Maytag MHWE300VW Support Question
Maytag MHWE300VW Support Question
Find answers below for this question about Maytag MHWE300VW - Performance Series Front Load Washer.Need a Maytag MHWE300VW manual? We have 1 online manual for this item!
Question posted by gl4aich on December 5th, 2011
Code F21
what does the code f21 mean when displayed on the control panel?
Current Answers
Related Maytag MHWE300VW Manual Pages
Use and Care Guide - Page 4
... in published user-repair instructions that you understand and have been previously cleaned in, washed in, soaked in, or spotted with controls.
[] Do not repair or replace any part of the washer or attempt any accumulated hydrogen gas. flammable, or explosive substances to cause cancer.
if the hot water system has not...
Use and Care Guide - Page 5
...colors.
additional drain hose Part Number 8318155;
If you purchased or Service" section. If You Have
Laundry tub or standpipe taller than 96" (2.4 m)
You Will Need to Buy Sump pump system (if... 285835
Drain hose too short
Water faucets beyond reach of the washer for Part Number 8212640. To do so you purchased your Maytag washer and dryer? call the dealer from whom you will add to...
Use and Care Guide - Page 6
...°F (49°C) water to the washer.
• A grounded electrical outlet located ...washer with a total weight (water and load) of 1" (25 mm) under a custom counter, or in a basement, laundry room, closet, or recessed area. Some water can remain in the washer and can be considered.
Installing the washer on all sides of the washer. Custom undercounter installation -
Washer...
Use and Care Guide - Page 8
...using the standpipe drain system (floor or wall), the laundry tub drain system, or the floor drain system.
...laundry tub needs a minimum 20 gal. (76 I .) per minute. See "Tools
The siphon break must be
Floor drain system (view D)
The floor drain system requires a siphon break that a separate circuit serving only this appliance be a minimum of 28" (710 mm) from the bottom of the washer...
Use and Care Guide - Page 9
...if you are not sure the washer is properly grounded.
• Do not have a fuse in the rear panel of the washer that the rear of the washer is within approximately 3 ff (...plug must be grounded.
Close the bolt holes with local codes and ordinances.
Once the bolt is loose, move and install washer.
• This washer is equipped with a power supply cord having an equipment-...
Use and Care Guide - Page 10
... faucet. NOTE: Do not overtighten. Damage to the coupling can be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. Washer drain system can result. |0
4. i_"_ _ _,,_t _ ,-_ _ "_
_
1, Insert new flat washers (supplied) into each end of drain
hose.
2. Screw on coupling by hand until it easier to the Cold (right) water...
Use and Care Guide - Page 11
... drain or standpipe drain Connect the drain hose form to its
6.
Check the levelness of the washer by placing a [eve[ on the bottom of the washer, first side to side, then front to the laundry tub leg or standpipe with a wood block and adjust the feet as necessary.
Snap either end of /recycle...
Use and Care Guide - Page 12
...control is automatically turned on when a cycle is self-cleaning, and can be added to help avoid odor-causing residue. Clean Washer with warm water to the load during the first 8 minutes of all the laundry...when the wash cycle is just right for optimal cleaning and rinsing performance. Spin Speeds This washer automatically selects the spin speed based on select cycles. During this ...
Use and Care Guide - Page 13
...panel shown above may also result in death, explosion, or fire.
Remember, concentrated detergents such as 2x or higher will likely result in washer errors, longer cycle times, and reduced rinsing performance. First Wash Cycle Without Laundry...a guide to redistribute
within the the load
WASHER USE
3000
SERIES
power - This wash system, along with less water, will be marked "...
Use and Care Guide - Page 14
...laundry products. Dispenser release lever D. fabric softener compartment
14 See "To cancel a cycle" in component failures and noticeable mold or mildew. Turn on load size. See "Options."
6. See "Modifiers."
7. The washer powers down the washer..."Using the Dispenser."
4. The display shows the estimated time remaining. ...washer errors, longer cycle times, and reduced rinsing performance...
Use and Care Guide - Page 15
...• Use the detergent and color-safe bleach manufacturer's recommended amount for load size.
• If you are available with this washer.
• I)0 not spill or drip any time, select START/PAUSE...I)0 not overfill.
Not all Options and Modifiers are using the Delay Wash option, powdered laundry products should be left in the dispenser. Use a measuring cup with the same type ...
Use and Care Guide - Page 16
...performance to the load. This cycle combines fast-speed tumbling, longer wash time, and extra high speed spin to the washer...washer. When Control I .OCK for cleaning loads of soiled white fabrics with the addition of your laundry. To unlock the controls Select and hold CONTROl... time. During the unbalance routine the time displayed may pause until the Control I .ock, Power/Cancel, and Start/...
Use and Care Guide - Page 17
... AFFRESH TM Use this cycle once a month to keep the inside of bacteria between loads after the cycle is recommended that you are part of bacteria typically found on the care...no carryover of your hot water heater to 120°F (49°C) to ensure proper performance during the Clean Washer cycle. You wiI[ hear water spraying and splashing during the washing, rinsing, and spinning...
Use and Care Guide - Page 18
...or off ] drain &spit rinse & spin
:lean washer
with the same water temperature as the normal rinse....extract ]
signalon. In cold climates, a warm rinse makes the load more than 60°E (15.6°C), detergents do not disso... for each Wash Cycle selection. Automatic Temperature Control The automatic temperature control electronically senses and maintains a uniform water temperature...
Use and Care Guide - Page 19
...load evenly.
• Wash small items, such as 2x or higher will use . This wash system, along with less water, will likely result in washer errors, longer cycle times, and reduced rinsing performance..._/
_/
_/
_/
_/
_/
_/
Max Extract tm
_/ _/ _/
_/
LAUNDRY TIPS
Preparing clothes for the best performance.
It may also result in a mesh garment bag. Remember, concentrated detergents...
Use and Care Guide - Page 20
...
Washer Maintenance Procedure
This washer has a special cycle that uses higher water volumes and steam, in the washer basket for small items.
Loading ...washer. this will display "int" (interrupt) and continue with a dry cloth and let the washer interior air dry
• Wear rubber gloves when cleaning for prolonged periods. • Refer to the washer drum. Using the AEERESH TM washer...
Use and Care Guide - Page 21
... the wash drum. • Press POWER/CANCEl. Close the washer door and dispenser drawer. 4.
The door will be
displayed, and the WASH and CONTROI_S I_OCK lights will take approximately 3 minutes.
6. and drying
• Repeat the cleaning procedure monthly or when the CI.EAN WASHER REMINDER light illuminates.
• If you are away.
•...
Use and Care Guide - Page 22
... reuse transport bolts. www.maytag.com/help
In Canada www.maytag.ca
Washer displaying code message and tone sounds
"F20" (Water Inlet Problem--no water or insufficient...Check the following : Is the drain hose kinked?
Before you washing a large load? If the problem remains, call . Is the drain hose more than F20, F21, or F22 Select POWER/CANCEl twice to operate. "F22" (Front Door Lock...
Use and Care Guide - Page 23
... the inlet hose connections tight? Use of 3/4" (19.1 mm) plywood underneath your wet laundry in the correct position? Did you using an extension cord? This washer has a tight sea[ to the Main wash compartment. Load too wet
Did you overloaded the washer? Select a cycle with metal snaps, buckles, or zippers? Did you wash a single...
Use and Care Guide - Page 24
..., the time displayed may not completely dissolve the detergent. The washer door will start to destroy excessive suds. The wash load must be balanced...load? This additional time
the load size and the hot water inlet temperature. Door locked at the end of the cycle.
Use enough detergent to provide maximum cleaning performance. Did you overload the washer? Consider using this washer...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Why is HE High Efficiency detergent the only type of detergent to use in my washer?
...well in high-efficiency washers. Washer odor due to remove suds. wet loads - Front-load washer This means only a small amount...if I don't clean my HE washer? Front-load washer Display shows an error code - Front-load washer Display shows F21 or F02 - Whirlpool does not...Look for the best performance in washer dispensers. HE detergent is available in my washer? Error codes. The use in ... -
Display shows an error code - Front-load washer
... an error code - Front-load washer Display shows F21 or F02 - F05, F07, F09, F10, F11, F13, F14, F15, F21, F22, and FdU Epic Z washer - Plug in washer or reconnect power. Front-load washer My front-load washer display shows an error code. Front-load washer Display shows F22 or FdL - Front-load washer The following answers for error-code related issues you can correct: Display shows Sud... -
Washer will not fill or start - Top-load HE washer with Dispenser Drawer - video
..., if necessary. If the problem continues to the washer and turned on the water. Product Recall Information Display shows an error code - The wash action turns on . Make sure to continue. Load items loosely in Corners Not draining, not spinning out water, wet loads - Top-load washer with Dispensers in heaps around the basket wall.
Similar Questions
F22 Error Signal
I get an F22 error signal. After performing the user suggestions, I need to look at the circuit that...
I get an F22 error signal. After performing the user suggestions, I need to look at the circuit that...
(Posted by clc43 6 years ago)
What Does The Code F71 Mean?
(Posted by Reneegoforth 10 years ago)
What Does F21 Mean Displayed On Washer?
(Posted by Anonymous-55531 12 years ago)
Water Is Leaking Out The Back Side Of Front Load Washer
My washer is 2 years old & is leaking water/bubbles out the back upper right during use of sanit...
My washer is 2 years old & is leaking water/bubbles out the back upper right during use of sanit...
(Posted by simplybrunke 12 years ago)
What Does The Code F--24 Mean On My Maytag (epic Z) Front Load Washer?
I just loaded my maytag front load washer, and when i tried to start it, the error code f-24 came up...
I just loaded my maytag front load washer, and when i tried to start it, the error code f-24 came up...
(Posted by Christd333 13 years ago)