RCA 25250RE1 Support Question
RCA 25250RE1 Support Question
Find answers below for this question about RCA 25250RE1 - ViSYS Cordless Phone.Need a RCA 25250RE1 manual? We have 1 online manual for this item!
Question posted by towgirl561 on February 24th, 2016
Cordless Phone Says Out Of Range
I have the RCA 2 line phone and the cordless phone says its out of range , I have a new battery but it still says out of range.
Current Answers
Answer #1: Posted by TechSupport101 on February 24th, 2016 9:03 AM
TechSupport101
Member since:
May 24th, 2013 Points: 12,171,305
Member since:
May 24th, 2013 Points: 12,171,305
Hi. Power cycle the base unit and observe. There are also some common troubleshooting steps on page 41+ of the User Guide here https://www.helpowl.com/manuals/RCA/25250RE1/12310 you should find very helpful.
Related RCA 25250RE1 Manual Pages
User Guide - Page 1
Model 25250
2-Line Intercom Speakerphone DECT6.0 Cordless Handset
Telephone Answering System User's Guide
Please read this manual before operating product for the first time.
User Guide - Page 4
... the equipment. Information for compliance could void the user's authority to 1.93GHz frequency range.
Use of 20 centimeters between the radiator and your body. Important Information
Notice: The ...other antenna or transmitter." Installation of this product.
For body worn operation, this phone has been tested and meets the FCC RF exposure guidelines when used with the belt...
User Guide - Page 5
...
Your cordless phone uses a digital security
Making Calls in the Speakerphone mode
system to protect against false ringing,
(from the base 24
unauthorized access, and charges to your
Making Call in the Speakerphone mode
phone line 8
(from Another
Register 17
Extension 28
Remove Handset 17
Ringer On/Off and Ringer Volume..........28
De-Register...
User Guide - Page 6
...31 Receiving and Storing CID Records.........31 Reviewing CID Records 31 Saving a CID Record to Phone Book Memory 32 Deleting a CID Record 32 Deleting All Call Records 32 Dialing Back 32...No Caller ID 42 Battery 42 General Product Care 42 Causes of Range..." shows in and out 41 Memory dialing doesn't work 41 Unit locks up and no communication between the base and cordless handset... 41 "...
User Guide - Page 7
... one installed.
Wall plate Modular
telephone line jack
If you don't have at least one phone in your package includes the following items:
Base Desk Stand
Battery Compartment
Cover
Handset
Belt Clip
AC power adaptor
Short Line Cord
Telephone 2- Parts Checklist
Make sure your home or office.
IMPORTANT: Because cordless phones operate on electricity, you will...
User Guide - Page 8
...audio/video senders, wireless computer networks, multi-handset cordless telephone systems, and some long-range cordless telephone systems.
Important Installation Guidelines
• Avoid ...lines.
Certain other communications devices may use the 1.9 GHz frequency for communication, and, if not properly set channels to your new telephone. If such interference continues, move the cordless...
User Guide - Page 11
... is packaged inside the compartment. NOTE: To ensure proper battery installation, the connector is keyed and can be inserted only one way. Connections & Setup
Installing the Phone Installing the Handset Battery
NOTE: You must connect the handset battery before use only the Thomson Inc. Plug the battery pack cord into position.
11 CAUTION: To reduce...
User Guide - Page 12
... home or office, you can use adaptors/couplers (not included) to the Line 1 + 2 jack on the back of the phone as a desktop or tabletop, or you can use one pictured here and can use the 2 single telephone lines plug into 1 dual lines. Choose an area near an electrical outlet and a telephone wall jack (RJ11C...
User Guide - Page 14
... into the power jack on the back of the builtin features.
Phone Setting 1. The charge indicator illuminates, verifying the battery is not set the clock. Programming Functions The system uses a ...to go to confirm and you don't properly charge the phone, battery performance is compromised. Press SELECT soft key (right) to menu "Phone Setting- If you may press the BACK Soft key (...
User Guide - Page 15
... to answer an incoming call without pressing the Talk/Spk/L1/L2 button. Date/Time From the Phone Setting Menu: 1. Programming the Telephone
Area Code (base only), Registration (handset only), De-Registration ...List (base only). Use the touch-tone pad to enter the last two digits of the current year (range: 00 to toggle between "P" (pm) and "A" (am). 8. Press SAVE soft key to your selection...
User Guide - Page 16
... soft key. Dial Mode (only applicable for base) The Dial Mode of Line 1 and Line 2 can be registered to handset) A cordless handset will show "PRESS "REG" TO INITIATE REGISTRATION" once the handset has...
display. Use the VOL (-
From the Phone setting Menu: 1. Press the VOL (- Press SELECT soft key to the base.
From the Phone Setting Menu: 1. Programming the Telephone
Auto ...
User Guide - Page 24
...?"
Press the End button when finished. Press Line 1 or Line 2 button on the screen. 4. The timer serves for a dial tone then dial the phone number. 3. or +) button to scroll to...let unit reset to Restore Setting. 3. Telephone Operation Making Calls with the Cordless Handset
1. Wait for both lines are hung up. Telephone Operation
Remote Password You can access the answering system ...
User Guide - Page 25
... the LINE 1 or LINE 2 soft key to 3 inches from the handset) 1. The handset will be dialed out.
Plug the headset into headset jack), an error tone is heard when the Headset button is compatible with the Optional Headset 1. For the cordless handset, press the Talk button. 6. Wait for a dial tone then dial the phone...
User Guide - Page 26
... finished, press Speaker button (in speakerphone) or Headset
button (in speakerphone
mode, -OR3. Cordless Handset To switch to de-activate.
26 Switching Between the Speakerphone, Handset, and Headset Mode Base...
For the base: 1. Press the corresponding Line button to cordless handset's receiver. or +) button during a call in headset mode) to the speakerphone, press ...
User Guide - Page 39
... messages so the answering system may record new messages. approved Nickel-metal Hydride (Ni-MH) battery model 5-2734, which can be erased in your 3-digit security code. Put the battery compartment door back on the battery used in remote access mode. If you do not properly charge the phone, battery performance will be announced and waits...
User Guide - Page 40
... telephone line is being worked cannot continue. UNAVAILABLE
Indicates that the function you want to enter a user name for the base. The system is busy or some other higher priority function is not connected.
EMPTY
Indicates there are no CID records in use your phone.
NEW CALLS
Indicates call Page signal Low battery warning...
User Guide - Page 41
... (for 14 hours).
shows in and out • The handset may be out of range of phone service you follow proper dialing sequence?
Handset does not ring • Make sure the handset...phones on your line. "Out of the base.
Remove the handset battery. Move closer to the base. • Make sure the battery is heard, see "No dial tone". If no communication between the base and cordless ...
User Guide - Page 42
... problems, even after recharging the battery, you need to replace the battery pack: • Short talk time • Poor sound quality • Limited range
General Product Care
To keep your...Solutions No Display • Charge the battery (for 14 hours). Or replace the battery. • Make sure the unit is connected to the
phone. • Clean the phone with a clean pencil eraser.
42
No...
User Guide - Page 48
...intercom call
29
3-way conference call with two
lines
29
4-way conference call (Line 1 +
Line 2 + 2 extension)
29
Accessory Information
47
Adding Phone Book Entries
33
Answering a Call
25
Answering...Changing the Battery
39
Conference Calls
29
Contrast
19
Copying a Phonebook Record 35
Cordless Handset
26
D
Date/Time
15
Deleting a CID Record
32
Deleting a Phone Book Record...
User Guide - Page 49
...Making Calls with the Cordless
Handset
24
Making Calls with the Optional
Headset
25
Memo Record
37
Memo Recording
37
Memory Full
39
Memory Log and Phone Book
Memory
33
...
19
Speakerphone, Handset, and Headset
Volume
29
Standby Screen
14
Storing a Redial Record in
Phone Book
28
Storing Record in One-Touch
Dialing
34
Switching Between the
Speakerphone, Handset, and
...
RCA Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Operating and Troubleshooting the RCA WSP150 Wireless Speakers
...alkaline cells in the correct polarity as cordless phones, cell phones and baby monitors are using batteries, they can cause interference . Make sure...range. How do I install the Speakers for many accessories can be some interference to the off .. If you encounter interference in audio equipment. Make sure the "Volume On/Off Control" knob is set the FREQUENCY ADJUST knob to a new... -
What is the difference between FRS and GMRS radios?
...like Family Radio Service (FRS) radios, and share some frequencies. Paint used by cordless phones, toys, and baby monitors. The following information is the difference between FRS and GMRS... over the general area of amplitude modulation (AM), and has a greater reliable range than the walkie talkies typically found on citizens' band (CB) at 27 MHz... of the battery for a FRS radio. -
Troubleshooting the Acoustic Research ARWH1 Mini-Bridge Headset
...range of this Mini-Bridge is low. Turn off automatically when the battery ...cordless phones and WiFi routers, may have manufacturer specific pairing requirements and you must use them to pair with this range.... What if the Sound cuts out on ? Returning Customer: Click Here to Go to the Ask A Question Page so you can submit a support request and we can affect this Mini-Bridge. New...
Similar Questions
How To Turn Volumne Up Speaking And Hearing From Phone Based And Cordless Phone?
How to turn phone volumne up from based andcordless-receiver. Can't hear from my end of the phone an...
How to turn phone volumne up from based andcordless-receiver. Can't hear from my end of the phone an...
(Posted by young91494 10 years ago)
I Need A Handset For A Telephone Rca 25201re1-a
Where can I get a handset for a telephone RCA 25201re1-a
Where can I get a handset for a telephone RCA 25201re1-a
(Posted by awpension 11 years ago)
I Have A Cordless 25250 Phone And One Of The Handsets No Longer Has Sound Or Dia
Today one of the cordless handsets stopped having sound or dial tone. It is charged - though and the...
Today one of the cordless handsets stopped having sound or dial tone. It is charged - though and the...
(Posted by jmjones 11 years ago)
Manual For Rca 25250re Cordless Phone
Help to get a manual for RCA 25250RE1_A cordless phone please
Help to get a manual for RCA 25250RE1_A cordless phone please
(Posted by aliciajmj 11 years ago)
New Cordless Phone
We need to replace a cordless phone, how do we un-register to old one from the base in order to regi...
We need to replace a cordless phone, how do we un-register to old one from the base in order to regi...
(Posted by stacey8371 12 years ago)