Pioneer VSX-D510 Support Question
Pioneer VSX-D510 Support Question
Find answers below for this question about Pioneer VSX-D510.Need a Pioneer VSX-D510 manual? We have 1 online manual for this item!
Question posted by Shonnielove on December 16th, 2012
Why Does It Power Off
It keeps cutting off, it stays on for a few seconds then it cuts off please help me..
Current Answers
Answer #1: Posted by davidp10333 on September 24th, 2013 5:24 AM
davidp10333
Member since:
August 11th, 2013 Points: 40
Member since:
August 11th, 2013 Points: 40
Hidden obscurely at the bottom of page 50 in the manual is the answer. DC in to output, see attachment.
I had previously discovered that pressing on the main PC board could induce the problem, further isolated it by applying pressure to the outpur amplifier modules on the heat sink and ultimately traced it to cold solder joints underneath the PC board where the output amp connects.
To aboind having to remove the sub assembly from the chassis, I used a DREML mini angle grinder to cut away the botton of the chassis, just under the amplifier connections, giving access to them and more in=mportantly, making it possible to test for success which is not possible when the power ams sub assembly is removed. I have photo's of the underside of the PC board if they are needed.
Immage upload was not allowed so just download the manual and see at the bottom of page 50 Good luck, David Prawde [email protected]
Related Pioneer VSX-D510 Manual Pages
Owner's Manual - Page 1
AUDIO/VIDEO MULTI-CHANNEL RECEIVER
VSX-D510
Operating Instructions
Owner's Manual - Page 4
...is located near a device that is emitting
infrared rays. • The receiver is for the VSX-D510 audio/video multichannel receivers. In the Additional Information section (p.34-35) you 've received the following ... noise to it.
It also describes how to set up all the other home theater components.
Loading the Batteries
Dry cell batteries (AA size IEC R6P) × 2
CAUTION:...
Owner's Manual - Page 5
... Cable Connections 4 Loading the Batteries 4 Operating Range of Remote Control Unit 4
02 Contents 5
03 Connecting Your Equipment 6 Connecting Digital Components 6 Connecting Audio Components 7 Connecting DVD 5.1 Channel Components 7 Connecting Video Components 8 Connecting Antennas 9 Using External Antennas 9 Connecting Speakers 10 AC Outlet [switched 100 W (0.8 A) max] 12 Operating Other Pioneer...
Owner's Manual - Page 6
... SPEAKERS
RL
CENTER SPEAKER
DIGITAL OUT
DIGITAL OUT COAX
The arrows indicate the direction of two digital inputs.
Connect your equipment, always make digital audio connections. 03 Connecting Your Equipment
Before making or changing the connections, switch off and the power cord is disconnected from the component to coaxial in on the receiver).
Owner's Manual - Page 7
... the power cord is disconnected from the wall outlet. The arrows indicate the direction of the audio signal.
If you experience noise, move the cassette deck farther away from the receiver. These are compatible with these jacks. Connecting DVD 5.1 Channel Components
DVD and LD discs are all analog connections and your analog audio components (like...
Owner's Manual - Page 8
... and the power cord is also a good idea to hook up their audio to a digital input (see page 7). R / TAPE
/ MD IN
SUB WOOFER
TO MONTOR TV
SUB WOOFER PREOUT SURROUND
L
CENTER DVD 5.1 CH
INPUT
Video deck
INPUT
OUTPUT
VIDEO VIDEO
L
L
R
R
INPUT VIDEO
TV (monitor)
8
En Connecting Your Equipment
Connecting Video Components
Connect your...
Owner's Manual - Page 10
...8 Ω to 16 Ω. Simply connect the speakers you connect the speaker on the right to the AC power source.
10
En MEMO: • Use speakers with just two stereo speakers (called "front" speakers in the manner...your TV as the center speaker, connect the CENTER PREOUT jack on this unit to the audio input jack on your TV.
Also make sure the positive and negative (+/-) terminals on the ...
Owner's Manual - Page 12
.... Do not pull out the plug by the receiver's POWER switch.
MEMO: • This unit should be stepped on. Operating Other Pioneer Components
By connecting a control cord (optional), you can also ...not require control cords. CONTROL OUT
VSX-D510
CONTROL IN OUT
MEMO: • You can cause a fire or give you find it with other cords. Check the power cord once in order to avoid ...
Owner's Manual - Page 13
...8226; Low cut filter ON/OFF setting mode (page 15) Use to cut the distorted ...order described below.
This is performed within 20 seconds.
04
13
En You only need to make...component to be assigned to the optical digital input.
1 Press RECEIVER to turn the power ...LOUDNESS FUNCTION MUTING
RECEIVER
FL DIMMER
REMOTE SETUP
MASTER VOLUME
AUDIO/VIDEO PRE-PROGRAMMED REMOTE CONTROL UNIT
4 3
•...
Owner's Manual - Page 17
...MUTING
RECEIVER
FL DIMMER
REMOTE SETUP
MASTER VOLUME
AUDIO/VIDEO PRE-PROGRAMMED REMOTE CONTROL UNIT
4,6 3
Optical digital input setting
Here you tell the receiver what component you have hooked up to the coaxial digital...CD-R, VCR or OFF).
Coaxial digital input setting
Here you tell the receiver what component you have hooked up to the optical input jack.
The test tone is output ...
Owner's Manual - Page 19
...SELECT indicators Lights to indicate the type of a Dolby Digital signal. DIGITAL : Lights when a digital audio signal is selected.
2 DTS indicator Lights when DTS mode is being received in ANALOG mode).
6... the power is played. DTS : Lights when a source with DTS audio signals is off .
8 MONITOR indicator Lights when MONITOR is on the level settings you make for the current component : ...
Owner's Manual - Page 20
...6 SOURCE button Use to turn on/off the components connected to change channels on pages 31-32.
2... when setting up the levels of the surround sound of the receiver. TV POWER button Use to prevent distortion. Displays & Controls
Remote Control
1 2
3
... 4¢
LOUDNESS FUNCTION MUTING
RECEIVER
FL DIMMER
REMOTE SETUP
MASTER VOLUME
AUDIO/VIDEO PRE-PROGRAMMED REMOTE CONTROL UNIT
=
~
! @ # $...
Owner's Manual - Page 21
... order: CD, tuner, CDR/TAPE, VCDR/DVR, DVD/LD, DVD 5.1 CH., and TV/SAT.
0 RECEIVER (POWER) button This switches between the AM and FM band when in different DSP sound modes or advanced listening modes.
! ...of effect in TUNER mode. Displays & Controls
7 THE FOLLOWING BUTTONS ARE BOTH CONTROLS FOR OTHER COMPONENTS (LIKE A DVD PLAYER) AND DEDICATED TUNER CONTROLS. YOU CAN USE THEM AFTER YOU HAVE ...
Owner's Manual - Page 22
...modes are also suited for classical music. You can also use with multi channel surround sound audio/visual sources (like .
2 STANDARD mode
This mode is good for a stereo surround effect... medium size movie theater, and is suitable for watching dramas on the reflected sounds emulates the raw power of being in Dolby Digital, DTS or Dolby Surround. A short delay on
sources marked 1 (...
Owner's Manual - Page 23
... CLASS MPX BAND
7
8
3
D.ACCESS 1¡
CHANNEL 4¢
LOUDNESS FUNCTION MUTING
RECEIVER
FL DIMMER
REMOTE SETUP
MASTER VOLUME
3 5
8
1 Turn on the power of the playback component.
2 Turn on .
7 Start playback of the component you choose which to listen to playback. If you have to use the FUNCTION button to select the source (see p. 30...
Owner's Manual - Page 25
...the effect level can be adjusted in each surround effect.
1 Turn on the power of the playback component.
2 Turn on the front panel.
3 Press a MULTI CONTROL button to ...
19 ¡ 0
EFFECT 4 ‡ E¢ NTER
LOUDNESS FUNCTION MUTING
RECEIVER
FL DIMMER
REMOTE SETUP
MASTER VOLUME
AUDIO/VIDEO PRE-PROGRAMMED REMOTE CONTROL UNIT
3 4
1 22
Î
MULTI CONTROL DVD/LD TV/SAT VCR/DVR CD
...
Owner's Manual - Page 27
... remote control. buttons to select the desired station memory number. The VSX-D510 can be easily recalled.
1 2
DVD/LD TV/SAT VCR/DVR... Directly to a Station, on pages 26 and this page, for about 5 seconds and the receiver stores the station. The display shows a blinking memory class. ...which the station is only possible from the AC power
outlet for a lengthy period, the station memories ...
Owner's Manual - Page 28
... MONITOR are unsure whether yours has manual controls.
4 Start recording, then start playback of the source component.
1
SOURCE CLASS MPX BAND
7
8
3
D.ACCESS 1¡
CHANNEL 4¢
LOUDNESS FUNCTION MUTING
RECEIVER
FL DIMMER
REMOTE SETUP
MASTER VOLUME
AUDIO/VIDEO PRE-PROGRAMMED REMOTE CONTROL UNIT
MONITOR
1
Record MONITOR
You can also use the MULTI CONTROL...
Owner's Manual - Page 29
... MUTING
RECEIVER
FL DIMMER
REMOTE SETUP
MASTER VOLUME
AUDIO/VIDEO PRE-PROGRAMMED REMOTE CONTROL UNIT
LED
2 4
3
1,5
1 Press REMOTE SET UP and 1 at any time Press REMOTE SET UP.
2 Press the MULTI CONTROL button for the component you enter the setup code, the remote emits a power ON/OFF signal. dB
dB
dB
dB
If...
Owner's Manual - Page 32
... DTV menu. Use as the GUIDE button for the VSX-D510 are dedicated to control the TV assigned to exit the menu screen. Use to switch DTV audio tracks
Use to the TVC button. Use to bring... the Rest of Your System
Cable TV/Satellite TV/TV/DTV Controls
This remote control can control these components after entering the proper codes (see p.29-30). Use the MULTI CONTROL buttons to select or adjust...
Similar Questions
My Pioneer Recicever Model Vsx-d457 Will Not Stay Powered Up
once the power button is pushed to start the recicever it turns on and have power on the display pan...
once the power button is pushed to start the recicever it turns on and have power on the display pan...
(Posted by samm061973 3 years ago)
Was Unplugged
Was unplugged for awhile and now it won't turn on No power
Was unplugged for awhile and now it won't turn on No power
(Posted by munrom63 3 years ago)
Powering Up Problem Vsx-47tx
Following a power outage my receiver will not stay powered on. It turns on then the standy light bli...
Following a power outage my receiver will not stay powered on. It turns on then the standy light bli...
(Posted by Bnjforeman 11 years ago)
What Is The Problem When ' Power Off ' Is Indicated Vsx -d510
(Posted by dwgraham 12 years ago)