Maytag MHW7000XR Support Question
Maytag MHW7000XR Support Question
Find answers below for this question about Maytag MHW7000XR.Need a Maytag MHW7000XR manual? We have 5 online manuals for this item!
Question posted by ctebault on March 6th, 2015
How Do You Access The Control Knob And Shaft On Model #mhw7000xw2, To Replace.
The person who posted this question about this Maytag product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by TommyKervz on March 6th, 2015 1:17 PM
TommyKervz
Member since:
January 10th, 2013 Points: 17,776,833
Member since:
January 10th, 2013 Points: 17,776,833
Please use the contact platform linked to below for a more prompt and hopeful assistance on this particular issues
http://www.maytag.com/contact-us
http://www.maytag.com/contact-us
Common problem and troubleshooting below
http://www.repairclinic.com/Shop-For-Parts/a8b4c31i972/Maytag-Dryer-Knob-Dial-Button-Knob-Parts
Related Maytag MHW7000XR Manual Pages
Installation Instructions - Page 4
... . Top of washer. install no higher than 96" (2.44 m) from bottom of drain hose should be at least 30" (762 mm) above floor; Minimum carry-away capacity: 17 gal. (64 L) per minute.
Select method you have an overhead sewer and need . Floor standpipe drain system
41/2" (113 mm)
Laundry tub drain system...
Installation Instructions - Page 6
... from back of hole. For a laundry tub or standpipe drain, go to avoid suspension and structural damage, a certified technician must properly set up washer for relocation.
6 Remove power cord
...bolt holes on elbow end of washer. 3. You may need additional parts with attached cap. C over top of washer to allow free access to center of washer.
See "Alternative Parts". Slide...
Installation Instructions - Page 8
... additional two-thirds turn on top edges of washer
place level here
Attach hot water hose to laundry tub leg, drain standpipe, or inlet hoses for leaks
Remove cardboard from beneath washer. A small amount of hose failure, replace the hoses every 5 years. Record hose installation or replacement dates for leaks. Connect inlet hoses to Step...
Energy Guide - Page 1
... water heater)
Your cost will depend on your utility rates and use.
• Cost range based only on standard capacity models. • Estimated operating cost based on eight wash loads a week and a 2007
national average electricity cost of 10.65...
$1.218 per kWh and natural gas cost of this label before consumer purchase.
Clothes Washer Capacity: Standard
Maytag Model: MHW7000X* Cat.
Warranty Information - Page 1
... alteration, misuse, abuse, fire, flood, acts of the washer and that existed when this major appliance is inconsistent to published... is used in the country in accordance with original model/serial numbers that vary from the date of your...;6777.
6/09
23 MAYTAG® LAUNDRY LIMITED WARRANTY
This Maytag Limited Warranty supersedes and replaces the limited warranty printed in materials or...
Dimension Guide - Page 1
...: 28" (711 mm) from bottom of washer. install no higher than 96" (2.44 m) from bottom of laundry tub must be large enough to allow door ... installation (washer only):
All dimensions show recommended spacing allowed, except for closet door ventilation openings which are for a standpipe drain: 2" (51 mm). Top of washer.
Front-Loading Automatic Washer
PRODUCT MODEL NUMBERS MHW6000X...
Use & Care Guide - Page 4
...models
1
2
3
4
heavy duty normal wrinkle control
power
whites
bedding
start
allergen
+
small cancel load
rinse/drain & spin
9
soak
fresh hold
clean washer
with Steam, and 8 hours on and off. Press to stop/cancel a cycle at any time.
2 WASH CYCLE KNOB Turn the Wash Cycle Knob... laundry load.
CONTROL PANEL AND FEATURES
Not all features and cycles are available on models with...
Use & Care Guide - Page 5
...turn button sounds on each cycle. An integrated heater helps to show when controls are available on some models) MaxExtract uses an extended high-speed spin to remove additional water during ..."HE" detergent compartment This compartment holds liquid or powdered HE detergent for Stains to turn the washer off . As you press the Soil Level button, the cycle time will increase or decrease ...
Use & Care Guide - Page 6
...Delay Start
Lightly-soiled shirts,
Wrinkle
Hot
Medium Extra Heavy
blouses, trousers,
Control
Warm
Low
Heavy
pants and dresses
Cold
Extra Low Normal
No Spin
Light
...best performance, not all settings are available on model) is automatically added for additional information. This cycle is complete. See "Control Panel and Features" for extra cleaning power....
Use & Care Guide - Page 7
...Warm Cold
Extra Heavy Fresh Hold
Heavy
Delay Start
Normal
Light
No clothes in washer Clean Washer with Affresh®
Cycle Details:
For small loads (3-4 items) needed quickly.... washer drum with each cycle. Medium load: Fill the washer drum up to about 3/4 full. Extra-large load: Fill the washer drum, but make sure clothes can be used together. Not all models....
Use & Care Guide - Page 9
...For powdered detergent, slide the selector to dispenser
Models with a 4-compartment dispenser
Models with the same type of HE detergent into... Do not overfill;
This is
completely closed.
Add laundry products as described in the dispensers from the previous ... detergent may cause detergent to be dispensed into the washer too early. If no recommendation is available, you would...
Use & Care Guide - Page 10
...or liquid.
7.
Add a measured amount of liquid fabric softener into washer.
Overfilling will cause fabric softener to immediately dispense into liquid fabric ...washer
power
cancel
Four compartment dispenser shown
Liquid chlorine bleach
compartment
Slowly close the dispenser drawer. 4. Add fabric softener to dispenser
(if desired)
6. Add Oxi or color safe bleach
(on some models...
Use & Care Guide - Page 11
... control
whites
bedding
allergen
small load
rinse/drain & spin soak
Steam model shown
clean washer
with...model shown
extra rinse oxi boost max extract cycle signal control lock press and hold for 3 seconds
The display will change the Estimated Time Remaining.
Setting a delayed start
11
Not all options and settings are available with
delicate
Turn cycle knob...
Use & Care Guide - Page 12
... progress of water has been added for best results. Cycle Status Lights +
- This sensing process will light on some models) This will unlock briefly before locking again. The motor sounds may pause the washer, open the door, and add items.
Sanitized Sanitized will continue until the correct amount of a cycle.
You will...
Use & Care Guide - Page 13
...2.
WASHER MAINTENANCE
CLEANING YOUR WASHER
Keep your washer as clean and fresh as your clothes. To keep washer interior odor-free, follow this recommended cleaning procedure at least once a month:
1. Make sure laundry drum... in the wash drum. If any garments in the washer, "rL" will be displayed, and the WASH and CONTROL LOCK indicators will determine whether clothing or other items are...
Use & Care Guide - Page 14
...stained areas are found, wipe down area thoroughly with a dry cloth and let the
washer interior air dry with door open.
Refer to check for proper use.
14
CLEANING ...the washer door and remove any clothing or items from the washer.
2. Lift off cover panel by pulling straight up.
4. WASHER MAINTENANCE
CLEANING THE DISPENSER
You may find laundry product residue leftover in washer, then...
Use & Care Guide - Page 15
..., follow WINTER STORAGE CARE directions before moving :
1. HELPFUL TIP: When replacing your washer, it from back of R.V.-type antifreeze in hoses, freezing can damage washer.
Unplug washer or disconnect power. TRANSPORTING YOUR WASHER
1. Unplug power cord. 5. Before using your washer for a period of hose failure, replace inlet hoses every five years and periodically inspect for kinks...
Use & Care Guide - Page 18
... latched for proper water supply.
Door not opened and then closed during certain cycles. Press START/PAUSE.
Replace any kinks in drum. Some cycles feature periods of cycle. Suds from regular detergents can begin.
18
washer stops working
Both hoses must be turned on your load requirements.
Plug power cord into a grounded...
Use & Care Guide - Page 22
... are washed in the Oxi compartment (on some models). Load may result in residual powder in washer.
Cycle time changes or Normal washer operation. This routine will start to remove extra ...rinse out dispenser. Load dispensers before starting a cycle. Leftover powder may use powdered or liquid laundry boosters in this cycle, wash time will be wiped out by hand, if needed.
To ...
Use & Care Guide - Page 23
...according to instructions attached to or furnished with original model/serial numbers that vary from defects in your major ...6777.
6/09
23 MAYTAG® LAUNDRY LIMITED WARRANTY
This Maytag Limited Warranty supersedes and replaces the limited warranty printed in the ...Pick up and delivery. The removal and reinstallation of the washer and that vary from warranty coverage.
4. MAYTAG SHALL NOT...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Dryer does not heat - Electric dryer
... damp; Dryer does not heat - Did you recently install a power supply cord on the control knob or button with the other temperature selections. Replace the fuses or reset the circuit breakers. Enter Model Number How do I find my model number? dryer does not dry Dryer does not heat - Electric dryers use 2 household fuses or... -
Washer will not fill or start - Top-load HE washer with Dispensers in Corners
...washer should seem low because this is not in the washer, select the Rapid Wash cycle. The washer will not be connected to the washer and turned on some models only) Your washer will start - To run properly, the washer...load washer with a cycle? Is a water inlet hose kinked? The washer lid must be tightly packed. Is the indicator on the Cycle Control knob ... -
Washer will not fill or start - Bravos washer with agitator
...replace it, if necessary. If the problem continues, call an electrician. Has a cycle been selected, but Start has not been selected and held for proper fill. Is the Delay Wash status light on? (on some models only) Your washer...on the Cycle Control knob properly lined up to the washer and turned on. Slightly turn on the water and check for up with a cycle? Washer will not ...
Similar Questions
How To Access Control Panel On Maytag Washer Mvwc6esww1
(Posted by SISKIN4 10 years ago)
Washer Cycle Control Knob
Can the knob be replace without replacing the whole control panel?
Can the knob be replace without replacing the whole control panel?
(Posted by dbartunek 10 years ago)
Accessible Cleanout?
Does this machine have an accessible cleanout for items which don't make it through to the drain (ie...
Does this machine have an accessible cleanout for items which don't make it through to the drain (ie...
(Posted by charliethebutter 12 years ago)
I Have A Maytag Nepture Model # Mah6500aww Front Loading Washer, The Control Li
I have a maytag NEPTURE MODEL # MAH6500AWW front loading washer, the control light START BUTTON IS F...
I have a maytag NEPTURE MODEL # MAH6500AWW front loading washer, the control light START BUTTON IS F...
(Posted by MRAY441 13 years ago)