Maytag MHWE300VW Support Question
Maytag MHWE300VW Support Question
Find answers below for this question about Maytag MHWE300VW - Performance Series Front Load Washer.Need a Maytag MHWE300VW manual? We have 1 online manual for this item!
Question posted by Frj1965 on June 29th, 2020
Height And Depth Measurements
please I need help with getting the height and depth of my May Tag machine.Model: MHWE300VW13
Current Answers
Answer #1: Posted by Odin on June 30th, 2020 9:44 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,680
Member since:
April 10th, 2010 Points: 41,236,680
Related Maytag MHWE300VW Manual Pages
Use and Care Guide - Page 4
...or store the washer where it will...needed for connecting the water inlet hoses • Pliers (that open to 1_//' [39.5 mm])
4 explode.
[] Do not reach into the washer...replace any part of the washer or attempt any accumulated hydrogen ...Tools needed for such a period, before using the washer.
[] Do ...Before the washer is
[]... to persons when using the washer, follow basic precautions, including ...
Use and Care Guide - Page 5
...strap £ Drain hose C. If You Have
Laundry tub or standpipe taller than 96" (2.4 m)
You Will Need to the total height of the washer for Part Number 8212640. and connector kit, ...drain
Standard 20 gal. (76 I .evel • Wood block • Ruler or measuring tape
Parts supplied:
Pedestal A pedestal will need to stack your dryer or refer to the "Assistance or Service" section. To do so...
Use and Care Guide - Page 6
... will need
• A water heater set to deliver 120°F (49°C) water to the washer.
• A grounded electrical outlet located within 4 ft (1.2 m) of the hot and cold water fill valves, and water pressure of 20-100 psi (137.9-689.6 kPa).
• A level floor with a total weight (water and load) of 1" (25 mm...
Use and Care Guide - Page 7
Recommended installation spacing for recessed or closet installation, with or without a pedestal
The dimensions shown are for the recommended Recessed area or closet installation
spacing.
34" ' 48in2. .
--
(864ram) (310crn2)
--_ 3"
(76ram)
.___ 24 n 2. -,
(155cm2) '
11"[-_-31'/2"-'_-41"[
Use and Care Guide - Page 8
separately.
D
4"
311/2''
1"
1"
27"
1"
(102rnrn} (800rnrn}(25rnrn}(25rnrn}(686rnrn} (25rnrn}
The washer can be needed. The rnmirnurn carry-away capacity can result in the top are
required. 7"(178rnrn) 7"(178rnrn}
00 {229rnrn)
Laundry tub drain system (view C)
The laundry tub needs a minimum 20 gal. (76 I .) per minute. Do not use an extension cord. Do not use an adapter...
Use and Care Guide - Page 9
... technician.
removed.
In the event of its final location.
For a permanently connected washer:
This washer must be connected to a grounded metal, permanent wiring system, or an equipment grounding...transported at a later date, ca[[ your local service center. IMPORTANT: Position the washer so that is equipped with a power supply cord having an equipment-grounding conductor ...
Use and Care Guide - Page 10
...washer...drain
hose.
2. Washer drain system can ...to the washer.
NOTE: Do not overtighten.... flat washers (supplied) into each end of hose failure. Firmly seat the washers in ...or replacement dates on the washer.
4, Attach the hose with an... B. Washer
2, Make sure the washer drum is seated on the washer.
8....washer.
©
Remove drain hose from washer drum 1. Slide drain hose onto washer...
Use and Care Guide - Page 11
... washer.
1. If the washer is [eve[, use a [eve[). 3. Check the electrical requirements. Check that a[[ parts are not tight against the washer cabinet, the washer may need additional
parts. Snap either end of the washer ... hose on the feet tightly
against a wail, move front to back, side to the laundry tub leg or standpipe with a wood block and adjust the feet as necessary. when pushed...
Use and Care Guide - Page 12
... the machine's interior free of dirt and other residue. bedspread. Plug into a grounded 3 prong outlet. To test and dean your washer, make your water and energy bills by helping conserve resources.
9. Allow the washer to five different spin speed choices. Heating Element
This washer has a heating element that automatically heats the water to the load at...
Use and Care Guide - Page 13
...load
WASHER USE
3000
SERIES
power - Place a load of suds for this type of this manual for more detailed information. Do not overload washer...The package for the best performance. Use _/_the manufacturer's ...model. The Efficient I )o not store laundry products on it without clothes. Vibration is wasted,
Dynamic Off-Balance Detection
This washer uses two sensors to detect load...
Use and Care Guide - Page 14
...removed from the washer. See "To cancel a cycle" in washer errors, longer cycle times, and reduced rinsing performance. Turn on load size. Select ...of water to use the proper dispensers when adding laundry products.
Push in component failures and noticeable mold ... unlocks, and the wash load can be marked "HE" or "High Efficiency." When the wash cycle is helpful when you wash small items...
Use and Care Guide - Page 15
...compartment for your wash cycle. Use a measuring cup with all Options and Modifiers are using the Delay Wash option, powdered laundry products should be left in the dispenser....washer win drain automatically before the start of the new cycle. To continue the cycle, select START/PAUSE (for powdered detergent A.
Select POWER/CANCEl. Select desired cycle. 3. Select START/PAUSE (for load...
Use and Care Guide - Page 16
...needed for 60 rninutes, until this cycle to shorten drying time. When Control I.ock light is pressed.
An additional rinse provides optimal rinse performance to the optimum temperature. Select START/PAUSE once. 2. Items can also use of the cycle the washer...can add items to wash loads of bleach. You can be extended if oversudsing occurs or the load is operating and the ...
Use and Care Guide - Page 17
... or I .oads that you set your wash load. Only Sanitary cycle has been designed to help reduce wrinkling. This cycle should be interrupted.
If desired, you can reduce the spin speed by NSF International, an independent, third party testing and certification organization are needed in the Washer Care section. See chart. The certification verified...
Use and Care Guide - Page 18
... max extract ]
signalon.
Warm rinses increase wrinkling. In cold climates, a warm rinse makes the load more than 60°F (15.6°C), detergents do not dissolve well. Cold rinses save energy. Wash...
normal,,
start of the cycle on or off ] drain &spit rinse & spin
:lean washer
with the same water temperature as the normal rinse.
Max Extract TM Use this option to remove...
Use and Care Guide - Page 19
... Start
AVAILABLE OPTIONS
Extra Rinse
Soak Time
_/
_/
_/
_/
_/
_/
_/
_/
_/
_/
_/
_/
_/
_/
_/
_/
_/
Max Extract tm
_/ _/ _/
_/
LAUNDRY TIPS
Preparing clothes for the best performance. CYCLE
SUGGESTED LOAD TYPE
Whitest Whites Heavy Duty Normal/Casual
Delicate
Quick Wash
Sanitary Clean Washer with a regular non-HE detergent. Normally soiled blouses, shirts, overalls, etc...
Use and Care Guide - Page 20
...Mix a dilute solution, using s/_ cup (177 ml.) of the washer.
The machine will not immediately stop the cycle. Using the AEERESH TM washer cleaner (Recommended): Add one AFFRESH rMwasher cleaner tablet to ensure that... that uses higher water volumes and steam, in the washer basket for small items.
Loading suggestions
Heavy Work Clothes
4 jeans 4 work pants 4 work shirts
Towels
10 ...
Use and Care Guide - Page 22
... twice to possibly avoid the cost of your load size if needed.
Unplug the power cord.
3. IMPORTANT: Ca[[ for service. Reinstalling the washer 1. Run the washer through the Normal/Casual cycle with I ) ...the upright position. Do not remove ground prong. www.maytag.com/help
In Canada www.maytag.ca
Washer displaying code message and tone sounds
"F20" (Water Inlet Problem--no...
Use and Care Guide - Page 23
...As water is normal. It is recommended excessive moisture at equal heights. The plywood may be [eve[. This washer has a tight sea[ to dry between uses. Check electrical ...laundry is still wet, take haft of the load out of detergent, fabric softener, or liquid chlorine bleach to the Main wash compartment. Chectkhefollowing: Isthepowecrordpluggeindtoagrounde3dprongoutlet? Is the washer...
Use and Care Guide - Page 24
...Powdered detergents may need to the Main wash compartment.
To avoid the transfer of the washer during
Gray whites, dingy colors
Did you unload the washer promptly? Did ...washer drum.
Follow the manufacturer's instructions to determine the amount of detergent to provide maximum cleaning performance.
mixing
whites and colors
in the display? will depend on a large load...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Washer continues to fill or continues to drain - Top-load washer
... fills. Is the drainpipe (standpipe) less than the minimum height of the drainpipe covered in the drainpipe or laundry tub. Drain hose form Is the drain hose taped onto the drainpipe? Top-load washer Washer continues to fill or continues to gravity. My top-load washer continues to fill or continues to drain out of the... -
Wash light remains on - Top-load HE washer with Dispenser Drawer
...) or laundry tub. The drain hose may help you determine why. Is the drain hose taped onto the drainpipe? The drain hose should I 'm not sure the wash is complete. Reinstall the hoses, turn on the water. Top-load HE washer with Dispenser Drawer Concentrated Washing in High Efficiency Top-load and Front-load washers - The... -
Washer continues to fill or continues to drain - Top-load HE washer with Dispenser Drawer
... drainpipe or laundry tub. Make sure that the drain hose does not extend more than 4.5" (113 mm) into the drainpipe with Dispenser Drawer - Top-load washer Washer will not fill or start to flow out of the machine due to drain out of 39" (99 cm)? Top-load washer Sounds different than the minimum height of the washer. Washer continues...
Similar Questions
F22 Error Signal
I get an F22 error signal. After performing the user suggestions, I need to look at the circuit that...
I get an F22 error signal. After performing the user suggestions, I need to look at the circuit that...
(Posted by clc43 6 years ago)
Accidentally Pulled Wiring Out Of The Back Of The Control Panel When Cleaning.
I was cleaning our washer and accidentally pulled out for blue wires out of the UID slot of the cont...
I was cleaning our washer and accidentally pulled out for blue wires out of the UID slot of the cont...
(Posted by Gersty85 7 years ago)
Water Is Leaking Out The Back Side Of Front Load Washer
My washer is 2 years old & is leaking water/bubbles out the back upper right during use of sanit...
My washer is 2 years old & is leaking water/bubbles out the back upper right during use of sanit...
(Posted by simplybrunke 12 years ago)
New Maytag Top Load Washer Model Mvwc300vw1, Gentle Cycle Question?
Hello, I have a new maytag top load washer model MVWC300VW1, we notice the gentle cycle seems to be ...
Hello, I have a new maytag top load washer model MVWC300VW1, we notice the gentle cycle seems to be ...
(Posted by hopkins9241 13 years ago)
What Does The Code F--24 Mean On My Maytag (epic Z) Front Load Washer?
I just loaded my maytag front load washer, and when i tried to start it, the error code f-24 came up...
I just loaded my maytag front load washer, and when i tried to start it, the error code f-24 came up...
(Posted by Christd333 13 years ago)