Maytag MGC5536BD Support Question
Maytag MGC5536BD Support Question
Find answers below for this question about Maytag MGC5536BD - 36" Gas Cooktop.Need a Maytag MGC5536BD manual? We have 1 online manual for this item!
Question posted by erobinson5 on January 14th, 2012
Automatic Sparkers
I have this model gas burner and all 5 sparker just started sparking. How do I turn them off or what is the troubleshooting procedure
Current Answers
Related Maytag MGC5536BD Manual Pages
Installation Manual - Page 1
...gas to serial plate on
underside of burner box for this appliance for future reference.
8101P582-60
(04-04-00) NOTICE TO CONSUMER: Retain these instructions with a gas other than the type specified.
30² MODEL...attempt to convert this information.
Refer to be supplied.
INSTALLATION SEALED GAS COOKTOPS
MANUAL
Models: MGC5430 & MGC5536 403 WEST FOURTH STREET, NORTH · NEWTON,...
Installation Manual - Page 2
...Gas.
Never test for storage space to
LP procedure found in each corner.
3. Countertop must be measured and cut accurately to within 3² (7.62 cm) of the National Fuel Gas...THE GAS BURNERS ...COOKTOP; V This appliance was manufactured for gas leaks. If LP gas is :
1.0² (2.54 cm) at rear 6² (15.24 cm) at sides
(Dimensions apply to both 30² and 36² wide models...
Installation Manual - Page 3
... column (30² models) on Maytag equipment installed other appliance is to be installed by a qualified service technician before attempting to operate the cooktop on that the gas supply pressure to the ... pressure regulator at the factory for use of gas supplied to it is designed. If, at a pressure of 5 inches of water column (36² models), 4 inches of the unit. Use standard ...
Installation Manual - Page 4
... appliance regulator to 20 to all pipe joint connections are gas tight. Always use in the cooktop if connections were disturbed during installation. Make the gas connection to the action of torque. If a leak appears, turn off supply line gas shut-off valve, tighten connections, turn on or shutting off valve to the appliance.
Install the...
Installation Manual - Page 5
... PIPE JOINTS
3/8² N.P.T. IF THIS UNIT WILL HAVE A MAYTAG MODEL MEW6500 or MEW5500 SERIES ELECTRIC WALL OVEN INSTALLED BELOW THIS COOKTOP. If a leak appears, turn off supply line gas shut-off valve, tighten connections, turn on or shutting off valve to more than in the gas line ahead of torque.
2. NOTE 2: It may be necessary to...
Installation Manual - Page 6
... and 14 inches of the appliance shall be no more than 1/2 pounds per square inch (3.5 kPa). If a leak appears, turn off supply line gas shut-off valve, tighten connections, turn on the supply line gas shut off valve, must be conducted by local codes or ordinances, a new A.G.A. - max.)
Flare Union Adaptor
3/8² N.P.T. Alternative Piping...
Installation Manual - Page 7
...this appliance and the counter units outlet is to be mounted within an adjacent cabinet. If a Model MEW6500 or MEW5500 Series Electric Wall Oven is to be installed below :
A. The clearance hole ... extending beyond a point 3-3/4² (9.53 cm) left of the nominal center of the rear wall of the burner box, when viewed from this left side) dividing wall. It is to the outlet.
2. If a wall ...
Installation Manual - Page 8
... in the literature packet. Tighten screws (do not cross thread) to tighten. WARNING
Electrical power and gas must be performed by turning clockwise to 25-30 in lbs.
Step 2: Remove burner base by turning counter- Tighten to a torque of burner throat. Carefully lift nut driver out of 15 to conversion. Step 7: Save the orifices removed...
Installation Manual - Page 9
...
High Altitude Notice
The specified gas burner ratings typically apply to elevations up to advise if a reduction is shipped from the factory with low and high flame settings adjusted for use with natural gas. This operation will be checked by turning knob from valve stem. A local certified gas servicer will automatically provide the proper flame size...
Installation Manual - Page 10
...Starting from the LP position (see #5 on figure 13. After Steps A, B and C have been completed, check the appearance of each of the following modifications must be turned off prior to natural gas... Of Natural Gas Orifice Spuds
5 BURNER MODEL (36² WIDE)
1.55
1.85
FIGURE 15
4. They will produce a stable, steady blue flame of the spuds and note the correct burner location for future...
Installation Manual - Page 11
... Rear Center
Hi
12,500 / 10,500 9,200 / 9,100 9,200 / 9,100 5000 / 4000 ----------- The burners are as shown in figures 16 and 17 below.
4 BURNER MODEL (30² Wide)
FIGURE 16
MAYTAG 36²
INPUT RATES - NATURAL GAS / LP GAS (BTU/HR)
BURNER LOCATION
Right Front Right Rear Left Front Left Rear Center
Hi
12,500 / 10...
Installation Manual - Page 12
... counter top. Additional hold -down brackets, one on the cooktop model number plate.
12 See figures 18 and 19. HOLD-DOWN BRACKET
FIGURE 18
COUNTERTOP
BURNER BOX
HOLD-DOWN BRACKET
HOLD-DOWN SCREW
FIGURE 19
How To Remove Cooktop For Servicing
Follow this procedure to reinstall. Reverse the procedure to remove the cooktop for gas leaks after reconnection.
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Compactor drawer won't open
...To raise the ram on models with a key-knob (or key-switch): Turn the key-knob (key-switch) to your Use and Care Guide. To raise the ram on models with push button controls: ...and Care Guide, find my model number? Is the Solid cycle engaged? For additional information, refer to Start and release. Enter Model Number How do not have your product model number in the search tool... -
Indicator lights - Ceramic glass cooktop
... lights come on . The hot surface indicator light is turned off my cooktop? Sabbath Mode - Why do some models A hot surface indicator light illuminate when any element is hot. It will glow when any cooking area is turned on when I have turned off , until the area has cooled. Hot surface indicator lights On... -
Surface burners fail to ignite
... do not have the receptacle checked and if it online by entering your product model number in the search tool below. This needs to be sparking to the burner cap. Turn off the appliance and check to gas. Reinstall the burner cap, making sure the alignment pins are cool. IMPORTANT: Food spills containing acids...
Similar Questions
Cooktop 4 Wire To Home 3 Wire No Plug.
I bought a new Maytag cooktop MEC5430bdw it has 4 wires my home where old cook top was only has 3 wi...
I bought a new Maytag cooktop MEC5430bdw it has 4 wires my home where old cook top was only has 3 wi...
(Posted by brianshawns4 4 years ago)
Please Number Of Part Of Two Sw Selector Cooktop Model Mec5536bas
(Posted by salbarranco 12 years ago)
Can A Mec5430 Cooktop Be Installed Over An Under The Counter Oven?
can a maytag mec5430 cooktop be installed over an under counter wall oven?
can a maytag mec5430 cooktop be installed over an under counter wall oven?
(Posted by lilliant27 12 years ago)
What Is The Cut Out Size For Maytag Mgc4436bdb Cooktop?
(Posted by fat55sam 12 years ago)
A New Cooking Top
My Cooktop came with two burner on one side and a grill on the other side it has and electric start ...
My Cooktop came with two burner on one side and a grill on the other side it has and electric start ...
(Posted by ezdriveways 13 years ago)