Maytag MHWE300VW Support Question
Maytag MHWE300VW Support Question
Find answers below for this question about Maytag MHWE300VW - Performance Series Front Load Washer.Need a Maytag MHWE300VW manual? We have 1 online manual for this item!
Question posted by Anonymous-40282 on October 14th, 2011
Water Leak
Water drips from the bottom of washer near the legs on the left side (the front and back)
Current Answers
Related Maytag MHWE300VW Manual Pages
Use and Care Guide - Page 4
... the door or lid.
Close supervision of children is necessary when the washer is
flammable, do not smoke or use an open to cause birth defects or other
moving. if the hot water system has not been used near children.
[] Before the washer is
[] Do not add gasoline, dry=cleaning solvents, or other reproductive...
Use and Care Guide - Page 5
... parts. and connector kit, Part Number 285835
Drain hose too short
Water faucets beyond reach of the items listed here, call the toll-free number on the cover or in several colors. Inlet hose washers (4) D. 7)ansport bolt hole plug (4) E.
If You Have
Laundry tub or standpipe taller than 96" (2.4 m)
You Will Need to...
Use and Care Guide - Page 6
... (1.2 m) of the hot and cold water fill valves, and water pressure of 20-100 psi (137.9-689.6 kPa).
• A level floor with a total weight (water and load) of 1" (25 mm) under a custom counter, or in the washer and can be required for the recommended spacing. Some water can remain in a basement, laundry room, closet, or recessed area.
Use and Care Guide - Page 7
Recommended installation spacing for recessed or closet installation, with or without a pedestal
The dimensions shown are for the recommended Recessed area or closet installation
spacing.
34" ' 48in2. .
--
(864ram) (310crn2)
--_ 3"
(76ram)
.___ 24 n 2. -,
(155cm2) '
11"[-_-31'/2"-'_-41"[
Use and Care Guide - Page 8
...required. A
B
8
Standpipe drain system - wall or floor (views A & B) The standpipe drain requires a minimum diameter standpipe of the laundry
tub must be purchased and Parts."
D
4"
311/2''
1"
1"
27"
1"
(102rnrn} (800rnrn}(25rnrn}(25rnrn}(686rnrn} (25rnrn}
The washer can be provided. See "Tools and Parts." The rnmirnurn carry-away capacity can be needed.
Do not...
Use and Care Guide - Page 10
... by hand until it is seated on the hoses for leaks. Turn on the washer.
8.
Cold water inlet
5o Using pliers, check the tightness of hose failure.
Damage to the washer. Washer drain system can be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. Once drain hose is empty.
3.
Screw
on coupling
by...
Use and Care Guide - Page 11
... move the washer out slightly before tipping back.
Do not force excess drain hose into standpipe. Confirm the levelness of the drain hose form to the laundry tub leg or standpipe with... Check that the water faucets are recessed (see which step was skipped.
3. If the washer is
perfectly [eve[ (use a 1 7 mm open-end wrench to back. Dispose of your washer avoids excessive noise and...
Use and Care Guide - Page 12
...clothes in which includes separate compartments for more water extraction, reducing drying time compared to use of all the laundry products before they touch any garments.
Smart Dispensers... the washer self-cleaning, flushing the machine's interior free of water to the load during the first 8 minutes of the load, providing even distribution, and optimum cleaning performance. Automatic...
Use and Care Guide - Page 13
... produce the right amount of sorted clothes in washer errors, longer cycle times, and reduced rinsing performance. Sort laundry according to color and type of the water and detergent mixture is wasted,
Dynamic Off-Balance Detection
This washer uses two sensors to redistribute
within the the load
WASHER USE
3000
SERIES
power - Overloading can cause poor cleaning. •...
Use and Care Guide - Page 14
...washer powers down the washer manually after the cycle is complete. This wash system, along with less water, will create too much sudsing with three separate compartments for your laundry... release lever D. Turn on load size. The indicator light for the best performance. See "Modifiers."
7.
Open the dispenser drawer and add laundry products to the proper compartment....
Use and Care Guide - Page 15
...water may be left in the dispenser.
Dispensing balls will be used . Not all cycles.
twice.
2. Select START/PAUSE (for proper use fabric softener dispensing balls in this washer. The washer...this compartment for load size.
•...Wash option, powdered laundry products should be ...To pause the washer at the best time during the Extra Rinse.
• I )0 not spill or drip any time, ...
Use and Care Guide - Page 16
...loads of the cycle the washer is pressed. normal,
casual
delicate
dut
whitest whites
quickwash sanitary
drain & spil rinse a spin
lean washer
withaff_h
_loorlocked
press pause to unlock
Each cycle has a preset Soil I_evel (cycle time), Water... may have preset options. An additional rinse provides optimal rinse performance to avoid chlorine residues on for approximately 1 second) to ...
Use and Care Guide - Page 17
...water temperature and fast-speed tumbling to help reduce wrinkling. Only Sanitary cycle has been designed to wash small loads of lightly soiled garments that are those with AFFRESH TM washer...Speed Spin Modifier setting to ensure proper performance during the wash and rinse cycles. See chart. Cycles Whitest Whites
Soil Level (cycle time)
Normal (1:15)
Water Temp Hot/Cold
Spin Speed Extra ...
Use and Care Guide - Page 18
... overview of the cycle on or off ] drain &spit rinse & spin
:lean washer
with all cycles.
This is selected.
Soak Time Use the Soak Time option to remove small...cold climates, a warm rinse makes the load more than 60°F (15.6°C), detergents do not dissolve well.
Wash Water Temperature Suggested Fabrics
Wash Water Temperature
Suggested Fabrics
HOT
Sturdy colorfast fabrics ...
Use and Care Guide - Page 19
...system, along with less water, will not tangle. &#...LAUNDRY TIPS
Preparing clothes for washing
Follow these recommendations to wash no-iron fabrics and garments labeled "Permanent Press" or "Wrinkle Free" or that each garment bag be washed promptly for the best performance. Remove non-washable trim and ornaments.
• Empty pockets and turn them inside out to avoid scratching the washer...
Use and Care Guide - Page 20
... minutes.
If necessary, the cleaning cycle may rust if left in combination with several rinse and drain steps to thoroughly ... towels 10 hand towels
Mixed Load
3 sheets (1 king, 4 pillowcases 3 shirts 3 blouses
2 twin)
WASHER CARE
2 sweatpants 2 sweatshirts
...button. Washer Maintenance Procedure
This washer has a special cycle that uses higher water volumes and steam, in the washer basket...
Use and Care Guide - Page 21
...not use an extension cord. or leaks are in the washer, it will proceed to keep it looking new. To winterize washer:
1. Run washer on the left side of the washer interior.
Press START/PAUSE.
Cleaning ...lock again, and then the cycle will continue.
• The machine will bring in some water may stay in the wash drum. • Press POWER/CANCEl. Cleaning the exterior Use a...
Use and Care Guide - Page 22
... rinsing and at inlet hose connection to locate, [eve[, and connect the washer.
2. Are screens at the end of HE detergent for a medium-size load, to cancel the cycle. Failure to cancel the cycle.
Reinstalling the washer 1. Check the following: Are both water faucets.
5. The door may look closed for service. Do not use...
Use and Care Guide - Page 23
... washer and try to avoid water leaks. Is the washer door firmly closed? Are the water inlet valve screens clogged? Is there power at the plug? ca[[ an electrician. Are you using HE detergent? This is still wet, take haft of the load out of 3/4" (19.1 mm) plywood underneath your wet laundry in the correct position? Is washer...
Use and Care Guide - Page 24
... will add time to provide maximum cleaning performance. This routine will be balanced. Did you using a gentle cycle?
Add liquid fabric softener to the washer drum. Did you overload the washer? Use enough detergent to remove any water remaining in the display? Did you properly sort the load? mixing
whites and colors
in a slow-speed...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
The water temperature is not correct - Top-load washer
...;check that there are not any leaks. To ensure a warm wash, run the water at the faucet. This is not correct - Did you have an ENERGY STAR ® Cold rinses are cooler than I do? Do you washing many loads in my top-load washer is obtained by using lower water temperatures that the rubber gaskets are... -
The water temperature is not correct - Bravos washer with Dispensers in Corners
... have hot water and then begin a load of time? The wash water temperatures may notice lower hot or warm water temperatures. Top-load washers Are the hot and cold water inlet hoses reversed? Check that the rubber gaskets are not any leaks. Turn the water back on and make a difference in a short amount of laundry. Top-load washer Display shows... -
Dispensers not working correctly - Front-load Epic washer
... Front-load Epic Z washer Leaking water - Are the laundry products...water left in the rear position for liquid detergent and in the dispenser at the end of the cycle? Make sure the laundry...laundry products (detergent, fabric softener, liquid chlorine bleach) in the dispenser? here's how to ensure best performance. Dispensers not working correctly - Front-load washer...
Similar Questions
Accidentally Pulled Wiring Out Of The Back Of The Control Panel When Cleaning.
I was cleaning our washer and accidentally pulled out for blue wires out of the UID slot of the cont...
I was cleaning our washer and accidentally pulled out for blue wires out of the UID slot of the cont...
(Posted by Gersty85 7 years ago)
La590 Top Load Washer Does Not Spin
LA590 top load washer does not spin - I only hear hum. Pump does not seem to be clogged. LID switch ...
LA590 top load washer does not spin - I only hear hum. Pump does not seem to be clogged. LID switch ...
(Posted by doshichetan 11 years ago)
Water Is Leaking Out The Back Side Of Front Load Washer
My washer is 2 years old & is leaking water/bubbles out the back upper right during use of sanit...
My washer is 2 years old & is leaking water/bubbles out the back upper right during use of sanit...
(Posted by simplybrunke 12 years ago)
Water Leeking Out Of Front
water dripping down front of washer
water dripping down front of washer
(Posted by timrichardson37 13 years ago)
I Have A Maytag Nepture Model # Mah6500aww Front Loading Washer, The Control Li
I have a maytag NEPTURE MODEL # MAH6500AWW front loading washer, the control light START BUTTON IS F...
I have a maytag NEPTURE MODEL # MAH6500AWW front loading washer, the control light START BUTTON IS F...
(Posted by MRAY441 13 years ago)