Maytag MAH2400AWW Support Question
Maytag MAH2400AWW Support Question
Find answers below for this question about Maytag MAH2400AWW - 2.4 cu. Ft. Compact Front Load Washer.Need a Maytag MAH2400AWW manual? We have 3 online manuals for this item!
Question posted by eblazaro01 on May 2nd, 2012
Why Is My Washer Always Stop After Filling Of Water. Motor Good
i conduct service mode all okey, how come when you put in normal wash timer does not advances and later on indicate 3E
Current Answers
Related Maytag MAH2400AWW Manual Pages
Owners Manual - Page 1
...
Table of Contents
Important Safety Instructions 1-2
Operating Instructions 3
Load the Clothes Washer Start the Washer Water Use
Using the Controls 4-6
Turn the Washer On Select the Cycle Select Wash/Rinse Temperature Select Spin Speed Select Soil Level Select Cycle Options Changing a Cycle Canceling a Cycle Cycle Indicator Lights
Features 7-8
Automatic Dispenser Detergent Compartment Bleach...
Owners Manual - Page 2
...instructions for such a period, before using it.
3.
Customers using your dealer, distributor, service agent or manufacturer about problems or conditions you have been removed. What You Need to...explosion: • Do not wash items that may be properly grounded. Install and level the clothes washer on which is not grounded adequately and in a hot water system that could ignite or...
Owners Manual - Page 3
... oil, the fabric may contain some oil after laundering. Important Safety Instructions
washing machine or combination washer-dryer, turn on top of the clothes washer.
18. SAVE THESE INSTRUCTIONS
2 Do not sit on all hot water faucets and let the water flow from service or discarded, remove the door to damage and deterioration over time. As...
Owners Manual - Page 4
..." or "Handwash" cycle with each load. Water Use
The amount of water and energy. Press any water remaining in the cycle.
Fill time will illuminate. 8. However, DO NOT pack the tub tightly.
• Overloading may fluctuate to better indicate the wash time remaining in the washer from the manufacturer's test run without a load. Select the appropriate cycle and options...
Owners Manual - Page 5
... - To drain water from tub without starting the washer, the power automatically turns off . For "wash and wear" and synthetic fabrics and lightly to turn the washer on for your load. Note • To minimize wrinkling of loads, select the Wrinkle Control cycle.
4 For sturdy, colorfast fabrics and heavily soiled garments.
• Normal -
If the washer power is...
Owners Manual - Page 6
... rinse of approximately 80˚ F and cold wash of fabric and construction and for jeans, wrinkle free or "wash-and-wear" items and synthetics.
washable woolens
IMPORTANT • The washer features an automatic temperature
control (ATC) to scroll through the spin speed settings. REMEMBER: In wash water temperatures below 60˚ F, detergents do not dissolve...
Owners Manual - Page 7
...go out.
The Wash indicator lights stops flashing and the new cycle starts. Press the Start/Pause pad.
To cancel a delay, press Start/Pause and reselect the cycle. The Washer light will start ...Start pads at the same time for your load.
2. Turn the Cycle selector dial to Drain or Spin. 3. The Spin light illuminates and the washer starts the drain or spin.
To unlock...
Owners Manual - Page 8
... over-sudsing which reduce or eliminate suds. All laundry additives are trademarks of the load, load size, and water hardness**. Slide the dispenser drawer carefully and completely back into the detergent compartment before starting the washer.
2. s,optionlsi,ghts
Detergent
• For best cleaning results, use :
1. Fill appropriate compartments with detergent, it is important to...
Owners Manual - Page 9
... rinse cycle.
The washer automatically dispenses bleach into the bleach
Controlst aa glance
compartment. It is not recommended with warm water until it reaches the wash load. Do not pour color....
The dispenser automatically dilutes liquid chlorine bleach before it reaches the MAX FILL line on the compartment. 3. Avoid splWahsahtincagn o&r coavnenero-tfiblling the compartmwaeshnetd....
Owners Manual - Page 10
... of dirt, soil or bacteria being run through a complete cycle using hot
Notes
water.
5. Cabinet - Run the washer through your washer interior. Hard water deposits may result in the washer as recommended:
Control Panel - Do not use of cold water.
Repeat the wash cycle if necessary. Failure to follow these instructions may be cleaned and freshened depends...
Owners Manual - Page 11
...to laundry additive buildup.
1.
loading
DETERGENT
SOFTENER BLEACH Controlst aa glance
Dryer Exhaust tips her
2.
For information on the dinisshidwaeshoefrthusee dispenser and pull out.
Press the release lever on long-term storage or storage of the parts under running water. 4. Remove the cups from the fabric softener anNdotes bleach compartments.
3. Wash all of your washer...
Owners Manual - Page 12
...The washer failed to fill but was unsuccessful. The washer has tried to fill but has not reached the proper water level.
Check for service, see below . Code Symbol
Controlst aa glance
Meaning
Solution
Unbalanced loadDrpyerrevEexhnatuesdt tthieps
Redistribute the load, press Start/Pause. Door lock is firmly closed.
Motor not running . OR Unplug the washer for service, see...
Owners Manual - Page 13
....
• Make sure the laundry load is running with sufficient water pressure. Troublesholoaodintg ing
The washer will not tumble or spin unless the door is tightly closed.
Washer vibrates or is too noisy • Make sure the washer is firmly closed.
See Installation Instructions.
• Make sure that the shipping bolts are removed. Stops
• Plug cord...
Owners Manual - Page 14
.... Very small loads (one or two items) may change as the washer determines the temperature of cycle
Leaks Water
• Check fuse or reset circuit breaker. • Straighten drain hoses.
Door locked shut;
Troublesholoaodintg ing
Fills with the wrong temperature water
• Turn both faucets on fully. This is normal.
• While the washer is correctly inserted...
Owners Manual - Page 15
Flushing water sound coming from the load. Whirring or sloshing sound followed by a pause, repeated throughout the wash cycle.
• The tub rotates one direction followed by a pause.
Rapid snapping and/or popping sound from the rear of the washer during spin.
• Before the washer starts to fill, it will make a series of clicking noises to check...
Installation Instructions - Page 2
..., inlet hose or laundry tub
ELECTRICAL
Refer to serial plate for a total overall height of Control Dial C. Height -
CABINET DIMENSIONS
WASHER DIMENSIONS
A. Depth to...detailed information refer to section on Water Requirements. WATER
Washer needs two standard 3/4 inch water supply faucets with a pressure between 20-120 pounds per square inch. With Washer Door Open 90° E....
Installation Instructions - Page 3
... appliance - WATER
To correctly fill the washer in the proper amount of time, Water pressure of an internal hose becoming loose and avoids a flooded home.
if
it will normally allow the water valve to ...up to provide adequate electrical service for faucets more than 20 psi may cause a failure in the water valve and may extend the fill time beyond what the washer controls will not fit ...
Installation Instructions - Page 4
... minimize vibration and/or unbalanced load situations. A louvered door with equivalent air opening . DRAIN FACILITY
Recommended height of the standpipe is attached at the factory. The drain hose must be reinforced to the standpipe.
Wood floors may freeze since the washer will always maintain some water in the water valve, pump and hose areas...
Installation Instructions - Page 7
... the drain hose cannot be leveled on all connections at the water valve and the faucet for leaks. Slide washer into a grounded 120 volt 60 Hz approved electrical service protected by hand. NOTE: The washer must be installed. It's a good idea after the first dozen washes to at least 18" high. Standpipe must always be restricted...
Installation Instructions - Page 8
... drain hose to floor level and tilt washer backwards to prevent excessive vibration.
Select a fill cycle and energize the water valve by running the washer through a complete cycle. All legs should exist). o Washer fills properly on all temperature selections. o Washer is turned on and checked for proper operation by
selecting a warm water setting. Turn the lock nuts on...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Washer will not fill - Front-load Epic® washer
... washer pauses for about 2 minutes during filling. Allow the cycle to fill normally. Some models will fill from the top, while other models will fill from the washer. Allow the unit to continue. When the washer stops filling, press the Pause/Off button. it , if necessary. If the washer is at the lowest 6-o'clock position. Reinstall hoses, turn off the water... -
Washer fills slowly - Epic® front-load washer
... in the back of the washer. front-load washer My Epic ® front-load washer fills slowly. Is the water inlet hose kinked? The water level will not be connected to fill normally. Make sure the washer is not cleaning laundry - Select the Normal cycle and press Start. Wait for details connecting inlet hoses. Washer is empty. Front-load washer Washer fills slowly - -
The amount of water seems too low - Front-load Epic® washer
... seem too low? To test for each load. Allow the unit to give you the proper care for the correct water level: Select the Normal/Casual cycle and press Start. Washer is not cleaning laundry - washer The amount of the three baffles is a low-water-usage washer. When the washer stops filling, press the Pause/Off button. The...
Similar Questions
Maytag Washer, Mah2400aww 45 Second Timer.
Have a Maytag MAH2400AWW top loading washer and had the all too ofter problem with coins obstructing...
Have a Maytag MAH2400AWW top loading washer and had the all too ofter problem with coins obstructing...
(Posted by kkdman2 10 years ago)
Maytag Washer Mah2400aww Alarm Sounds And Door Lock Flashes
Push the power button and then the start button the alarm goes off and the dl flashes. What is wrong...
Push the power button and then the start button the alarm goes off and the dl flashes. What is wrong...
(Posted by cathibohannon 10 years ago)
Maytag Mhwe450ww02 - 4.5 Cu. Ft. Front Load Washer
Is there any recall info for Maytag Mhwe450ww02 - 4.5 Cu. Ft. Front Load Washer?
Is there any recall info for Maytag Mhwe450ww02 - 4.5 Cu. Ft. Front Load Washer?
(Posted by hhppjj 10 years ago)
Maytag Washer Mah2400aww
this washer starts vibrate like crazy with a load it look like nothing is preventing it from shaking...
this washer starts vibrate like crazy with a load it look like nothing is preventing it from shaking...
(Posted by cleveru 11 years ago)
Maytag Model Mvwc400xw Washer Not Running In Any Mode Except 'cold Normal'
Our newly purchased Maytag model mvwc400xw washer is not running in any mode except "cold normal". A...
Our newly purchased Maytag model mvwc400xw washer is not running in any mode except "cold normal". A...
(Posted by miketillman 11 years ago)