Maytag MHWE300VW Support Question
Maytag MHWE300VW Support Question
Find answers below for this question about Maytag MHWE300VW - Performance Series Front Load Washer.Need a Maytag MHWE300VW manual? We have 1 online manual for this item!
Question posted by simplybrunke on December 12th, 2011
Water Is Leaking Out The Back Side Of Front Load Washer
My washer is 2 years old & is leaking water/bubbles out the back upper right during use of sanitary & cleaning cycles.
Current Answers
Related Maytag MHWE300VW Manual Pages
Use and Care Guide - Page 4
... the weather.
[] Do not tamper with gasoline, dry-cleaning solvents, other
moving. iMPORTANT SAFETY iNSTRUCTiONS
WARNING: To reduce the risk of fire, electric shock, or injury to persons when using the washer, follow basic precautions, including the following:
[] Read all hot water faucets and let the water flow from service or discarded, remove the door...
Use and Care Guide - Page 5
...water fill hoses: 6 ft (1.8 m) Part Number 76314, 10 ft (3.0 m) Part Number 350008
Optional pedestal
This pedestal is available in purchasing one of 53.5" (1359 ram). If You Have
Laundry...Parts supplied:
Pedestal A pedestal will need to purchase a Stack Kit. Inlet hose washers (4) D. 7)ansport bolt hole plug (4) E. you, washer or refer to the "Assistance
Pedestal Height 10" (254 mm) 10" (...
Use and Care Guide - Page 6
...water and load) of the washer. Some water can remain in the washer and can be considered. Custom undercounter installation - You will need
• A water heater set to deliver 120°F (49°C) water...8226; Hot and cold water faucets located within 6 ft (1.8 m) of 1" (25 mm) under a custom counter, or in a basement, laundry room, closet, or recessed area. Washer only
(
39"rnin,...
Use and Care Guide - Page 7
Recommended installation spacing for recessed or closet installation, with or without a pedestal
The dimensions shown are for the recommended Recessed area or closet installation
spacing.
34" ' 48in2. .
--
(864ram) (310crn2)
--_ 3"
(76ram)
.___ 24 n 2. -,
(155cm2) '
11"[-_-31'/2"-'_-41"[
Use and Care Guide - Page 8
... drain requires a minimum diameter standpipe of the washer. T
30"rnin.
(762ira)
Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not use an extension cord. See "Tools
The siphon break... • The dimensions shown are
required. 7"(178rnrn) 7"(178rnrn}
00 {229rnrn)
Laundry tub drain system (view C)
The laundry tub needs a minimum 20 gal. (76 I .) per minute. at least ...
Use and Care Guide - Page 10
... of hose failure. Damage to the coupling can be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. Attach hot water hose to the coupling can result. |0
4.
Washer
2, Make sure the washer drum is in the couplings.
9. NOTE: Replace inlet hoses after 5 years of use to reduce the risk of the hose couplings already attached...
Use and Care Guide - Page 11
... around the water inlet hoses and the drain hose. Slide the washer to the laundry tub leg or standpipe with a wood block and adjust the feet as necessary. Check that a[[ parts are recessed (see which step was skipped.
3. Do not force excess drain hose into standpipe. If the washer is [eve[, use a [eve[). 3. Laundry tub drain...
Use and Care Guide - Page 12
... front onto the center of water to use of all the laundry products before they touch any garments.
Two sensors determine load size, load composition, and suds level, then the sensors adjust the water level to traditional front-load washers. bedspread. This enables stepped cleaning, a process in the dispensers when the wash cycle is self-cleaning, and can be easily removed...
Use and Care Guide - Page 13
... the the load
WASHER USE
3000
SERIES
power -
For All Wash Cycles
1. Washer door should close easily. of off-balance to produce the right amount of detergent to use less detergent based on it without clothes. Please refer to using your model. Follow the manufacturer's instructions to determine the amount of suds for the best performance. Open the washer door by...
Use and Care Guide - Page 14
... for the best performance. Select one is for the selected cycle will likely result in the dispensers when the wash cycle is normal for the selected cycle will use less detergent based on the washer by pushing it unnecessary for the selected cycle. Using regular detergent will illuminate. The indicator light for small amounts of water to add them...
Use and Care Guide - Page 15
... time during the Extra Rinse.
• I)0 not use .
• Do not fill beyond the "MAX" [eve[. once.
1 second) to restart the washer at any fabric softener onto the clothes.
• At the end of the cycle, a small amount of water may seep out of the new cycle. Main wash compartment (I.etter B in Dispenser Illustration) Add...
Use and Care Guide - Page 16
... are locked. An additional rinse provides optimal rinse performance to the optimum temperature. If the water temperature is lower than needed for this activity is complete, then resume with the addition of the cycle the washer is pressed. Normal/Casual
Use this cycle to continue the cycle.)
Whitest Whites
This cycle is pressed. Select the desired OPTIONS or...
Use and Care Guide - Page 17
...part of NSF Protocol P172 for the selected cycle.
You wiI[ hear water spraying and splashing during the Clean Washer cycle. Only Sanitary cycle has been designed to meet the requirements of normal washer operation. Rinse & Spin Use this cycle to clean heavily soiled, colorfast fabrics. NOTE: For more delicate loads, when using a "Gentle" cycle on clothing, bedding, and towels.
Normal...
Use and Care Guide - Page 18
... wash sanitary
I max extract ]
signalon. Using the Soak time option The soak time option provides a soak time with a selected cycle, there will not illuminate when selected. Choose the desired temperature. 3. Select and hold START/PAUSE (approximately 1 second).
18
Preset cycle settings of the cycle on or off ] drain &spit rinse & spin
:lean washer
with all cycles. Not...
Use and Care Guide - Page 19
... blends Use this type of detergent will not tangle. • Mend tears, loose hems, and seams. • Treat spots and stains.
• Stained or wet garments should be filled with equal amounts of detergent to avoid scratching the washer interior.
CYCLE
SUGGESTED LOAD TYPE
Whitest Whites Heavy Duty Normal/Casual
Delicate
Quick Wash
Sanitary Clean Washer with...
Use and Care Guide - Page 20
... machine will not immediately stop the cycle. Pull back the sea[ to the washer drum. b) Wipe the seal area with a dry cloth and let the washer interior air dry
• Wear rubber gloves when cleaning for prolonged periods. • Refer to ensure that uses higher water volumes and steam, in the washer basket for stained areas. NOTES...
Use and Care Guide - Page 21
... garments in the washer.
Remove the drawer. 2. Cleaning the exterior Use a soft damp cloth or sponge to run the Clean Washer cycle, but the Clean Washer Reminder light is removable for better ventilation of washer interior. Replace inlet hoses after each cycle to a water pressure surge) while you are away.
• Slightly open after 5 years of use an adapter. or leaks are at home...
Use and Care Guide - Page 22
... can tumble freely. Are screens at the end of HE detergent for the washer to cancel the cycle. Plug in death, fire, or electrical shock. Were you close firmly. ...operate. Do not use an adapter. Disconnect the water inlet hoses from the drain system and attach to clean the washer and remove the antifreeze, if used .
Before you washing a large load? The door ...
Use and Care Guide - Page 23
...[[ an electrician. Check electrical source or call electrician. Dispensers clogged or leaking
• Are the laundry products in the correct position? Are you using HE detergent? This washer has a tight sea[ to the dispenser? Load too wet
Did you add detergent to avoid water leaks.
for the load being pulled through the pump. Also sort by securing a piece...
Use and Care Guide - Page 24
... it in suspension. Use enough detergent to provide maximum cleaning performance. Is your water colder than 60°F (15.6°C) may not dissolve we[[ in suspension. cycle. to use. You may pause until this activity is designed for your hot water system is wrinkled
Did you use the right cycle for the load.
Load is adequate to the original cycle. Did you choose...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
The water temperature is not correct - Top-load washer
.... Top-load washer The distance from the washer? Top-load washer The water temperature in a short amount of energy. Washing many loads in my top-load washer is obtained by using lower water temperatures that are not any leaks. Top-load washer Cold and Cool water wash differences - Top-load washer Cold temperature selections - Load-sensing Energy Star washer Hot water fills slowly... -
The water temperature is not correct - Bravos washer with Dispensers in Corners
... is not correct - Top-load washer Display shows HC - Top-load HE washer with Dispensers in each of laundry. Is the water heater a distance from the water heater to the washer can produce. Check that the rubber gaskets are reversed, the washer will display an "HC" error code at the end of time may use up operation. You may feel... -
Loads are wrinkled - Neptune® front-load washer
... end of my Neptune front-load washer are wrinkled - Did the wrinkling occur during a cycle with a reduced spin speed, warm wash, and cold rinse to find my model number? Not draining, not spinning out water, wet loads - front-load washer Product Recall Information Leaking water - Front-load washer Washer not draining, not spinning out water; wet loads - Neptune® Leave...
Similar Questions
Accidentally Pulled Wiring Out Of The Back Of The Control Panel When Cleaning.
I was cleaning our washer and accidentally pulled out for blue wires out of the UID slot of the cont...
I was cleaning our washer and accidentally pulled out for blue wires out of the UID slot of the cont...
(Posted by Gersty85 7 years ago)
Brand New Mhw6000aw Leaked Water Sometime During The First 'clean' Cycle.
The brand new front load washer leaked sometime during the first "clean" cycle somewhere around the ...
The brand new front load washer leaked sometime during the first "clean" cycle somewhere around the ...
(Posted by claytonlindsey 9 years ago)
Maytag Front Loading Automatic Washer Performance Series F20 Won't Reset
(Posted by axercl 10 years ago)
Residue After A Cleaning Cycle
My washer is 2-3 years old and I have been using an Affresh tablet monthly without fail. Lately we h...
My washer is 2-3 years old and I have been using an Affresh tablet monthly without fail. Lately we h...
(Posted by thatwillguy 12 years ago)
Water Leak
Water drips from the bottom of washer near the legs on the left side (the front and back)
Water drips from the bottom of washer near the legs on the left side (the front and back)
(Posted by Anonymous-40282 12 years ago)