Miele DA 5190 W Support Question
Miele DA 5190 W Support Question
Find answers below for this question about Miele DA 5190 W.Need a Miele DA 5190 W manual? We have 3 online manuals for this item!
Question posted by Mariasaluta on October 13th, 2018
Miele Da5190w Hood Has Stopped Working
My Miele DA5190 hood is not going on- fan nor lights. Recently the electric company has been doing some work on my street and there was a time last week where I has power go out in some rooms in the house but was restored within a couple of hours. They are still doing work, but I have not experienced any futher outages. A few days later I was cooking and turned on the hood but but no response. I checked the circuit breakers - all On - and all other kitchen appliances are functional. I ran the power from the hood to a outlet I knew was working and the hood still did not go on. Any suggestions? Would a p
Current Answers
Answer #1: Posted by Odin on October 13th, 2018 12:13 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Miele DA 5190 W Manual Pages
Operating and Installation manual - Page 1
US, CA
M.-Nr. 07 787 390
Operating and Installation Instructions
Ventilation System DA 5190 W
To prevent accidents and appliance damage, read these instructions before installation or use. en -
Operating and Installation manual - Page 4
.... Grease should any other work and repairs
should only be dangerous.
~ f) Only open flame beneath the hood. Tampering with all applicable codes and standards. Heat oils slowly on low or medium settings.
~ b) Always turn the hood on the fan or filter.
~ d) Use the proper pan size. If in accordance with electrical connections or components and...
Operating and Installation manual - Page 5
...Do not use the hood without
cookware. If the flames do not extend beneath the cookware. Do not overheat the cookware, e.g. BE CAREFUL TO PREVENT BURNS. Steam could penetrate electrical components and cause ... the burner so that the flames do not go out immediately, EVACUATE AND CALL THE FIRE DEPARTMENT.
~ b) NEVER PICK UP A FLAMING
PAN - The hood can fight the fire with your back to operate...
Operating and Installation manual - Page 6
... between a cooktop and the bottom of the hood given in accordance with any
solid-state speed control device.
~ f) Do not use this manual. IMPORTANT SAFETY INSTRUCTIONS
Installation
,WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
~ a) Installation work and electrical
wiring must be made of approved non...
Operating and Installation manual - Page 7
...Miele. Air is drawn in and cleaned by the grease filter and directed outside. Functional description
The ventilation hood offers two modes of operation:
Air extraction
Recirculation mode
The air is drawn through a vent at the top of the hood's chimney. The hood... comes equipped with a non-return flap. When the hood is... the hood is in recirculation mode, ensure that...
Operating and Installation manual - Page 9
... timer must be changed. to be activated before the first use on the hood. The indicator light lights blue when the active charcoal filter needs to reset the filter timer after either 5 or 15 minutes. g Grease filter
h Light button
i On/Off button
j Fan power selection
k Delayed shut down
This button activates the Delayed Shut Down feature...
Operating and Installation manual - Page 11
... of programming, the hood will affect this value.
Level 1 operates at 40% capacity Level 2 operates at 60% capacity Level 3 operates at 80% capacity Level 4 operates at 100% capacity
^ To deactivate press the "-" button.
^ To save the setting press the "Delayed Shut Down" button.
The power level indicators "1" and "4" light continuously. The maximum air...
Operating and Installation manual - Page 12
... again.
The lighting however, will remain on again.
12 Turning off automatically 10 hours after cooking has been completed, the Delayed Shut Down feature can be selected to allow the hood to turn the fan back on .
^ Press the On/Off button to turn the fan off.
After that period of time the fan turns off...
Operating and Installation manual - Page 15
... button to turn off the fan.
^ Store the selection by pressing the grease/charcoal filter button. A time of 20 hours should also be programmed if the kitchen is preset to 30 hours.
If the procedure is not stored within 4 minutes of programming the hood will flash.
15
This time can be programmed in kitchens...
Operating and Installation manual - Page 16
...blue indicator for the grease/charcoal filter and one of programming, the hood will flash. The lit indicator shows the programmed time:
1st indicator from the left 2nd indicator from the left 3rd indicator...be used in recirculation mode and cannot be used to select the desired time.
^ Turn off the fan using the hood in recirculation mode, the charcoal filter timer must be programmed.
If the...
Operating and Installation manual - Page 17
... a conditioner for stainless steel can be followed in use a stainless steel cleaner on the hood. Water could penetrate into the electronics and cause damage. cleaning agents containing soda, acids, chlorides...REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
Before cleaning or servicing the hood, disconnect it from the power supply, see "Important Safety ...
Operating and Installation manual - Page 21
... REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
Before changing the light bulbs, disconnect the hood from its life. Cleaning and Care
When in use halogen bulbs become extremely hot, and can now be flipped down.
^ Pull the halogen bulb from the power supply, see "Important Safety Instructions...
Operating and Installation manual - Page 22
... Sales Service
Repairs
In the event of a fault which is visible when the grease filters are removed. These are shown on your Miele products, possibly doing further damage to prevent unauthorized (and untrained) service personnel from working on the data plate which you the assurance of your appliance investment is covered by...
Operating and Installation manual - Page 27
... the distance the less effectively cooking odors are drawn in wall or ceiling for the user.
Appliance dimensions
4) and 5) Cut-out area in .
^ If the hood is fitted flush to the ceiling, regard the possible unit height when selecting the installation height.
27 Before beginning the installation:
^ Read all instructions. a comfortable...
Operating and Installation manual - Page 28
... safety distances given by the manufacturer of the hood:
Electric Cooktops Electric Barbeques and Fryers Multiburner Gas cooktops < 43,000...Miele Cooktops
Non-Miele Cooktops
24" (610 mm)
26" (660 mm)
26" (660 mm) 30" (760 mm)
26" (660 mm) 30" (760 mm) 30" (760 mm)
- Be sure to easily flammable materials e.g.
Provided a larger distance is more than one appliance beneath the hood...
Operating and Installation manual - Page 32
.... Installation
Protective film
The casing is enclosed for easier removal of the chimney extension.
^ After removing the screws from its hooks.
32 Dismantling
If the hood needs to be disassembled, follow the instructions on the "Installation diagram" in the reverse order.
Operating and Installation manual - Page 33
...To reduce the risk of fire and to properly exhaust air, the exhaust gases extracted by the hood should be less than the cross section of the building only.
Please read and follow the ... for exhaust ducting. The diameter of personal injury. Make sure all local building codes when installing the hood. The exhaust duct must not be bent or compressed.
- Do not vent exhaust air into the ...
Operating and Installation manual - Page 34
... ensure that it may need to be insulated to reduce condensation. Seek professional advice before connecting an exhaust hood vent to an active chimney, dryer vent, flue, or room venting ductwork. If the exhaust is available for ducts 5" (125 mm) and 6" (150 mm)... be expelled parallel to the flow direction of the flue. Never connect an exhaust hood to an existing, inactive chimney or vent flue.
Operating and Installation manual - Page 35
... must be plugged into an outlet that power to your power supply, please consult a licensed electrician or call Miele's Technical Service Department.
In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing a path of electric shock.
Important
The hood comes equipped with a 5 ft. (1.5 m) power cord with a NEMA 5-15 molded plug for...
DA5190 - Page 1
Product Dimensions Decorator Wall Hood
DA5190
E O 11 7/16"
10 5/8"
3 5/16"
Front Perspective
28" - 40 3/8" See Notes
20 1/2"
35 1/4"
Location Codes
E - 120 Volt - 15 Amp 3-wire power supply connects through top or rear of chimney. SPECIFICATION SHEETS 011206 O -
NOTE: Drawing is not to blower system inside
chimney. Standard 110 Volt Outlet
Notes
&#...
Similar Questions
Hi All Of Sudden My Miele Da3496 Stopped Working Today. I Bought It In 2017 . Ci
(Posted by Uff2208 2 years ago)
Miele Cooker Hood Da6690w
miele cooker hood DA6690W leds flickering when switched on ,program OK, click when switched on.
miele cooker hood DA6690W leds flickering when switched on ,program OK, click when switched on.
(Posted by jjhinchy365 2 years ago)
Downdraft Is Stuck In Up Position, Will Not Go Down When The Button Is Pressed
(Posted by mjb 3 years ago)
Miele Da 249-2 Hood Touch Control Panel Broke
Hello, we use our Miele DA 249-2 hood and we're very happy with it. A short time ago the touch contr...
Hello, we use our Miele DA 249-2 hood and we're very happy with it. A short time ago the touch contr...
(Posted by avernov 8 years ago)
Hood Stop Working?
Hood stop working? No tripped switch at the electrical panel.
Hood stop working? No tripped switch at the electrical panel.
(Posted by erikrh33317 10 years ago)