYSTONE button 28
For ...
Operation Manual - Page 19
... on the screen material. Remote control sensor
Note
• The signal from the fluorescent lamp.
30°
23n (7 m)
Remote control
Remote control signal transmitters
15
flected off a screen for easy operation. In this case, move the projector away from the remote control can be re- ever, the effective distance of the signal...
Operation Manual - Page 22
... to obtain the recommended ceiling-mount bracket (sold separately).
18 Before mounting the projector, contact your nearest Sharp Authorized Projector Dealer or Service Center to the screen with the projector's feet flat and level. Doing so will eliminate the need for Keystone correction and provide the best image quality. (See page 28.)
Standard Setup...
Operation Manual - Page 24
Setting up the Projector (Continued)
Screen Size and Projection Distance
NORMAL Mode (4:3)
Picture (Screen) size
Diag. [χ]
Width
... 10.1 m (33Ј 2Љ) 11.7 m (38Ј 4Љ)
250Љ (635 cm) 508 cm (200Љ) 381 cm (150Љ) 9.4 m (30Ј 9Љ) 10.8 m (35Ј 5Љ)
200Љ (508 cm) 406 cm (160Љ) 305 cm (120Љ) 7.5 m (24Ј 7Љ...
Operation Manual - Page 25
...available)
DVI-D
Note
• See page 60 "Computer Compatibility Chart" for use with the projector. Press "Fn" and "F5" keys simultaneously when using , an image may not be ...SHARP notebook computer). Refer to the specific instructions in your computer's external output port.
21 Connecting the Projector to Other Equipment
Before connecting, ensure that the power cord of the projector ...
Operation Manual - Page 27
...
Terminal on connected equipment
Cable
ø3.5 mm ø3.5 mm stereo or mono audio cable audio output (commercially available or available
terminal as Sharp service part QCNWGA038WJPZ)
Terminal on the projector
AUDIO 1
Monitor Amplifier
RCA audio output terminal
RCA audio cable (commercially available)
AUDIO 2
Audio output terminal
Cables for a camera or a video game...
Operation Manual - Page 32
...Note
• To return to adjust the Keystone Correction. • You can also use KEYSTONE on the projector.
direction.)
3 Press KEYSTONE. • The on-screen display of the Keystone Correction mode is called ... approximately ±20 degrees (when the resize mode is set to "NORMAL" (see page 30)).
1 Press KEYSTONE to enter the Keystone Correction mode. • You can also display the...
Operation Manual - Page 34
... K 1024) WXGA (1280 K 768)
NORMAL
XR-40X/30X XR-30S
BORDER
XR-40X/30X XR-30S
STRETCH
XR-40X/30X XR-30S
1024 K 768
800 K 600 768 K 576
600 K 450
1024 K 576
800 K 450
J
J
Input Signal
Computer XR-40X/30X XR-30S
Image type
NORMAL
Output screen image BORDER
STRETCH
Resolution Resolution
lower than lower than
XGA
SVGA
XGA
SVGA
*
*
4:3 aspect ratio
Resolution higher...
Operation Manual - Page 39
...selecting S-VIDEO or VIDEO.
*5 Adjustment range for XR-40X/XR-30X. *6 Adjustment range for XR-30S. There is basically no need to adjust "Tone", but you can be set in the projector. Menu Items
The following shows the items that...) input
Page 39
Page 39
Picture
SCR -
ADJ
Picture Mode Contrast Bright Color Tint Sharp CLR Temp Bright Boost Progressive Lamp Setting Reset
PRJ -
Operation Manual - Page 54
...the name of use . ONLY
Caution Concerning the Lamp
■ This projector utilizes a pressurized mercury lamp. In such a case, it is recommended that the lamp be replaced with this projector is... deterioration in the picture and color quality. The lamp will be very hot and may cause burns or injury.
• Wait at your nearest Sharp Authorized Projector Dealer or Service Center to ...
Operation Manual - Page 59
...command from the projector is being sent, send each command only after the response code for connection.)
Communication conditions
Set the serial port settings of the computer to match that of at least 30 seconds after ... in the range indicated in brackets
under Control Contents. *1 For setting the projector name, send the commands in the following order: command, parameter, and return code.
Operation Manual - Page 60
...124 (SVGA)
On
Off
On
Off
Start
Computer
Normal
Stretch
Border
DVI
Normal
Stretch
Border
RETURN
COMMAND PARAMETER
Power ON
Standby mode (or 30-second ...30, 45 T L T L _ _ _ 1 0% - 100%(Integer) T N A M _ _ _ 1 XR40X / XR30X / XR30S M N R D _ _ _ 1 XR-40X / XR-30X / XR-30S
P J N 1 * * * * OK or ERR
P J N 2 * * * * OK or ERR
P J N 3 * * * * OK or ERR
P J N 0 _ _ _ 1 Projector Name...
Operation Manual - Page 64
...; 768
SXGA 1152 ´ 864
1280 ´ 1024 SXGA+ 1400 ´ 1050
VGA 640 ´ 480 SVGA 832 ´ 624 XGA 1024 ´ 768
SXGA 1152 ´ 870
Horizontal Frequency
(kHz)
27.0 31.5...When this projector supports other signals that conform to the projector's
native resolution (1024K768 for the XR-40X and XR-30X models or 800K600 for the XR-30S model). However, this projector receives 640K350 ...
Operation Manual - Page 68
...indicated are nominal values of continuous improvement, SHARP reserves the right to make design and ...frequency
Input current
Power consumption (Standby)
Operation temperature Cabinet Dimensions (main body only)
Weight (approx.)
XR-40X/XR-30X/XR-30S
0.55" DLP® Chip
XR-40X/XR-30X
XGA (1024 × 768)
XR-30S
SVGA (800 × 600)
F 2.5 - 2.6
Manual, ×1.15 (f = 20.4 - 23...
Similar Questions
Projector Lamp Is Ones On For Some Second And Projector Are Restart
Projector are aniwear restart
Projector are aniwear restart
(Posted by Anonymous-166921 3 years ago)
Sharp Xr 10s - Notevision Svga Dlp Projector.
Main board needed. Where can I get? Used is fine. Budget $20
Main board needed. Where can I get? Used is fine. Budget $20
(Posted by sanoorvishwa 8 years ago)
How Do I Get Sound On The Sharp Projector Xr-55x?
The sound is coming from my computer, not the projector. The speaker setting is ON. I have pushed ...
The sound is coming from my computer, not the projector. The speaker setting is ON. I have pushed ...
(Posted by 12carol21 11 years ago)
Sharp Projector Xr-10k Won Light Up I Changed The Lamp Vol On Contr Board Are Ok
(Posted by ruestas01 12 years ago)