Poulan PPB430VS Support Question
Poulan PPB430VS Support Question
Find answers below for this question about Poulan PPB430VS.Need a Poulan PPB430VS manual? We have 1 online manual for this item!
Question posted by bolkowbob58 on May 6th, 2013
Weak Spark
PPB430VS will not start, the spark appears to be weak, carb is ok, replaced spark plug still same problem, sprayed starter fluid in cly and not a pop.
Current Answers
Related Poulan PPB430VS Manual Pages
User Manual - Page 2
...or bystanders.
The blower can be blinded or injured. Always stop unit and disconnect spark plug before opening the vacuum inlet door. Failure to
follow instructions could result in serious ... tilt the handle of the screwdriver toward the front of 30 feet (10 meters) when starting or operating unit. Save operator's manual.
Keep children, bystanders, and animals away from the...
User Manual - Page 3
... or face mask when working with loosely hanging straps, ties, tassels, etc., can cause sparks) in moving parts.
D Mix and pour fuel in dusty environments. D Make sure the...will follow all warnings and safety rules in good operating condition. WARNING: Inspect area before starting or operating unit. Avoid forcing the unit into
piles, around joints, or between bricks....
User Manual - Page 4
... muffler and spark arresting screen which can kill.
SPECIAL NOTICE: This unit is equipped with engine stopped and spark plug disconnected. D.... D Use only recommended Poulan PRO replacement parts; forest land and the states of these problems. Users who operate power tools on ...the avoidance of children. D Inspect unit before starting engine and letting it stops. When using your...
User Manual - Page 5
... sure
the impeller blades have stopped turning before opening the vacuum inlet door or attempting to insert or remove the vacuum or
-- 5 -- Always disconnect the spark plug before performing maintenance or accessing movable parts. NOTE: Knob must be loose enough to allow blower tube to be aligned. remove the tubes. Align the...
User Manual - Page 7
...starting. OPERATING POSITION
Blower
Vacuum
OPERATING TIPS S While vacuuming or blowing debris, hold the STOP switch in place. Upper Vacuum Tube
Elbow Tube
Lower Vacuum Tube
Starter Rope
Fuel Mix Fill Cap
Primer Button
Throttle Trigger
STOP Switch
Spark Plug... though Saturday. Comply with fewer pulls on the starter rope.
Activate primer button by moving the choke lever...
User Manual - Page 8
... gallon (4 liters) of alternative fuels will cause problems such as gasoline and are secure before blowing.... This engine is obtained by mixing 3.2 fluid ounces (95 ml) of 40:1. A... S Watch out for many lawn and garden applications, including areas such as
shown. Blow debris... area when starting position as gutters, screens, patios, grills, porches, and gardens. Alternative fuels...
User Manual - Page 9
... cloth.
-- 9 -- Pull starter rope sharply until engine runs, but no more pulls. NOTE: If engine dies with the choke lever in this unit does not cover items that have stopped turning before performing maintenance or accessing movable parts. then, pull the rope to STARTING A FLOODED ENGINE.
7. Always disconnect the spark plug before opening the...
User Manual - Page 10
.... 3.
After 50 hours of the following conditions: S Engine will not require replacement. S Turn idle speed screw clockwise to ensure the engine starts easier and runs better.
NOTE: Move choke lever to distribute oil. 6.
Reinstall the spark plug boot. Muffler Mounting Screw
MUFFLER AND SPARK ARRESTING SCREEN
WARNING: The muffler on fuel line; Adjustments may be...
User Manual - Page 11
.... Run
engine at end of season or if
it starts to distribute oil.
S Check entire unit for storage ...recommend that any damaged, broken, or worn parts. Slowly pull the starter rope 8 to 10 times to rust.
-- 11 -- SEASONAL STORAGE... Replace spark plug with all guards in your gasoline can weekly to cool, and secure the unit
before lengthy stor-
ENGINE S Remove spark plug and...
User Manual - Page 12
... spark plug and re-gap. 4. Fuel mixture incorrect. 2.
Carbon build up . 6. Replace with correct fuel mixture. 3.
replace. repair or replace.
2. Contact an authorized service dealer
4. Compression low.
1. Check for dirty fuel filter; Contact an authorized service dealer. 6. Air filter dirty.
3. Engine runs hot.
1. TROUBLE Engine will not start. Engine flooded.
2. See...
User Manual - Page 13
..., or income producing purposes.
30 DAYS - This warranty does not cover tune--up, spark plugs, filters, starter ropes, or blower and vacuum tubes that term as follows from the original date of ...engine. This is a limited warranty within the meaning of that will wear and require replacement with reasonable use of accessories and/or attachments not specifically recommended by
Poulan PRO. EPA...
User Manual - Page 14
...an
Poulan PRO authorized repair center as soon as a problem exists. Any warranted part which
is certified. DIAGNOSIS:
...air filter (covered up to maintenance schedule), ignition system: spark plug (covered up to be emissions compliant for the following use...whichever is not li-
WHAT IS COVERED: REPAIR OR REPLACEMENT OF PARTS.
WARRANTY COMMENCE- Warranty repairs should contact ...
Similar Questions
What Is The Spark Plug Model & Type Used In The Popular 3314
(Posted by Eristerling 2 years ago)
Spark Plug
i need the spark plug no. for the briggs and stratton motor on the poulan tractor PXT16542. thanks G...
i need the spark plug no. for the briggs and stratton motor on the poulan tractor PXT16542. thanks G...
(Posted by ltcolonel23 2 years ago)
Locaton Of Spark Plug
I have the poulan pro PR241 and cannot find the spark plug. Where is it located and how do I get to ...
I have the poulan pro PR241 and cannot find the spark plug. Where is it located and how do I get to ...
(Posted by jansmi61 3 years ago)
Gas To Oil Mixture Ratio
gas to oil mixture ratio for Poulan Pro PPB430VS
gas to oil mixture ratio for Poulan Pro PPB430VS
(Posted by windybs 6 years ago)
Poulan Pro Ppb430vs Will Not Crank
ppb430vs will not crank. Replaced soleniod module & spark plug. Set module to .014. Appears to b...
ppb430vs will not crank. Replaced soleniod module & spark plug. Set module to .014. Appears to b...
(Posted by futralrcha 10 years ago)