1993 Mazda Protege Support Question
Find answers below for this question about 1993 Mazda Protege.Question posted by dyb1967 on October 23rd, 2012
Automatic Transmission Issues.
I can hear the car go from 1st to 3rd and that is it. I am now starting in "S" and then moving shifter into "D" once I hit 40 mph. Just got a new alternator put in. Also, I have no idea what the "Hold" button is for. On my drive from TN to CA recently, the "Hold" button on the instrument panel would blink.
Current Answers
Answer #1: Posted by katonna2009 on June 29th, 2013 10:39 PM
the problem is either a transmission shift solenoid or the Computer.. Computer is under dash on passenger side under carpet- easiest & cheapest to check this first- the Transmission shift solenoids are attached to and inside the Tranny. Just looked at the solenoid kit- over $300.. a used computer is about $40 or less if you know where to look.. I have the same problem with the same car..
Similar Questions
2003 Mazda Protege Change From Automatic To Manual?
If it does, how does 2003 mazda protege become a manual when it's an automatic? Thanks
If it does, how does 2003 mazda protege become a manual when it's an automatic? Thanks
(Posted by Jazlynelsiasmama 7 years ago)
Car Won't Start
changed out plugs,wires,rotor and distributor cap,now car spins over ,but won't start
changed out plugs,wires,rotor and distributor cap,now car spins over ,but won't start
(Posted by marysanchez 8 years ago)
How To Reset Or Disable Factory Alarm On 02 Protege? Where Is Valet Button?
I have a 02 protege. Battery died unexpectedly. Charged it to 71% (bad cell so wouldn't charge all t...
I have a 02 protege. Battery died unexpectedly. Charged it to 71% (bad cell so wouldn't charge all t...
(Posted by xravenezzx 9 years ago)
Not Moving On Reverse
2002protege, put on reverse not moving, when press hard the gas the car drags and start to move
2002protege, put on reverse not moving, when press hard the gas the car drags and start to move
(Posted by edgarallan1234 10 years ago)