Home » Samsung » Ranges » Samsung FX510BGS

Samsung FX510BGS Support Question

Find answers below for this question about Samsung FX510BGS.
Need a Samsung FX510BGS manual? We have 1 online manual for this item!

Samsung Overview Questions Manuals Reviews Videos Research

Question posted by donvalk on August 31st, 2015

Burner Control Knobs

The simulated stainless steel covering on the burner control knobs is coming loose and/or bubbling up. They all need to be replaced. Samsung should replace them at no cost but I know that is not going to happen. Where can I get replacement knobs that will not do the same thing?Don ValkAustin, TX

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by TommyKervz on August 31st, 2015 7:55 AM

This answer was accepted by the poster of the original question.

TommyKervz

Member since:
January 10th, 2013

Points: 17,776,813

1,100
points

You can purchase them on this link: http://www.repairclinic.com/Shop-For-Parts/a13b160c31/Samsung-Range-Stove-Oven-Knob-Dial-Button-Parts

Or here: http://www.searspartsdirect.com/samsung-range-parts/DG64-00347A/0022/401/model-FX510BGSXAA0000/1482/0124002.html

The replacement knop part number for this ranger burner is DG64-00347A

Hope that is helpful.
Kervz at www.satechhelp.co.za

Related Samsung FX510BGS Manual Pages

User Manual - Page 5

...: Installation and Service This range must be properly located and installed in accordance with the controls. Electrical/Mechanical Unplug or disconnect...replace this appliance on each cavity side. Grates and griddles (if equipped) are heavy. Failure to shut it is specifically recommended in this range following the instructions found in the proper position within the outer rack. Know...

User Manual - Page 6

...burners, drawer burners, or interior surfaces of children. During and after use a towel or other flammable materials contact oven burners, drawer burners, or interior surfaces of the range. Children climbing on the range... recommend you utilize the control / door lockout feature to reduce the risk of injury if dropped on a foot. Cooking surfaces, grates, cooktop burners and caps, as well...

User Manual - Page 8

... the burner knob. - To prevent delayed eruptive boiling, ALWAYS allow heated beverages to prevent an abnormal flame. - When you can get inside the range and cause the parts inside to make sure it stays on the cooktop for at least 20 seconds after it is assembled to stand at least 10 minutes • Cover...

User Manual - Page 13

...the air inlet and exhaust necessary for the range to make sure no range parts have come loose during shipping. Make sure the wall coverings around the range. See the Installation instructions Remove all packaging ...burners are located behind the range, under the oven control panel, at the top and bottom of the cabinets. This appliance should be positioned so that is as wide as the range,...

User Manual - Page 14

.... Make sure the burners have ignited. Once the ignition is failed, let the knob to Off and wait...loose or hanging garments when using this range to low and stir frequently. They could ignite and burn you if they come in them may cause burns from the range during the firyer cooking. Flames that are turned to the side or rear of fire, electrical shock, injury, or death to cover the burner...

User Manual - Page 15

... open flame to bubble up of dangerous ...range and call a qualified service technician. Always turn the burners off before moving. important safety instructions Always heat frying oils slowly, and watch during frying, they should always be flamed under a ventilation hood that window. Always turn off the surface burner controls...you are flamed, they need to be stirred together before...

User Manual - Page 16

...not to prevent burning or personal injury. Stored items can damage the surface burner control knobs and even kitchen counter. NEVER cover WARNING an entire oven rack with the oven door closed to put out the... or any holes or passages in the container could cause a fire hazard or damage the range. Keep the oven free from meat before cooking. Reposition oven racks only when the oven is...

User Manual - Page 19

... new range 20 surface cooking 22 operating the oven 25 using the warming drawer 52 maintaining your appliance 54 troubleshooting 71 warranty 77 20 Overview 22 Lighting a gas surface burner 22 Manually lighting a gas surface burner 22 Flame size selection 23 Gas surface burners and control knobs 24 Cookware usage 24 Center burner grate 25 Oven control panels...

User Manual - Page 20

... roller guide rails (2) Electric heating element (not shown under burners) Cooktop burner control knobs (5) - introducing your new range FX710BGS_FX510BGS_DG68-00356A-01.indd 20 2011-08-19 �� 4:25:43 Cooktop burner caps Cooktop burners Cooktop burner heads (5) Cooktop burner cups (5) (not shown under burners) Electrodes (5) (not shown under drawer) Oven light (1) Convection fan...

User Manual - Page 21

... Storage drawer (1) Full-extension roller guide rails (2) Bake oven burner FX710BGS_FX510BGS_DG68-00356A-01.indd 21 ADJUSTABLE LEVELING LEGS (4) (not shown) ANTI-TIP BRACKET KIT (1) introducing your new range MODEL FX510BGS COOKTOP COMPONENTS Heavy-duty continuous cast grates - introducing your new range _21 2011-08-19 �� 4:25:44 Left burner grate - Right-rear burner control -

User Manual - Page 22

.... The flames should never extend beyond the bottom surface and/or up the sides of the surface burner and turn the control knob for melting chocolate Manually lighting a gas surface burner If a power failure occurs, the surface burners can still be lit manually. Failure to do so could result in product damage, personal injury, and...

User Manual - Page 23

surface cooking Gas surface burners and control knobs Your gas range cooktop has five gas burners. All sealed cooktop burners are of cooking temperatures to meet your cooking needs. The electronic ignition system sparks when the control knob is in [30.5 cm]) or larger pots and pans. FX710BGS_FX510BGS_DG68-00356A-01.indd 23 surface cooking _23 2011-08-19 ��...

User Manual - Page 24

... and pitting.) COPPER: Excellent heat conductor, but retains heat very well. CAST-IRON: A poor conductor, but discolors easily. Center burner grate Samsung gas ranges come with uneven cooking results. STAINLESS STEEL: Slow heat conductor with a center burner grate. Cooks evenly once cooking temperature is well-balanced. • Pan size matches the amount of food being prepared...

User Manual - Page 54

... the range has been pushed back into place. Care and cleaning of the above items can damage the surface. All of the oven The oven and surface burner control panels ...CONTROL/ DOOR LOCK pad for 3 seconds. Never use steel wool or abrasive cleansers. Oven control panel 1. To lock just the oven controls, hold the CONTROL/DOOR LOCK pad for any possibility of burning. • If the range...

User Manual - Page 55

.... Wipe off any type of cleaner into them could damage the range. Close the oven door, if you are ignition switches which carry the current that lights the surface burners. Stainless steel surfaces Do not use . 1. Within these WARNING holes are holding the CONTROL/DOOR LOCK pad for 3 seconds. Spraying into the manifold panel holes...

User Manual - Page 56

... gray areas. Do not move or clean gasket. Do not get gasket wet or allow moisture to get inside door surface outside door surface is stainless steel and should never be cleaned with glass cleaner or warm, soapy water with hot, soapy water and a soapy plastic scouring pad. The outside glass surface...

User Manual - Page 57

... 55. 5. Replace the control knobs in warm, soapy water. maintaining your appliance _57 2011-08-19 �� 4:25:58 Pull the control knobs straight off the surface burner control valve stems. Do not clean the control knobs in death, personal injury, or product damage. 4. Rinse and completely dry all surface burner knobs are not dishwasher-safe. 3. Clean stainless steel surfaces...

User Manual - Page 59

Concave line 10. Push in and turn each surface burner control knob to the LITE position, then back to a burner setting to make sure they operate properly. FX710BGS_FX510BGS_DG68-00356A-01.indd 59 maintaining your appliance Precise simmer burner(RR)cap should be set on top of the range cooktop. maintaining your appliance _59 2011-08-19 �...

User Manual - Page 71

...your new gas range. If, after trying the suggested solution, you experience a problem, look first for at 1-800-SAMSUNG (1800-726-7864...burner knob is not in the table below. Replace the fuse or reset the circuit breaker. If the problem persists, disconnect all occupants. It is not ignited. The oven control beeps and displays an error code. Check and level the range...

User Manual - Page 72

... the control knob and turn the control knob to a desired setting. See the Installation Instructions. Clean surface burner components. (See pages 58 and 59.) Contact your range. Call for the foods being used. See the Installation Instructions that came with your installer. See page 30. Oven thermostat needs adjustment. Clean electrodes. The display will turn off position. Replace...

Samsung Knowledge Base Results

We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!

General Support
.... screen, use the arrow buttons on again. Turn the power on the remote control to select "Yes" and then press enter. Download Instructions: Click here to go to the Samsung and enter your players firmware using the CD Method: A CD burner and burning software such as instructed, until the update is connected. A series...
How To Correct "Sync Out Of Range" Or " Video Mode Not Supported " Messages SAMSUNG
... If you will start correctly and will need to its native resolution and a refresh ... Driver To Plug and Play in Safe Mode go to visit the Download Center for your user's...Range or Video Mode not Supported Error: This happens when your screen resolution and refresh rate (HZ) is booting press and hold the Shift key. To correct this issue you don't know...Control Panel, then Display.
General Support
... cause an electric shock. Harsher chemicals (benzene, thinner, bleach, alcohol, acetone, ammonia) can erode the protective coating that is with a stainless steel cleaner or polish, which can leave streaks on the stainless steel finish. Do not spray water or cleaner directly on the rag and then clean the surface. Glass cleaner can be purchased...