Sanyo DP52440 Support Question
Sanyo DP52440 Support Question
Find answers below for this question about Sanyo DP52440 - 52" Diagonal LCD FULL HDTV 120Hz.Need a Sanyo DP52440 manual? We have 1 online manual for this item!
Question posted by jh126210 on January 11th, 2013
None Of My Hdmi Inputs Work, Is There A Fix?
First the sound went out on all 3 inputs. Now they don't work at all.
Current Answers
Answer #1: Posted by none64391 on June 29th, 2014 5:53 PM
none64391
Member since:
June 29th, 2014 Points: 0
Member since:
June 29th, 2014 Points: 0
The HDMI switch integrated circuit used on the board was discontinued by NXP due to problems. That failed part was a TDA9996HL switch.
I replaced mine with a TDA19997HL/C1. This got the 1st HDMI port working but there must be a software issue between the new (pin compatible) part and the present firmare that runs the switch over an I2C interface. At least one is working. The unit failed 18 months after buying it in 2011. It has been down a few years with only component video inputs when I tried to fix it. $4.72 for the part at Mouser, but you need rework equipment to change the 100 pin part.
Related Sanyo DP52440 Manual Pages
Owners Manual - Page 2
... NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
IMPORTANT SAFETY INSTRUCTIONS
1. Read these instructions.
3. Keep these instructions.
2. Heed all servicing to the television equipment, be fatal. Follow all instructions.
5. Clean only with them might be sure the antenna system is used as power-supply cord or plug is...
Owners Manual - Page 3
... Laboratories. Need help . If this equipment does cause harmful interference to radio or television reception, which the receiver is no guarantee that interference will not occur in the ...Reorient or relocate the receiving antenna. -
However, there is connected. - HDMI, the HDMI Logo and HighDefinition Multimedia Interface are designed to provide reasonable protection against risk of...
Owners Manual - Page 4
... THE LCD HDTV 5 STAND REMOVAL / WALL MOUNTING 5 GETTING STARTED- PROTECTING THE LCD SCREEN
CAUTION: The screen can cause permanent discoloration or dark spots.
• NEVER spray liquids on the screen.
Remote Control Battery Installation 5 Antenna Connections for children younger than two years of Pediatrics discourages television viewing for off-air or cable 5 BACK PANEL JACKS...
Owners Manual - Page 5
...television set and any other electronic equipment.
1 Remove the four (4) screws securing the foot stand.
Wall mounting of explosion if a battery is replaced by a skilled person. Need help?
Do not use a new battery with the use a firm and flat...www.sanyoctv.com
1-800-877-5032
5 POSITIONING THE LCD HDTV
• Always use of a 75 OHM coaxial cable. STAND REMOVAL AND WALL ...
Owners Manual - Page 6
... and HD equipment.
6
Need help?
GETTING STARTED
HDTV INPUT/OUTPUT REFERENCE
1
5
1 Digital Audio Output (Coaxial)
2 Component AV Input (VIDEO2 or VIDEO3)
Green (Y), blue (Pb), and red (Pr) Video inputs plus white and red (Audio) input jacks.
7 Stereo Audio Out (L/R) Jacks
8 USB Input
View pictures stored in a USB flash drive.
9
9 HDMI (INPUT1, INPUT2, & INPUT3)
An all digital AV...
Owners Manual - Page 7
... Video Game system. Audio Output L/R are used to hookup an external stereo Amplifier. (Do not connect external speakers directly to the HDTV)
PC INPUT is used to connect a USB mass storage device to watch digital images (JPEG only.)
HDMI (DVI) INPUT1 can replace the yellow Video connection for details. USB FLASH DRIVE
USB...
Owners Manual - Page 8
... antenna or cable connection and all AV equipment correctly to set the backlight to the HDTV's AV input jacks. Pressing the CHLM key finalizes the setup process.
AV INPUT SELECTION
Press the INPUT key to select the correct AV input for on screen trouble shooting guide. www.sanyoctv.com
1-800-877-5032
INITIAL ENERGY SAVING...
Owners Manual - Page 9
... switch on time (see Clock Timer on page 12.)
• CAPTION Key-Cycles through the sound modes.
• NUMERICAL Keys-Select channels directly. " (sub ch) key -Allows for the...input directly.
• PIX SHAPE Key-Cycles through the available aspect ratios.
REMOTE CONTROL OPERATION
• POWER Key-Turns your HDTV On or Off.
• ECO Key-Modifies the Energy Saver level (see HDMI...
Owners Manual - Page 10
... - Channel Scan Memory
Channel Scan Memory lists all disabled channels. NOTE: For information on local digital channels, visit www.antennaweb.org
IMPORTANT FACT: This HDTV maintains only one input must and will only be added. You will remain enabled. :Skip is Cable. Press ENTER to enable or disable the selected channel. NOTE...
Owners Manual - Page 11
... establish either a Component or Composite connection to the VIDEO INPUT 2 jacks on your On Screen menu's display language. ...pressing the CAPTION key during normal TV viewing) causes the HDTV to select Setup. NOTE: ECO key may also be ...LCD backlight brightness to reduce power consumption. • Level 1: Energy Saver feature is textual information transmitted along with the picture and sound...
Owners Manual - Page 12
... including the automatic power ON process and power OFF process. For example, a CEC-enabled device hooked up to your HDTV's HDMI input, setting the HDMI-CEC Function to ON enables you to ON, the TV will set the HDTV on stand-by will automatically turn on at the previously set Switch on Time.
NOTE: The...
Owners Manual - Page 13
... as brightness and cotrast are affected opposite. Best setting for less blur in scenes with Motion Sync set to reduce the HDTV's power consumption. When room lighting is dark, the panel brightness
and/or the picture setting parameters such as often than a common 60 Hz refresh rate TV would, allowing for original...
Owners Manual - Page 14
... (RRT5)
RRT5 (V-Chip Regional Ratings 5) is an advanced V-Chip ratings system for viewing by your children.
Therefore, it 's downloaded & stored in other countries.
When the HDTV detects compatible RRT5 data, it may be more ratings than can be displayed on one screen. NOTE: This feature is then modified to comply with...
Owners Manual - Page 15
...and Standard, which have its own picture mode (predetermined or manual.) Current input's selected option is indicated by pressing the CURSOR
keys. NOTE: CURSOR LM ...Dynamic Contrast
The Detailed Setting option allows for customized personal settings.
NOTE: Each AV input can have predetermined fixed picture parameter values, or choose the Manual option for the adjustment of 7 additional ...
Owners Manual - Page 16
... return to the previous menu screen. NOTE: Default Sound option returns all sound parameters to select Sound. ON-SCREEN MENU OPERATION SOUND
Display the On Screen menu and use the CURSOR ... SCREEN
1 Audyssey Dynamic Volume solves the problem of large variations in volume level between television programs, commercials, and between the soft and loud passages of movies. Modify the selected...
Owners Manual - Page 17
...HDMI cable and RCA audio cables (see HDMI (DVI) INPUT1 on the HDTV. Manual - Need help? NOTE: If computer has only DVI Output, a DVI to RGB adapter will be required, or, a DVI to the Picture or Sound parameters. Adjust the Dot frequency to match your Sanyo HDTV... that includes a Ferrite Core.
PC INPUT
Use your HDTV as a computer monitor by hooking up your HDTV. See PC Resolution chart on the...
Owners Manual - Page 18
...from the full view options menu to start the slideshow from the settings in TV and AV inputs.
Adjust Color, Tint, Contrast, Brightness, Sharpness and Dynamic Contrast.
FULL VIEW OPTIONS MENU
SLIDE...enable the Rotate, Full View and Start Slideshow functions. USB INPUT PHOTO VIEWER
View pictures on your HDTV with the use of a USB mass storage device (not included.)
USB FLASH DRIVE
...
Owners Manual - Page 19
...EFFECTIVE: March 1, 2007)
Your Sanyo HDTV is registered at the sole discretion of purchase, Sanyo Manufacturing Corporation warrants this TV to give us the television's model number and serial number when... PARTS AND LABOR WARRANTY
THIS LIMITED PARTS AND LABOR WARRANTY IS VALID ONLY ON SANYO TELEVISIONS PURCHASED AND USED IN THE UNITED STATES OF AMERICA, CANADA, AND PUERTO RICO, EXCLUDING...
Similar Questions
Hdmi Inputs Work Only Sometimes
The HDMI on this model DP52440 Sanyo only work sometimes and sometimes no signal indication. Is this...
The HDMI on this model DP52440 Sanyo only work sometimes and sometimes no signal indication. Is this...
(Posted by tvdoctor33 10 years ago)
Why Is It That When Using A Hmdi Cable Its Tells Me To Use The Dvi Audio Input 3
why is it that when using a hmdi cable its tells me to use the dvi audio input 3
why is it that when using a hmdi cable its tells me to use the dvi audio input 3
(Posted by danielmgraziano 11 years ago)
No Sound Sanyo 52 Inch
Trying to connect TV to dish box. Perfect picture yet no sound. HELP PLEASE
Trying to connect TV to dish box. Perfect picture yet no sound. HELP PLEASE
(Posted by Anonymous-78739 11 years ago)
Hdmi Input
When I turn on the new DP55441 I get a screen that asks me to choose "Home or Store", after I choose...
When I turn on the new DP55441 I get a screen that asks me to choose "Home or Store", after I choose...
(Posted by rbvett 12 years ago)