NordicTrack E 8.7 Elliptical Support Question
NordicTrack E 8.7 Elliptical Support Question
Find answers below for this question about NordicTrack E 8.7 Elliptical.Need a NordicTrack E 8.7 Elliptical manual? We have 2 online manuals for this item!
Question posted by soldierbd1 on April 27th, 2014
Receiver And Receiver Wire Connect?
The Receiver Wire connects to the Receiver and the console, but where does the Receiver, the three-prong port attached to an adhesive circuit, go?
Current Answers
Related NordicTrack E 8.7 Elliptical Manual Pages
English Manual - Page 1
... YOUR WARRANTY
To register your product and activate your warranty today, go to www.nordictrackservice.com/ registration. USER’'S MANUAL Or call 1-800-TO-BE-FIT (1-800-862-3348) Mon.–-Fri. 6 a.m.–-6 p.m. Keep this equipment. www.nordictrack.com
Model No. 831.23948.2 Serial No.
English Manual - Page 2
... location shown. TABLE OF CONTENTS
WARNING DECAL PLACEMENT 2 IMPORTANT PRECAUTIONS 3 BEFORE YOU BEGIN 6 PART IDENTIFICATION CHART 7 ASSEMBLY 8 HOW TO USE THE ELLIPTICAL 15 FCC INFORMATION 27 MAINTENANCE AND TROUBLESHOOTING 28 EXERCISE GUIDELINES 30 PART LIST 31 EXPLODED DRAWING 33 ORDERING REPLACEMENT PARTS Back Cover LIMITED WARRANTY Back Cover
WARNING DECAL PLACEMENT
This...
English Manual - Page 3
...all warnings on each side. When connecting the power cord (see page 15), plug the power cord into a grounded circuit.
10. Do not use the elliptical in a commercial, rental, or ...responsibility for foot protection while exercising.
6. tained by an authorized service repre- Before beginning any worn parts immediately.
8. Use the elliptical only as an exercise aid in determining heart ...
English Manual - Page 9
... the packing materials (not shown) under the front of the Frame (1). son hold the Upright (4) against the Frame (1). Attach the Upright with two M10 x 115mm Screws (104). Orient the Upright (4) as shown.
4
Tip: Avoid pinching the wires. Remove the packing materials from tipping
while you complete this step. Have the second per-
English Manual - Page 10
... M10 x 20mm Screw (107) and an M10 Washer (111). Repeat this step to attach the Left Pedal Arm (38) to the Lower Wire (115). tors downward into the Shield Cover (30).
Press the connec- See the inset... drawing. Slide the Right Pedal Arm (37) onto the Right Upper Body Leg (26).
Connect the Upper Wire
5
(116) to the Left Upper Body Leg (28).
28 38
23 30
26 Grease
37 111
107...
English Manual - Page 13
....
Attach the Console (8) to the Right Pedal Arm (37) with four M4 x 16mm Screws (97).
While a second person holds the Console (8) near the Upright (4), plug the Upper Wire (116), the Pulse Wire (117), and the Receiver Wire (112) into the matching receptacles on the back of the Console.
12 8
The connectors on the other side of the elliptical.
41...
English Manual - Page 15
...an adapter. HOW TO USE THE ELLIPTICAL
HOW TO PLUG IN THE POWER CORD
This product must be on a nominal 120-volt
circuit. DANGER: Improper connection of
the power cord increases the ...
2-pole Receptacle Adapter
Lug Metal Screw
The lug or wire extending from the adapter must be installed by a qualified electrician. If it will not fit an outlet, have a proper outlet installed by a qualified...
English Manual - Page 18
... progress by competing against other users in the world with customizable Google Maps. Measure your workouts.
CONSOLE DIAGRAM
MAKE YOUR FITNESS GOALS A REALITY WITH IFIT.COM
With your new iFit-compatible fitness equipment, you reach your personal goals.
Upload your workout results to make your fitness goals a reality:
Exercise anywhere in the iFit community.
18
English Manual - Page 19
... module. You can change console settings, see page 20. IMPORTANT: If the elliptical has been exposed to cold temperatures, allow it to warm to communicate with the touch of a button. The console also features an iFit mode that enables the console to room temperature before you exercise.
You can even connect your MP3 player or CD...
English Manual - Page 20
...151;-When the manual mode is shown. When a workout is not inserted into the console and connected to reach the selected resistance level. My Trail—-This tab will show the approximate ...the resistance of the pedals and the incline of the numbered 1 Step Resistance buttons. As you exercise, the flashing rectangle will take a moment for a few seconds each segment represents the amount ...
English Manual - Page 21
... heart rate monitor).
If there are not pressed, the console will turn off and the display will indicate the approximate ...to the off automatically.
7. When your pulse is connected, the wireless symbol at least 15 seconds. If the display does ... you are finished exercising, unplug the power cord. As you do not do this, the electrical components on the elliptical may wear prematurely....
English Manual - Page 22
... rpm is comfortable for the current segment is divided into one target rpm (speed) are nished exercising, unplug the power cord.
To resume the workout, simply resume pedaling.
4. See step 5 on page... See step 7 on page 19.
2. The height of the workout. See step 4 on the console to keep your current pace. One resistance level, one ramp incline level, and one -minute segments....
English Manual - Page 23
...workout, the length of the desired goal appears in the display. The time will depend on the console. To resume the workout, simply resume pedaling.
4. As you burn will pause in the display.... will be affected. Measure your progress with the display. Note: If you are nished exercising, unplug the
power cord. Then, press the Enter button.
Follow your heart rate if desired....
English Manual - Page 24
... the console. If more information about the iFit workouts, please see HOW TO CHANGE CONSOLE SETTINGS on the console to your schedule. To purchase an iFit module at least 8 in the console.
When...you through your own wireless network including an 802.11b/g/n router with an internet connection and a USB port. Press the increase and decrease buttons next to the Enter button to use ...
English Manual - Page 25
... (not included) into the jack on the console and into a jack on your personal fitness goals.
The other personal audio player; To play button on your MP3 player, CD player, or other lines will enable you to continuously monitor your heart rate while you exercise, helping you exercise, plug a 3.5 mm male to reach your...
English Manual - Page 26
... If no module is connected to be available. Navigate the settings mode.
After a few seconds, the status of hours that has been pedaled on the elliptical.
To view distance in...display. HOW TO CHANGE CONSOLE SETTINGS
1. Units—-The currently selected unit of measurement, press the Enter button repeatedly.
Send/Receive—-The words SEND/RECEIVE DATA will appear in ...
English Manual - Page 27
... relocate the receiving antenna. •• Increase the separation between the equipment and the receiver. •• Connect the equipment ...into an outlet on , try to radio or television reception, which the receiver... compliance, use only shielded interface cables when connecting to provide reasonable protection against harmful interference in...
English Manual - Page 31
... Roller Arm Bushing Lift Motor Spacer Foot Reed Switch/Wire Resistance Motor Clamp Pedal Plate Pedal Arm Bushing Upper ... Pedal Axle Lift Bracket Bushing M10 x 50mm Bolt Friction Fastener/Screw Receiver Mechanism Spacer M8 x 16mm Screw M8 x 14mm Shoulder Screw M10... Insert Console Pulse Grip Front Ramp Right Track Rear Stabilizer Cover Ramp Cover Roller Arm Cover Lift Motor Lift Bracket Connecting Rod...
English Manual - Page 32
... Bolt M8 x 18mm Screw M8 Locknut M10 Washer Receiver Wire Drive Belt Power Cord Lower Wire Upper Wire Pulse Wire Pulse Grip Back Pulse Grip Cap Magnet
121 2
...Connecting Rod Bushing Left Pedal Handle M6 Small Washer Right Grip Arm Spacer User’'s Manual Assembly Tool General White Grease Packet PTFE Grease Packet Power Board Lift Motor Wire Resistance Motor Wire Blue Wire Green Wire White Wire...
English Manual - Page 36
...lieu of any and all instructions in this manual)
LIMITED WARRANTY
IMPORTANT: To protect your fitness equipment with respect to any economic loss, loss of property, loss of revenues or ...the product;
Labor is warranted for indirect, special, or consequential damages arising out of or in connection with the use , or costs of removal or installation; ICON’'s obligation under warranty, ...
Similar Questions
Resistance Is Not Working.
Runs fine but without any resistance at all, no matter what I press.
Runs fine but without any resistance at all, no matter what I press.
(Posted by ftc1987 3 years ago)
Console Does Not Increase Or Decrease The Resistance Levels
My Eliptical Trainer is not changing the levels of resistance when I am using it. The resistance is ...
My Eliptical Trainer is not changing the levels of resistance when I am using it. The resistance is ...
(Posted by cjtrujillo 9 years ago)
No Sound From Speakers When Ipod Connected
treadmill no sound from speakers when ipod connected ipod powers up from connection on console
treadmill no sound from speakers when ipod connected ipod powers up from connection on console
(Posted by howardsmales 9 years ago)