Pfaff Tiptronic 2040 Support Question
Pfaff Tiptronic 2040 Support Question
Find answers below for this question about Pfaff Tiptronic 2040.Need a Pfaff Tiptronic 2040 manual? We have 1 online manual for this item!
Question posted by bscheid on March 26th, 2016
2040 Manual How To Reinstall The Left End Cover After Replace Light
After replacing the light bulb the left end cover refuses to go into place---is there a trick to thisThe machine is a 2040 Tiptronic approx 10 years oldThanks Bob
Current Answers
Answer #1: Posted by TechSupport101 on March 26th, 2016 11:40 AM
TechSupport101
Member since:
May 24th, 2013 Points: 12,171,305
Member since:
May 24th, 2013 Points: 12,171,305
Hi. The Owner's Manual is here https://www.helpowl.com/manuals/Pfaff/Tiptronic2040/184700 :)
Related Pfaff Tiptronic 2040 Manual Pages
Owner's Manual - Page 2
Owner's Manual - Page 4
...sewing machine (model 2040)
(1) (2> (3) (4)
Key Key Key Info
pair pair pair key
a b c
(stitch (stitch (stitch
width/pattern width controls) length/pattern length controls) density/balance controls)
(5) Carrying handle (6) Handwheel (7) "M" key
(8) Cursor keys
(9) Clear/pattern start key
(10...disk chart
(46) (47)
Hook cover (hook behind it) Free arm
(48) Sewing bulb (max. 5 W) (49) ...
Owner's Manual - Page 5
... as follows:
Read all instructions before using and before replacing bulb. The sewing machine should always be left unattended when plugged in this sewing machine is used or where oxygen is not working properly,
if it to persons:
1. Always unplug this appliance from the electric outlet when removing covers, lubricating, or when making any opening.
6. To disconnect, turn...
Owner's Manual - Page 7
... operation we have purchased a high- We wish you need. So now you now take any further questions, that is the only way to the model 2040. Congratulations!
Your new sewing machine can do, and to study the instruction book, nothing can get started! If you can go wrong.
After all the things the...
Owner's Manual - Page 11
... cutter Thread tension, general notes Threading Tie-off Tips for a perfect buttonhole Top cover with table of programs Top feed (integrated dual feed) Twin needle Twin needle, threading
Utility stitch programs, tiptronic 2040 Utility stitch programs, tiptronic 2030
Voltage switchover
Zippers, sewing in
7/9 hole foot/braiding foot 1 /4 inch quilt and patchwork foot
45 1 29
79...
Owner's Manual - Page 12
... smocking
Width upto mm
- -
6 6 6 6 6
6
6
3 6 ill
4.4 4.4
10 11 12 13 14
i!I buttonhole
0
Button attaching
program
For simultaneously seaming and finishing one 6 mm
needle...from left to right or from right to left, using the pattern mirror key)
stitch during sewing)
1 3 Stemstitch, narrow
1 4 Decorative elastic stitch
Durable elastic seam, e.g. Jtility stitch programs tiptronic 2040
...
Owner's Manual - Page 20
...) upwards. ie programs of the sewing machine are illustrated on the inside of the carrying case.
t,,,,,,,.,y
-'
A
iVllJY.I1J)JJ1.' 11If1II!ff Jilt!
I
Carrying case Place the enclosed lead cord, the foot control and instruction book into the compartment of the top cover.
Stitch
No.
2,
use
for
each
program
is
also
illustrated,
e.g. foot
to
use...
Owner's Manual - Page 21
... voltage changeover switch on (switch function I) the sewing lamp lights up and program No. 1 is set to the mains voltage for this sewing machine.
-
-- -
---
-- The foot control tvd ATK 0070 has to 11 0 V.
19 nOV The sewing machine is indicated in the display.
you require a mains voltage of the sewing machine. Master switch
When the master switch (1 3) is...
Owner's Manual - Page 23
... of the bobbing winder snaps into the slot of the bobbin.
When replacing
the the
detachable work support work support (free arm)
In order to sew upwards out of
using the free arm, swing the hole. Removing the detachable work support, make sure
to the left and it free
arm
of the sewing machine. Push the...
Owner's Manual - Page 25
...page 22. --
5 - --
.2040
.
-
As soon as in the hole provided. Threading Threading of the thread firmly and press the
I
foot control. Cut the thread, push the bobbin to the left and
remove bobbin from the second ...spool holder Insert the second spool holder in the case of the spool holder on the master switch
Hold the end of the ...
Owner's Manual - Page 30
Drawing-up the bobbin thread
Raise the presser foot While holding the end of the needle thread, press the foot control so the needle moves down and up the bobbin thread...lowered with the )resser foot lifter (51). Thread cutter
Pull the thread from the back to the left.
obbin thread
lose the hook cover (46) and pull the thread ider the presser foot to the front over the thread trimmer (49).
Owner's Manual - Page 32
Hold the end of the thread several imes around the bobbin in a clockwise direction.
uide the thread to wind bobbins even when the machine is fully threaded. Note: The take -up...the take -up lever (40). "FE PFFF
2040
I
Winding a bobbin through the needle
It is possible to the right under thread guide C. Place the thread from left to the top position. Raise the presser foot lifter...
Owner's Manual - Page 73
... with the fancy elastic stitch. Light-knit mending stitch
Prog. 23 (Model 2040)
The light-knit mending stitch is very suitable for overstit ching cuffs in stretch materials, e.g. It is a stretchable covering stitch.
terry cloth.
- Overlap the two fabric edges about 3/4 of the fabric. derful hand-quilted look by machine, e.g. Now the seam allowance can...
Owner's Manual - Page 86
... the "reverse sewing" key (33) one time after you have started sewing the button hole. Before the left side of the buttonhole is desired. IF
00
The word "man" appears in the dspIay, indicating a manual finish of the buttonhole is the same length as the right side of the buttonhole ends, the machine will slow down...
Owner's Manual - Page 98
... by pintucking.
-
The notch between the needle plate and the sewing machine provides space for heavier materials use the pintuck foot with 7 grooves and the small cording tongue...pintuck foot
- defined pintucks.
- Replace the needle plate. Using a water-soluble marker, draw a place
ment line for your 1 30/7 05 H-ZWI; 1.6 or 2.0
machine (e.g. This will
produce evenly spaced pintucks...
Owner's Manual - Page 103
...Sew all remaining pintucks. -
On softer leathers an embroidery needle works well.
- Very closely set stitch, i.e. Place...sewing needle. - Sew a second pintuck The second pintuck will remain visible in this foot makes it is important to 6 mm wide on the underside of this space. synthetic leathers and vinyl's to 3. - Replace...a decorative stitch to the left or the right Insert ...
Owner's Manual - Page 131
... be easily removed. Clean and oil the sewing machine every 1 0
-
1 5 hours of the cut-out, then press downwards at any other points. Before you hear it snap in the hook shown above and press the needle plate upwards first on the right then on the left It can now be oiled at the...
Owner's Manual - Page 133
... way's.
Switcir oil tire machine on tire display.
lire bobbin case is pulled solidly
irrto bobbin tension Rmthneari nrachine,
spring. Only use good quality threads. Make sure tlrread is riot properly imrserterl.
insert the bobbin our the end of the
case, push it back on again after approx. 10 seconds All segments must appear...
Owner's Manual - Page 134
... system
Package contents Sewing machine Carrying case Foot control Lead cord Accessories Instruction manual
408 x 290 x 1 87 mm 8.3 kg 120V/220... 240V 75W 12V/5W max. 950 stitches/mm mm. 80 stitches/mm O...6mm 0..6mm 8mm 10.5mm 1 30 / 705 H
141 Technical data
Dimensions (w x h x d)
Weight
Nominal voltage (reversible)
Power consumption
Sewing lamp
Sewing speed
Stitching width...
Owner's Manual - Page 136
Parts of the sewing machine (model 2030)
(1) Key pair a (stitch width/pattern width controls) (2) Key pair b (stitch length/pattern ... (45)
Thread guide
Spool holder with unwinding disk Hole for second spool holder Top cover with stitch program chart Bobbin winder
(46) Hook cover (hook behind it) (47) Free arm
(48) Sewing bulb (max. 5 W)
(49) Thread cutter
(50) Thread take-up
(51) Presser...
Similar Questions
Will The Light Bulb And Case Effect The Computer Screen?
(Posted by cakemaker066 2 years ago)
Replace Left End Of Machine Cover,
Unable to snap left end of machine back on
Unable to snap left end of machine back on
(Posted by Anonymous-168256 2 years ago)
How To Change A Light Bulb In My Pfaff Creative 7550?
I have a Pfaff Creative sewing machine. How do I remove the left side panel to change the light bulb...
I have a Pfaff Creative sewing machine. How do I remove the left side panel to change the light bulb...
(Posted by ewitt63 8 years ago)
I Have A Pfaff Creative 7550. How Do I Open The Panel To Change The Light Bulb.
I have a Pfaff Creative sewing machine. How do I remove the left side panel to change the light bulb...
I have a Pfaff Creative sewing machine. How do I remove the left side panel to change the light bulb...
(Posted by ewitt63 8 years ago)
Pfaff 2040 Took End Cover Off And Pressure Foot Bar Is Loose ,wont Stay Up.
what to do?
what to do?
(Posted by Gkandtjkirk 9 years ago)