Sharp CV10NH Support Question
Sharp CV10NH Support Question
Find answers below for this question about Sharp CV10NH - 10,000 BTU Portable Air Conditioner.Need a Sharp CV10NH manual? We have 1 online manual for this item!
Question posted by jamiekimpton on August 5th, 2020
Window Replacement Parts?
How can I buy a new window panel, exhaust cover, and adjustment panel. for this?
Current Answers
Answer #1: Posted by INIMITABLE on August 5th, 2020 11:42 PM
INIMITABLE
Member since:
April 3rd, 2020 Points: 2,084,120
Member since:
April 3rd, 2020 Points: 2,084,120
Hi, depending on which part you mean, you can probably find it here:
https://www.partstore.com/Model/Sharp/Sharp/CV10NH.
https://www.partstore.com/Model/Sharp/Sharp/CV10NH.
I hope this is helpful? PLEASE "ACCEPT" and mark it "HELPFUL" to complement my little effort. Hope to bring you more detailed answers
-INIMITABLE
Related Sharp CV10NH Manual Pages
CV-10NH Operation Manual - Page 3
... E-3 • PRECAUTIONS E-4 • LOCATION E-7 • INCLUDED E-7 • PART NAMES E-8 • INSTALL WINDOW PANEL E-10 • INSTALLATION AND REMOVAL OF EXHAUST HOSE .........E-14 • PRE-OPERATION CHECKS E-16 • COOL MODE E-18 &#...ENGLISH
This manual explains the proper use of your new air conditioner. This manual should be kept in a safe place for handy reference.
CV-10NH Operation Manual - Page 4
... Dealer Name Address City State Zip Telephone
TO PHONE: Dial 1-800-BE-SHARP (237-4277) for:
SERVICE (for your nearest Sharp Authorized Servicer) PARTS (for your Authorized Parts Distributor) ACCESSORIES ADDITIONAL CUSTOMER INFORMATION
TO WRITE: For service problems, warranty information, missing items and other assistance:
Sharp Electronics Corporation Customer Assistance Center 1300...
CV-10NH Operation Manual - Page 5
... the purchaser for parts or labor for your Product. In no charge to Obtain Service:
CV-10NH
Portable Air Conditioner. YOU MAY ALSO...its option, either repair the defect or replace the defective Product or part thereof with respect to the fi...
Sharp Plaza, Mahwah, New Jersey 07430-2135
E-3
Appearance items of purchase.
One (1) year parts and labor from defective workmanship...
CV-10NH Operation Manual - Page 6
...replaced with a new power supply cord obtained from that to which the
radio/TV receiver is not loose. • Do not pull, deform, or modify the power supply cord, or immerse it off immediately and disconnect the power supply.
Read the precautions on the plug before using your air conditioner. Replacement... Do not modify any part of this room air conditioner should cause interference to ...
CV-10NH Operation Manual - Page 7
...may spill out while being moved. • Remove the window panel in any doubt as to whether the appliance is properly ...is used . Extremely adverse weather may be performed whenever moving the air conditioner. (See Page 26)
If any maintenance or cleaning. •...plugged into the room. • Do not block the exhaust air outlet with a cord that is properly grounded.
Cooling performance...
CV-10NH Operation Manual - Page 9
...) of space from the wall for direct installation.)
E-7
ENGLISH
LOCATION
• The air conditioner should only be rolled on a firm foundation to minimize noise and vibration. Do...the air inlet or outlet of the unit.
• Allow at surfaces. Knife or scissors 4. Tape measure or ruler 3. MIN.12" (30cm)
INCLUDED
MIN.12" (30cm)
SUGGESTED TOOLS FOR WINDOW PANEL INSTALLATION...
CV-10NH Operation Manual - Page 10
PART NAMES
FRONT VIEW
1
1 Air Outlet
2
2 Vertical louvers
3 3 Horizontal louvers
4 Remote control signal receiver
4
window
5
5 POWER Button
6
6 OPERATION Lamp (red)
7 7 TIMER Lamp (orange)
8
9
8 MEGA COOL Lamp (green)
9
9 Air inlet
9
REAR VIEW
0
0 Exhaust air outlet
q
q Window exhaust adapter
w
w Exhaust hose
e
e Remote control hook
r
t
r Air filters
y
t ...
CV-10NH Operation Manual - Page 12
..., as you will now be unable to shut the exhaust cover.
(1) Remove the adjustment panel from the window panel, and cut the window panel to ensure that its four projections fit into the holes in the diagram.
Foam seal A (adhesive type)
4 Attach the window panel to the insect guard net. Projection
Window panel
3 Cut the foam seal A (adhesive type) to the proper...
CV-10NH Operation Manual - Page 13
... it to the adjustment panel.
6 Close the window sash securely against the Window panel.
Attach foam seal A to the window panel and extension panel, and attach foam seal B to the window panel. Adjustment panel 24"~36.8"
If the inner width of the window is between 24" (609mm) and 36.8" (934mm) inclusive.
(1) Open the window sash and place the window panel on the window stool.
(3) Slide the...
CV-10NH Operation Manual - Page 14
..."~24" Insert all three projections on the window frame.
(3) Secure the window panel to the same height as indicated
in the diagram. The window panel cannot be installed in windows less than 22" (559mm) high, as you will now be unable to shut the exhaust cover.
(1) Remove the adjustment panel from the window panel, and cut the window panel to the window frame with 2 screws.
CV-10NH Operation Manual - Page 15
... (934mm) inclusive.
(1) Open the window sash and place the window panel on the window frame.
(2) Slide the adjustment panel to fit the window frame height.
(3) Secure the window panel to the window panel.
Attach foam seal A to the window panel and extension panel, and attach foam seal B to the adjustment panel.
6 Close the window sash securely against the Window panel.
7 Cut the foam seal...
CV-10NH Operation Manual - Page 16
... to each other.
3 Slide and open the exhaust cover on the window frame side when it stops. Make sure they are securely attached.
2 Attach the exhaust hose adapter to the exhaust hose. Window exhaust adapter Extend Exhaust hose
Projection Hole
"TOP"
The exhaust hose should be on the window panel, and attach the window exhaust adapter. however, it must be installed or removed...
CV-10NH Operation Manual - Page 17
ENGLISH
Removal of the exhaust hose
1 Remove the window exhaust adapter.
Pull out and remove the window exhaust adapter by pushing down two "PUSH" markings, and slide and close the exhaust cover in the window panel.
2 Remove the exhaust hose adapter from the unit. "PUSH" Projection
E-15 Lift up and remove the exhaust hose adapter from the unit by pushing down on the two projections.
CV-10NH Operation Manual - Page 18
...air conditioner is functioning correctly.
4 Press the RESET button until you will appear on the display when batteries are the same type. • If the remote control does not operate normally after replacing...batteries from
the remote control. Battery cover
NOTES:
• The battery should last approximately one year under normal use the air conditioner if the above procedure cannot be ...
CV-10NH Operation Manual - Page 19
...hook it to the unit when not in use. CAUTION • Do not expose the signal receiver window to block out the sunlight. • Use of the
signal. • The unit may adversely
...when the unit receives the signal. • Make sure nothing, such as curtains,
blocks the signal receiver window. • The remote control operates up slightly and pull it . When attached, to remove the remote ...
CV-10NH Operation Manual - Page 25
Point the remote control at the signal receiver window on the unit.
1 Press the ON TIMER button. • The time setting will change the setting, the...re-
nal. • The time setting will turn on the unit will count down to your setting. Timer duration can set from 10 to turn on 6.5 hours later.
Select the mode, temperature and fan speed setting as follows.
0.5h 1.0h 1.5h 10h 11h...
CV-10NH Operation Manual - Page 26
...TIMER button and set the time as desired. • The time setting will change as you set from 10 to show the re- maining time. Display shown when you press the button as follows.
0.5h 1.0h...hour (30 minutes) to turn off 2.5 hours later. Point the remote control at the signal receiver window on the remote control display the next time you can not be retrieved even after the power is ...
CV-10NH Operation Manual - Page 28
..., 7/8" outer diameter)
Stopcock
"OPEN" position
5 Attach the hose to the OPEN position.
Stopcock
7 Replace the stopcock to the CLOSE position. Drain grommet Hose
6 Press the POWER button on the unit.
&#...COOL lamps will take about one minute.
4 Remove the hose from the drainage nozzle, and replace the stopcock. • Keep the hose band and drain grommet in case of re-used for...
CV-10NH Operation Manual - Page 29
... remove the window exhaust adapter from ...part of the unit.
2 CLEAN THE FILTERS • Use a vacuum cleaner to remove any residue by wiping with dust.
ENGLISH
MAINTENANCE
Be sure to disconnect the power from the window panel... or hotter) when cleaning. Insect guard net
MAINTENANCE AFTER AIR CONDITIONER SEASON
1 Perform drainage to drain out water within the unit. (See Page...
CV-10NH Operation Manual - Page 30
...window. • Check whether the remote control batteries are installed with dust? The water tank inside the unit.
• An audible gurgling sound may be heard for less than 3 minutes when, you restart the unit within the unit through the exhaust air outlet. Clean and replace...;owing inside the unit.
• This air conditioner evaporates water condensed during cooling operation within 3...
Similar Questions
Replacement Window Exhaust Unit For Sharp Portable Air Conditioner Model Cv-10nh
Do you have a replacement window exhaust kit available for sharp portable air conditioner model cv-1...
Do you have a replacement window exhaust kit available for sharp portable air conditioner model cv-1...
(Posted by jnohner18 2 years ago)
Parts For Discontinued Sharp Portable Air Conditioner/ Ion Generator..cv-2p10sc.
I need the back plate 9jq26116114 and extender panel 9jq26116121 for window that is 41 inches wide. ...
I need the back plate 9jq26116114 and extender panel 9jq26116121 for window that is 41 inches wide. ...
(Posted by Oldladyanderson 3 years ago)
Where Can I Buy The Window Panel Kit For Sharp 10,000 Btu Portable Air
conditioner
conditioner
(Posted by buEdna 10 years ago)
How To Drain Water From 10,000 Btu Sharp Portable Air Conditioner
(Posted by DBIBLEto 10 years ago)
How Do You Easily Drain A Sharp Portable Air Conditioner, Model # Cv-10nh?
I am having issues with my Sharp air conitioner, Model # CV-10 NH. I've misplaced the manual and can...
I am having issues with my Sharp air conitioner, Model # CV-10 NH. I've misplaced the manual and can...
(Posted by kashka 12 years ago)