Oregon Scientific Aw129 Thermometer Is Not Receiving A Signal

In the Monitor

1. Slide down and lift the belt clip off the back of the monitor.

Slide then lift up to remove the battery compartment cover.

2. Place two AA batteries in the compartment as indicated by the polarity symbols (+ and -).

3. Press reset in the battery compartment using a pointed object such as a paper clip.

NOTE Reset both the monitor and the thermometer sensor

within 60 seconds to synchronize signal transmission.

4. Replace the cover and the belt clip. In the Thermometer Sensor

1. Slide the battery compartment cover open.

2. Insert two AAA size batteries into the compartment

matching the polarities (as shown). Press reset using a

pointed object such as a paper clip.

I hope this is helpful to you!

Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!