Home » NordicTrack » Exercise and Fitness » NordicTrack T 6.5z Treadmill

Get support for NordicTrack T 6.5z Treadmill

NordicTrack T 6.5z Treadmill Support Question

Find answers below for this question about NordicTrack T 6.5z Treadmill.
Need a NordicTrack T 6.5z Treadmill manual? We have 1 online manual for this item!

NordicTrack Overview Questions Manuals Reviews Videos Research

Question posted by Anonymous-154174 on September 7th, 2015

My Speed Changed On Treadmill. At 1 It Reads 1.6 On 2 It Reads 3....how Do I Get

Speed to go back to normal setting?

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by TechSupport101 on September 8th, 2015 2:38 AM

This answer was accepted by the poster of the original question.

TechSupport101

Member since:
May 24th, 2013

Points: 12,171,305

1,100
points

Here are the possible causes of your issue http://www.livestrong.com/article/313828-speed-problems-with-nordictrack-treadmills/

www.satechhelp.co.za

Related NordicTrack T 6.5z Treadmill Manual Pages

English Manual - Page 1

CUSTOMER CARE For service at any time, go to www.nordictrackservice.com. CAUTION Read all precautions and instructions in the space above for future reference. Save this equipment. Serial Number Decal ACTIVATE YOUR... USER'S MANUAL Write the serial number in this manual before using this manual for reference. Or call 1-800-TO-BE-FIT (1-800-862-3348) Mon.-Fri. 6 a.m.-6 p.m.

English Manual - Page 2

... front cover of ICON Health & Fitness, Inc. 2 Apply the decal in the location shown. TABLE OF CONTENTS WARNING DECAL PLACEMENT 2 IMPORTANT PRECAUTIONS 3 BEFORE YOU BEGIN 6 PART IDENTIFICATION CHART 7 ASSEMBLY 8 HOW TO USE THE TREADMILL 17 HOW TO FOLD AND MOVE THE TREADMILL 26 MAINTENANCE AND TROUBLESHOOTING 27 EXERCISE GUIDELINES 30 PART LIST 31 EXPLODED...

English Manual - Page 3

...exercise program, consult your local electronics store. 5. Do not use the treadmill in any surface that all users of this treadmill are adequately informed of all warnings and precautions. 2. Failure to use only. Read... physician. Do not place the treadmill on any commercial, rental, or institutional setting. 13. Keep children under the treadmill. 7. Do not wear loose ...

English Manual - Page 4

.... (See ASSEMBLY on page 8 and HOW TO FOLD AND MOVE THE TREADMILL on page 6 for the location of heart rate readings. If you feel faint, if you experience pain while exercising, stop immediately and cool down. 24. 20. Never leave the treadmill unattended while it is not in use , before performing the maintenance and...

English Manual - Page 6

... manual, please see the front cover of this manual. For your workouts at home more effective and enjoyable. The T 6.5 Z treadmill provides an impressive selection of features designed to make your benefit, read this manual carefully before contacting us assist you, note the product model number and serial number before you use the...

English Manual - Page 8

...persons. • Place all assembly steps. • After shipping, there may be an oily substance on the exterior of the treadmill. This is an oily substance on the treadmill, wipe it off with a soft cloth and a mild, non-abrasive cleaner. • Left parts are marked "L" or "... offers Note: If you finish all parts in a cleared area and remove the packing materials. If there is normal.

English Manual - Page 14

... shown. Make sure that the "This side toward belt" sticker (B) is completed. 12. Have a second person hold the Frame until step 15 is facing the treadmill.

English Manual - Page 15

... Latch (26) to the bracket on the Base (6) with a 5/16" x 2 1/4" Bolt (63) and a 5/16" Nut (34). Lower the Frame (56) (see HOW TO LOWER THE TREADMILL FOR USE on the Latch Crossbar (41) with a 5/16" x 1 3/4" Bolt (62) and a 5/16" Nut (34) as shown. Attach the upper end of the Storage Latch...

English Manual - Page 16

the hex key is used to the console, keep the treadmill out of plastic on the treadmill decals, remove the plastic. Note: Extra hardware may be included. 16 Then, slide the Left and ... belt (see pages 28 and 29). If there are properly tightened before you use the treadmill. 16. Firmly tighten all parts are sheets of direct sunlight. To protect the floor or carpet, place a mat under...

English Manual - Page 17

... surge suppressor must have a proper outlet installed by a qualified electrician. 17 If it will not fit an outlet, have a UL suppressed voltage rating of 400 volts or less and a minimum surge ... installed and grounded in the Power Cord The treadmill must be on or off. The surge suppressor must also be damaged by sudden voltage changes in damage to a permanent ground such as ...

English Manual - Page 18

...belt if necessary (see page 22. As you can change the speed and incline of the treadmill with the touch of a button. To use a set-a-goal workout, see page 29). In addition, the ... wireless network through an effective exercise session. Note: The console can even measure your workouts more effective and enjoyable. The first time you exercise. To use the settings mode, see page 19....

English Manual - Page 19

...you exercise, change speed until it to warm to room temperature before you use . Next, locate the power switch on . ing a few seconds. When the frame stops moving, the treadmill is turned on the treadmill ..., you plug in the power cord (see THE SETTINGS MODE on the foot rails of the clip. Change the incline of the treadmill as you may take the ETS597114 following steps to...

English Manual - Page 20

.... For the most accurate heart rate reading, continue to zero. IMPORTANT: If you do not do this, the treadmill's electrical components may damage the treadmill when you are finished exercising, remove the key from the metal contacts on the pulse Contacts bar. As you have walked or run, the speed of the walking belt, the...

English Manual - Page 21

... setting are finished exercising, remove the key from the console. The flash- Start the workout. Press the Start button or the Speed increase button to the speed and incline settings for the next segment. 3. Note: The same speed setting and/ or incline setting may show the maximum incline, the maximum speed, and the duration of the workout begins, the treadmill...

English Manual - Page 23

...settings. To stop the workout at the speed setting for the next segment. 6. Follow your heart rate if desired. See step 6 on page 20. The console will show a map of the trail you are finished exercising.... When the next segment of the workout begins, the treadmill will automatically adjust to the speed and incline settings for the first segment of laps you complete. 1. See...

English Manual - Page 24

...TRANSFERS DONE will function normally when you press the Home button. Exit the settings mode. To exit the settings mode, press the Settings button. TRAINER VOICE... may also select the following screens: UNITS-To change the unit of your iFit module. Press the Enter ...STATUS-Press the Enter button to be used if the treadmill is selected, the matrix will show the software version number...

English Manual - Page 25

... or another flat ETS597114 surface instead of the treadmill are using a personal CD player and the CD skips, set to place the treadmill in the same way. for less firmness, turn a cushion to the position shown in drawing 1; make sure that reduces the impact as you exercise, plug a 3.5 mm male to 3.5 mm male audio...

English Manual - Page 26

... kg) to the floor. 1 Storage Latch 26 CAUTION: Make sure that the storage latch locks. 2 Frame 2. Pull back on the wheels, and carefully move the treadmill without tipping it as described at the left. CAUTION: Make sure that the latch knob is locked in temperatures above 85° F (30° C). CAUTION...

English Manual - Page 27

... this manual. First, press the power switch into the console. IMPORTANT: Do not spray liquids directly onto the treadmill. Find the symptom that the key is plugged into a properly grounded outlet (see THE SETTINGS MODE on . Next, remove the five #8 x 3/4" Truss Head Screws (31), and carefully pivot the Motor Hood (65) off...

English Manual - Page 28

... screws counterclockwise, 1/4 of the treadmill does not change correctly a. b 2-3 in . (5 to the minimum level. The treadmill will recalibrate the incline system. When the incline system is about 1/8 in. (3 mm). Such substances may become damaged. Top View 1/8 in the power cord, insert the key, and run the treadmill for a correct speed reading. Repeat until the Magnet is...