Maytag MGD6600TQ Support Question
Maytag MGD6600TQ Support Question
Find answers below for this question about Maytag MGD6600TQ - MaytagR BravosR Steam Gas Dryer.Need a Maytag MGD6600TQ manual? We have 1 online manual for this item!
Question posted by drffulton on December 29th, 2015
Maytag Bravos Dryer Heats Up For One Cycle Then No Heat On Door Open Restart.
dryer heats up for 1 cycle, once door is opened, igniter glows but no gas ignition to heat dryer up. Check all three limits and thermistor ohms are good. Do I have a bad control board?
Current Answers
Answer #1: Posted by Odin on December 29th, 2015 5:37 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,680
Member since:
April 10th, 2010 Points: 41,236,680
Your question is not competey clear, but you should find the answer at http://www.repairclinic.com/RepairHelp/Dryer-Repair/8-4--TUdENjYwMFRR/Maytag-Dryer-Troubleshooting. The link most likely to solve is listed seventh.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Maytag MGD6600TQ Manual Pages
Use and Care Guide - Page 4
...gas installation must not exceed 3 feet. In the State of Massachusetts, the following :
■ Read all instructions before or after each load. ■ Keep area around the exhaust opening and adjacent
surrounding areas free from service or discarded, remove the door to the drying compartment.
■ Do not reach into the dryer....
■ Do not use heat to dry articles containing foam rubber...
Use and Care Guide - Page 5
...dryer. Some codes limit, or do so can result in the same closet as gasoline, away from whom you purchased your washer using the "Y" connector and short hose (if needed : Check local codes and consult gas..., and water pressure of the dryer in an area where it will need ■ A location that opens to 1" (2.5 cm) or hex-head socket wrench (for adjusting dryer feet)
■ Level
■...
Use and Care Guide - Page 6
... appliance spacing should also be considered.
■ Additional spacing is required if you exhaust out the rear of the door are recommended for this dryer.
Louvered doors with elbow. Closet door with a door, minimum ventilation openings in .2* (155 cm2)
3"* (7.6 cm)
1"
29"
1" 1"* 29¼" 5"
(2.5 cm) (73.7 cm) (2.5 cm) (2.5 cm) (74.3 cm) (12.7 cm)
A
B
C
*Required spacing...
Use and Care Guide - Page 7
...the door well of a qualified person include: licensed heating personnel, authorized gas company personnel, and authorized service personnel. It is also recommended that a separate circuit serving only this dryer be...new CSA International approved gas supply line.
Check with the type of gas available, contact your gas company. Ask for LP (propane or butane) gases with the dryer: if it will ...
Use and Care Guide - Page 8
... kinking.
■ Use only pipe-joint compound.
It is recommended that comes out through the rear of your dryer has been converted to reach for opening and closing. Gas Supply Pressure Testing ■ The dryer must be used . If the total length of the burner Btu rating shown
on the model/serial number plate...
Use and Care Guide - Page 9
...plugged with lint.
■ Replace any gas vent, chimney, wall, ceiling or a... in enclosed walls, ceilings or floors. The dryer exhaust must be connected or secured with rigid or... elbows provide better airflow than 90° elbows. Good
Better
Clamps ■ Use clamps to achieve the ...your dealer or by calling Maytag Services. Venting Requirements
WARNING
Rigid metal vent ■...
Use and Care Guide - Page 11
...terminate beneath the mobile home.
Number of 90º turns or elbows
Type of the dryer.
■ Reduce performance, resulting in the Vent system chart. Avoid 90º turns...provides venting requirements that extend into the interior of the dryer is equivalent to exhaust hood with one elbow to seal exterior wall opening around exhaust hood.
2. Vent must be securely fastened...
Use and Care Guide - Page 14
... screws. Remove the 4 plastic plugs located outside the dryer door opening to the front
panel of the dryer near the console.
3.
Lay the door on the door. A B
A
Then, by placing a level in the crease on the side of the dryer between the top of the dryer and
B
the dryer cabinet, check the levelness from each of the 2 hinges in Step...
Use and Care Guide - Page 15
...1. Remove the door strike from the dryer door. 2. Remove the cosmetic screw opposite the door strike. NOTE: Door strike and plugs must be on the opposite side of the dryer door opening from the opposite side of the dryer using 4 screws. Replace the 4 screws in the door.
Do not tighten screws. Door strike B. Leave approximately ¼" (5 mm) of the dryer door opening . 2.
Use the...
Use and Care Guide - Page 16
... fuse is intact and tight, or circuit breaker has not tripped.
■ Dryer door is open the dryer door and feel for 5 minutes, open , contact a qualified technician.
16 For this test, do not feel heat, cancel cycle and close door. See "Level Dryer."
Check for certain part replacement or repair. 13. Wipe the dryer drum interior thoroughly with a damp cloth to engage...
Use and Care Guide - Page 17
... have all of this manual for Sensor Dry, Timed or Steam Cycles will adjust again, showing the final drying time.
17
Do not dry anything that has ever had anything that has ever had any type of the load. Place laundry into dryer and shut door.
3. Do not dry anything flammable on a clothesline or by...
Use and Care Guide - Page 18
...Steam Cycle. ■ Press the TIMED CYCLE ADJUST up or down arrows and the time will change by 5-minute intervals. NOTE: During the Custom Refresh cycle, you can be used only with Timed Cycles and the Custom Refresh cycle. Open the door.... Once a dryness level is selected. As the cycle runs, the control
senses the dryness of Cycle Signal. 5. (OPTIONAL STEP) If desired, select ...
Use and Care Guide - Page 19
... in a Sensor Dry Cycle when the laundry is automatically sensing the dryness level of all cycles. Dry The Dry light illuminates when the drying cycle is selected.
If the cycle is detected. ■ In a Timed Cycle, the Sensing light illuminates at any time Open the door or press PAUSE/CANCEL once. Select new cycle settings before restarting the dryer.
NOTE: You...
Use and Care Guide - Page 20
... medium heat for this cycle a small amount of water is sprayed into the dryer drum after several minutes of tumbling with steam cycles as lingerie, blouses or washable knit fabrics. In this cycle. Custom Refresh This cycle is selected, the estimated time remaining display shows the actual time remaining in the dryer too long. Wrinkle Control Use this cycle to...
Use and Care Guide - Page 21
... Air Fluff ■ Check that require drying without heat such as exercise wear, can be changed without stopping the cycle. The preset dryness setting is Normal when a Sensor Dry Cycle is not available with the Sensor Dry Cycles. Lightweight garments, such as rubber, plastic and heat-sensitive fabrics. Steam Refresh Preset Cycle Settings
Timed Cycles Load Type
RAPID REFRESH...
Use and Care Guide - Page 22
... the light inside the dryer, close the door and restart the dryer to ON. NOTE: When the Wrinkle Prevent setting is selected and the End of selecting the cycle, the dryer automatically shuts off , open for 5 minutes, the dryer door is closed , or the door is left open the door to stop the dryer, rearrange the load inside the dryer drum.
Your Dryness Level...
Use and Care Guide - Page 23
...or pillows Foam rubber filled
Timed Dry
Air Fluff (no 90 heat)
Sneakers or canvas shoes
Timed Dry
Air Fluff (no 90 heat)
*(Minutes) Reset time to save the drying setting. 5. ... for normal tumbling. Open dryer door. Refer to complete drying. Dryer back panel
3. 2. To use the automatic cycle with the drying rack. Dryer rack front edge B. NOTE: While cycling through the settings, ...
Use and Care Guide - Page 25
.... 6. Unplug the power supply cord. 2. Open the dryer door. Remove
the screw located in dryer or reconnect power.
25 To winterize dryer
1. To use dryer again
1. Reconnect water inlet hose to secure dryer door. Replace the bulb with the screw.
4. Turn on the back wall of the cover. Shut off water faucet. 3. Disconnect gas supply line pipe and remove...
Use and Care Guide - Page 26
... correct size? Separate the load items and restart the dryer. If the problem continues, call an electrician.
■ Is the valve open on the gas supply line?
Clean out pockets before each load. Do not use a metal foil vent. www.maytag.com/help - In Canada www.maytag.ca
Dryer Operation
Dryer will not run
■ Has a household fuse...
Use and Care Guide - Page 27
... doors must have ventilation openings at the beginning of 1" (2.5 cm). See "Modifiers."
■ Is the load too large and heavy to do so can result in back or other clothing. Change the dryness level setting on .
■ To remove odors left in the dryer.
■ Was the dryer overloaded? These cycles are still wrinkled following Steam cycles? Check...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Max Cool feature - French door refrigerator
French door refrigerator How do I use my temperature controls? - IMPORTANT: When the Max Cool feature is in operation, the (+) and (-) pads for the Refrigerator and Freezer controls will illuminate. The Max Cool indicator light will not operate. Press the Max Cool touch pad again to return to the normal refrigerator set the... -
Display shows an error code - Dryer
dryer - Dryer Display shows AF - Dryer The following answers for service. Check the following list of codes indicates a possible problem with the dryer: Epic ® Dryer Display shows L2 - F01, F02, F22, F23, F26, F28 and F29 Bravos dryer - F01, F02, F22, F23, F24, F25, F26, F28, F29, F30 and F50 To remove the error display, select Pause... -
My Bravos® washer turns on when I open the lid. Dispensers in Corners
... Information Affresh washer cleaner or liquid chlorine bleach - HE washers Stain Cycle did not run - Dispensers in Corners Yes, your washer is not in Corners Display shows Sd - Top-load washer with Dispensers in Corners My Bravos washer turns on when I open and close the washer lid, and the display will illuminate. My...
Similar Questions
Maytag Bravos Dryer
My Maytag Bravos Dryer Mgdx700xl Stops Drying After About 15 Minutes. Clothes Remain Wet And The Tim...
My Maytag Bravos Dryer Mgdx700xl Stops Drying After About 15 Minutes. Clothes Remain Wet And The Tim...
(Posted by rpreciado6853 8 years ago)
Trying To Attach Maytag Bravos Dryer Door To Panel. Should The Hinge Close Flush
Trying to attach dryer door to panel. Should the hinge be flush between the panel and door or if I t...
Trying to attach dryer door to panel. Should the hinge be flush between the panel and door or if I t...
(Posted by Carolbcool 9 years ago)
What Does F1 Mean On A Bravo Maytag Gas Dryer
(Posted by blacELPFa 9 years ago)
My Maytag Bravo Dryer Has No Power
I have checked the outlet and it works. what could be wrong if the dryer has no power?
I have checked the outlet and it works. what could be wrong if the dryer has no power?
(Posted by mygirlfriend2525 11 years ago)
Maytag Gas Dryer, Model #mgd6600tqo
My dryer is saying an error of "F1"? What is that? I lost the manual, & can'tseem to find one on...
My dryer is saying an error of "F1"? What is that? I lost the manual, & can'tseem to find one on...
(Posted by melt819 13 years ago)