Sharp CV-2P10SC Support Question
Sharp CV-2P10SC Support Question
Find answers below for this question about Sharp CV-2P10SC.Need a Sharp CV-2P10SC manual? We have 1 online manual for this item!
Question posted by Soul7power on July 27th, 2017
My Air Conditioner Is Not Cooling Could It Be A Fuse
My air conditioner is not cooling, could it be a fuse
Current Answers
Answer #1: Posted by BusterDoogen on July 27th, 2017 1:08 PM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,397
Member since:
October 30th, 2011 Points: 28,565,397
POWER PLUG CHECK: This unit uses a fused power plug. Always check the power plug before use.
1 Press the RESET button.
2 Insert the power plug into the wall socket.
3 Press the TEST button. You will hear a CLICK if the circuit breaker is functioning correctly.
4 Press the RESET button until you hear another CLICK. The circuit breaker is activated, power is supplied, and the unit is now ready for use.
I hope this is helpful to you!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Related Sharp CV-2P10SC Manual Pages
CV-2P10SC Operation Manual - Page 3
... REMOVAL OF EXHAUST HOSE EN-14 • PRE-OPERATION CHECKS EN-16
USE FOR AIR CONDITIONER • COOL MODE EN-18 • DEHUMIDIFICATION MODE EN-18 • FAN MODE EN-19 • VENTILATION MODE EN...EN-27 • BEFORE CALLING FOR SERVICE EN-28
Declaration of Conformity SHARP ROOM AIR CONDITIONER CV-2P10SC This device complies with Part 18 of FCC rules. Sharp Plaza, Mahwah, New Jersey 07495-1163 TEL: ...
CV-2P10SC Operation Manual - Page 5
...
Sharp Plaza, Mahwah, New Jersey 07495-1163 EN-3
CV-2P10SC_en.indd 3
11.3.22 11:00:11 AM Warranty Period for the Sealed Cooling System parts; This warranty does not apply to the...shall Sharp be liable, or in the United States. Your Product Model Number & Description:
CV-2P10SC Portable Air Conditioner.
YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.
Additional Item(s) ...
CV-2P10SC Operation Manual - Page 6
... or relocate the receiving antenna. • Increase the separation between the room air conditioner and radio/TV receiver. • Connect the room air conditioner into an appropriate wall socket. WARNING FOR POWER SUPPLY CORD • This unit...; Always conduct a "Power Plug Check" before use a fuse with the installation instructions in fuse. CV-2P10SC_en.indd 4
EN-4
11.3.22 11:00:11 AM
CV-2P10SC Operation Manual - Page 7
... whenever moving the unit.
ferent level during dehumidification mode. EN-5
CV-2P10SC_en.indd 5
11.3.22 11:00:12 AM
ing any water... Place the unit on a level surface to a grounding plug.
Cooling performance may freeze inside the hose, causing water inside the unit to... into the room. • Do not block the exhaust air outlet with a cord that is properly installed and grounded. ...
CV-2P10SC Operation Manual - Page 8
...°F - 95°F
• A built-in cool mode. EN-6
CV-2P10SC_en.indd 6
11.3.22 11:00:12 AM
Any previous settings will be sure to drain out water within the following temperature range.
Setting the unit to its initial settings.
• Low temperature operation: Is your unit freezing up?
Warm air will rise.
CV-2P10SC Operation Manual - Page 9
...be placed within reach of a properly rated grounded socket.
• Never place any obstacles around the air inlet or out- This will also help to avoid water spilling out into the room.
• ...firm foundation to minimize noise and vibration. let of space from the wall for direct installation.)
EN-7
CV-2P10SC_en.indd 7
11.3.22 11:00:12 AM For safe and secure positioning, place the unit on...
CV-2P10SC Operation Manual - Page 10
EN-8
CV-2P10SC_en.indd 8
11.3.22 11:00:13 AM
PART NAMES FRONT VIEW
1
1 Air Outlet
2
2 Vertical louvers
3
3 Horizontal louvers
4
4 POWER Button
5
5 Receiver window (for remote
6
control)
7
6 AIR CON Lamp (green)
8
7 TIMER Lamp (orange)
9
8 MAXIMUM Lamp (red)
10
9 ION GENERATOR Lamp (blue)
10
10 Air inlet
10
REAR VIEW
11
11 Exhaust air outlet
12
12...
CV-2P10SC Operation Manual - Page 11
... 19 20 21 22 23 24
1
1 Tramsmitter
2 Display
AIR CON MODE ONLY 3 A/C Button
4 TEMP Button
5 MAX COOL Button
2
6 MODE Button
7 SLEEP Button
8 ON TIMER ...COOL Symbol
21 ION GENERATOR Symbol
22 MAX DENSITY Symbol
23 SLEEP Symbol
24 FAN SPEED Symbols
: AUTO
: Quiet
: Low
: High
25 Temperature and timer count down indicator
26 Transmitting Symbol
27 ON TIMER/OFF TIMER Symbol
CV...
CV-2P10SC Operation Manual - Page 18
...service. Disconnect the power plug and call for use the unit if the above procedure cannot be using a thin
pointed implement. EN-16
CV-2P10SC_en.indd 16
TEST RESET
Battery cover
11.3.22 11:00:15 AM CAUTION: Do not attempt to use .
NOTES: • The... Press the RESET button. 2 Insert the power plug into the wall sock- PRE-OPERATION CHECKS
POWER PLUG CHECK This unit uses a fused power plug.
CV-2P10SC Operation Manual - Page 20
... AUTO and cannot be
2
changed.
COOL DEHUM
FAN
VENT
2 Press the A/C button to start operation. • The green AIR CON lamp will light. Remove the stopcock and attach the hose to the drainpipe and lead to a floor drain to allow water to select DEHUMIDIFICATION mode. USE FOR AIR CONDITIONER
Use when the unit operates...
CV-2P10SC Operation Manual - Page 21
...
LOW
HIGH
CV-2P10SC_en.indd 19
EN-19
2 1 3
2 1 3
11.3.22 11:00:16 AM
ENGLISH FAN MODE
The unit simply circulates the air.
1 Press the MODE button to set fan speed.
TO TURN OFF Press the OFF button. • The green AIR CON lamp will light. • The temperature cannot be set.
COOL DEHUM...
CV-2P10SC Operation Manual - Page 22
...
in the diagram and adjust the air flow direction. Condensation may result.
LEFT / RIGHT AIR FLOW DIRECTION Hold the vertical louver as shown in the COOL mode with the fan speed set to "QUIET (
)"
for an extended period of time.
USE FOR AIR CONDITIONER
TO CHANGE AIR FLOW DIRECTION
UP / DOWN AIR FLOW DIRECTION
1 Press the LOUVERS...
CV-2P10SC Operation Manual - Page 23
... SLEEP operation Unit shuts off
CV-2P10SC_en.indd 21
11.3.22 11:00:17 AM TO CANCEL Press the SLEEP button. • The orange TIMER lamp will turn off . Only the most recent settings will stop operating after the unit has run for 30 minutes in MAX COOL mode.
• The extra...
CV-2P10SC Operation Manual - Page 24
...you can set in half-hour increments and from 10 to 12 hours, in the display for 5 sec-
USE FOR AIR CONDITIONER
TIMER OPERATION ON TIMER
1 Press the ON TIMER button and set the time as desired. 0.5h 1.0h 1.5h ...the re- onds and then return to a maximum of half an hour to the timer display. EN-22
CV-2P10SC_en.indd 22
11.3.22 11:00:17 AM TO CANCEL Press the CANCEL button. • The orange...
CV-2P10SC Operation Manual - Page 25
....
For more information, please check our press release such as: http://www.sharp-world.com/corporate/news/080827.html
CV-2P10SC_en.indd 23
EN-23
11.3.22 11:00:17 AM Hot air will reduce airborne mold. There is SHARP's original technology.
ENGLISH
USE FOR ION GENERATOR
Use when the unit operates...
CV-2P10SC Operation Manual - Page 26
...again. • The red MAXIMUM lamp will light.
USE FOR ION GENERATOR
TO CHANGE AIR FLOW DIRECTION
UP / DOWN AIR FLOW DIRECTION
1 Press the LOUVERS button. • The horizontal louvers will return to ... operation can not be automatically cancelled in the diagram and adjust the air flow direction.
EN-24
CV-2P10SC_en.indd 24
11.3.22 11:00:18 AM MAX DENSITY OPERATION
The unit releases...
CV-2P10SC Operation Manual - Page 27
...The orange TIMER lamp will reduce odors of 12 hours. NOTES: • Adjust the louvers so that air from 10 to the
clothes.
• REFRESH operation and MAX DENSITY operation can not be used together.
... REFRESH operation and OFF TIMER can not be retrieved even after 5 hours.
EN-25
1
CANCEL
CV-2P10SC_en.indd 25
11.3.22 11:00:19 AM TO CANCEL Press the CANCEL button. • ...
CV-2P10SC Operation Manual - Page 28
... the POWER button during operation. Stopcock Drainpipe
CV-2P10SC_en.indd 26
EN-26
11.3.22 11:00:19 AM
The fan speed set at its last cooling settings. MAIN UNIT OPERATION
Use this operation ...at 68˚F. DRAINAGE
Drain out water within the unit in the cooling mode, set to the drainpipe. COOL (The green AIR CON lamp will light)
ION GENERTOR (The blue ION GENERATOR lamp will light)
...
CV-2P10SC Operation Manual - Page 29
... FILTER Remove the grill and clean the air inlet filter with a mild soap. If the filter is clogged with dust, the airflow will be cleaned every two weeks.
Doing so may result in poor cooling performance. Avoid splashing water onto the unit. EN-27
CV-2P10SC_en.indd 27
11.3.22 11:00:19...
CV-2P10SC Operation Manual - Page 30
...air will not be heard immediately after the power is set to FAN, DEHUMIDIFICATION, VENTILATION, ION GENERATOR mode? Run the unit in or is the plug loose? • Has the fuse blown or is frozen. For efficient operation, make the hose as short as possible.
This is full.
EN-28
CV...unit is turned on or off, and also during cooling operation within 3 minutes of ozone which may cause ...
Similar Questions
Sharp Cv-p10pc Floor Air Conditioner
the three lights, operation, mega cool, timer, are all blinking. I have emptied the water but the li...
the three lights, operation, mega cool, timer, are all blinking. I have emptied the water but the li...
(Posted by Dikippie 3 years ago)
How To Program A Sharp Cv-2p10sc Portable Air Conditioner
(Posted by bdisda 9 years ago)
How Do You Empty Water From Sharp Portable Air Conditioner Model Cv-2p10sc
(Posted by regg1marc 9 years ago)
My Air Conditioner, Model Number Afq60pf, Is Not Cooling
the airconditioner seems to just operate like the fan. I have another model and it works perfectly...
the airconditioner seems to just operate like the fan. I have another model and it works perfectly...
(Posted by stanrosa 11 years ago)