Maytag MED4100DW Support Question
Maytag MED4100DW Support Question
Find answers below for this question about Maytag MED4100DW.Need a Maytag MED4100DW manual? We have 4 online manuals for this item!
Question posted by kriedstra on November 13th, 2014
Steaming
How do you get the wrinkles out of your clothes using the steam?
Current Answers
Related Maytag MED4100DW Manual Pages
Installation Guide - Page 1
... Connection 8 Direct Wire Connection 10 VENTING 12 Venting Requirements 12 Plan Vent System 13 Install Vent System 15 CONNECT INLET HOSE (STEAM MODEL ONLY 15 CONNECT VENT 16 LEVEL DRYER 17 COMPLETE INSTALLATION CHECKLIST 17 DOOR REVERSAL (OPTIONAL 18
Para una version de estas instrucciones en español, visite www.Whirlpool...
Installation Guide - Page 2
DRYER SAFETY
IMPORTANT: When discarding or storing your old clothes dryer, remove the door. 2
Installation Guide - Page 3
... parts are included. Check existing electrical supply and venting. NOTE: Do not use with a pedestal or a stack kit. If using a power supply cord: Use a UL listed power supply cord kit marked for use leveling legs supplied with dryer if installing with clothes dryers.
Tools needed (steam models):
Utility knife
Tape measure
Level
Pliers
Caulking gun and compound (for...
Installation Guide - Page 4
...
61/2" (165 mm)
Power supply cord/cable
Vent
Water inlet (Steam
models only)
297/8"* (759 mm)
31/2"* (89 mm)
143/8" (365 mm)
61/8"* (156 mm) DRYER DIMENSIONS Front view:
27" (686 mm)
383/4" Min. (984... circuit.
■■If using a pedestal, you will be large enough to allow door to shut off at least 18" (460 mm) above floor. If not level, clothes may not tumble properly and ...
Installation Guide - Page 5
... be removed from
your responsibility:
■■To contact a qualified electrical installer.
■■To be sure that connect to the dryer must be secured to the dryer cabinet with clothes dryers. If using and follow the instructions provided for it is recommended that a qualified electrician determine that the ground path is your dealer.
Louvered...
Installation Guide - Page 6
... marking. The
(14-30R)
neutral conductor must be insulated.
■■10-gauge solid copper wire (do not use a wrench to its final location. Firmly grasp dryer body (not console panel) and gently lay dryer down on the corner posts until it is close to finish turning legs until diamond marking is no...
Installation Guide - Page 15
... be connected to the cold water faucet using straightest path possible. CONNECT INLET HOSE (STEAM MODEL ONLY)
For non-steam models, skip to cold water faucet. ...use to "Y"
connector and tighten couplings
Turn cold water faucet off , remove hose,
and replace rubber washer
Using pliers, tighten the couplings with additional two-thirds turn . Damage to dryer location using...
Installation Guide - Page 17
... of the water system, which will go back through the water system in a hard water area, use wrench to
remove any tape remaining on . q Wipe dryer drum interior thoroughly with a damp cloth to adjust legs up using a wood block, use of a water softener is an extra part, go away. The odor will reduce product performance...
Use & Care Guide - Page 5
... calls caused by improper venting are not recommended for smoothing out wrinkles and reducing odors from your lint screen before each bend and curve reduces air flow.
n Use no more drying time or when using cycles that use steam. n Clear away items from the dryer.
Use Sensor cycles for final product check. CHECK YOUR VENT SYSTEM FOR...
Use & Care Guide - Page 7
...Use to turn the dryer on and off. Reduce Static Touch to add the Reduce Static option to turn on some cycles, you may select a dry temperature based on or off .
Steam Boost Steam Boost adds steam to the end of periodic tumbling to help smooth out wrinkles. Wrinkle...minutes to take clothes out of the dryer and avoid an accidental change in the load.
Control Lock Use to lock ...
Use & Care Guide - Page 8
... clothes, casual Normal
Medium
More
78
wear, mixed cottons,
Normal
sheets, corduroys
Less
Shirts, blouses,
Wrinkle
...Wrinkle Prevent†
Steam Boost*
Energy Saver
Cycle Details:
O ffers stepped drying starting with 3-4 items, not more than 1/4 full.
Medium load: Fill the dryer...fabric care. Use Sensor Cycles for better fabric care and energy savings
The dryer senses moisture in...
Use & Care Guide - Page 9
....
If you may be used for items that do not require an entire drying cycle. STEAM CYCLE (on each cycle. Do not add dryer sheets.
† On steam models, you are unsure ...:
Shirts, blouses, and slacks
Cycle:
Refresh
Drying Temperature:
Medium
Default Time:
22
Available Options:
Wrinkle Prevent† Reduce Static*
Cycle Details:
U se to dry foam, rubber, plastic, or heat...
Use & Care Guide - Page 10
.... Place laundry in the dryer. Tightly packing can lead to remove. USING YOUR DRYER
WARNING: To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS before each cycle. Pull the lint screen straight up. Wet lint is hard to poor drying performance and may increase wrinkling and tangling...
Use & Care Guide - Page 11
... Cycle, or Steam Cycle (on Sensor Cycles. Touch + and - to reduce odors and light wrinkles in 5-minute increments. The display will show the settings for detailed information.
There are 5 drying settings, which the dryer will affect all cycles are displayed using the time display:
01 Factory preset dryness level. 02 Slightly drier clothes, 15% more...
Use & Care Guide - Page 12
...use . Align the two hooks on top of the drying rack. The light will need your dryer, order by calling 1-877-944-7566. Good Airflow This indicator will rotate; If Wrinkle Prevent has been selected, the dryer...: Steam is not available on model. 6. ADDITIONAL FEATURES
USING THE DRYING RACK
To purchase a drying rack for Good Airflow".
NOTE: If there are available on the dryer back...
Use & Care Guide - Page 13
... to dry drum OR Use a microfiber cloth and hot water in the Installation Instructions. n If lint falls off the screen with a nylon brush every 6 months, or more often, depending on the lint screen. Rinse screen with a clean towel.
Wet both the dryer and fabrics. Reinstall screen in front of laundry in dryer.
13 Cleaning should...
Use & Care Guide - Page 14
... drain the
hose. Unplug the power supply cord. 2.
Steam models only: Shut off valve in gas supply line. 3. DRYER CARE
NON-USE, STORAGE, AND MOVING CARE
Install and store your dryer during freezing weather, winterize it will be on water faucet. 2. Use tape to the dryer. Unplug dryer or disconnect power. 2. Clean lint screen. Turn off the...
Use & Care Guide - Page 15
... tripped. Unusual Noise
Humming or whining noise with lint, restricting air movement.
Thumping noise Rattling or vibrating noise
Dryer hasn't been used during cycle
is blocked. Clothing is packed tightly or exhaust vent
noise during the Steam function. Loud humming or increased Load is balled up , the load will not run longer. Check that...
Use & Care Guide - Page 16
... on load
Steam models only: Clothes are coming Under certain environmental or installation conditions,
out of the Refresh cycle with damp or
you experience Dryer Results (cont.) Clothes are not ...are wrinkled
Improper use of fabric softener. Dry-clean-only garments are blocking the grille.
The dryer is connected to tumble the load with lint. Separate the load to other clothing....
Use & Care Guide - Page 17
... a problem with an "F" appears in the Installaton Instructions for reducing wrinkles from loads left in the area where your vent system falls within the recommended run from the display and return to the Installation Instructions for the type of the dryer. Electric dryers use two household fuses or breakers. the vent is clogged; The...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Wrinkles in load after Steam cycle - Steam dryer
... Steam cycle - Steam dryer Were you drying a large load? Steam dryer Wrinkles in load after Steam cycle - Is the dryer connected to help smooth out wrinkles from items such as clothes packed in a suitcase or wrinkled from loads consisting of one to see water spraying or steam in the Steam cycles. Unable to four dry items of the cycle? Steam dryer Loads are wrinkled... -
Steam nozzle has blue-green discoloration - Steam dryer
... in your dryer, (located inside the dryer, under the drum light) use white vinegar and scrub with a scouring pad. To clean any blue-green lime or calcium buildup off the water nozzle in my dishwasher Loads are stains on my steam dryer has a blue-green discoloration. There are wrinkled - If the buildup rubs onto clothing items... -
Loads are wrinkled - Dryer
... washer Fabric is also important to promptly remove loads from the dryer before removing the laundry items from setting. The occasional tumbling will take longer to the dryer? Use the Automatic Dry or Sensor Dry to wrinkling. Use Automatic Dry or Sensor Dry How Auto Dry and Timed...
Similar Questions
Maytag Medb835dw Dryer Won't Start Af Signal I Cleaned Vents And Airf
(Posted by 1688fairway 2 years ago)
Check Lint Light Comes On
My Maytag MGDB725BW0 is not working properly. When ready to start the dryer the led reads 40 minutes...
My Maytag MGDB725BW0 is not working properly. When ready to start the dryer the led reads 40 minutes...
(Posted by eid00 4 years ago)
My Maytag Centennial Gas Dryer Wont Dry My Clothes
(Posted by UFOYJkuvar 10 years ago)
Dryer Just Runs And Runs Or Will Add Time To The Timer.
When I set the dryer to dry the clothes it will either add time to the timer or cut the time in half...
When I set the dryer to dry the clothes it will either add time to the timer or cut the time in half...
(Posted by mdalpaugh 10 years ago)
Super Noisy Dryer Brand New
Are these dryers super noisy. Brand new used once
Are these dryers super noisy. Brand new used once
(Posted by abackor 11 years ago)