Maytag MAH2400AWW Support Question
Maytag MAH2400AWW Support Question
Find answers below for this question about Maytag MAH2400AWW - 2.4 cu. Ft. Compact Front Load Washer.Need a Maytag MAH2400AWW manual? We have 3 online manuals for this item!
Question posted by sholmestyle1 on October 15th, 2020
Why Does My Mah2400aww Repeat Beginning Stage Of Wash?
Repeats first phase of washing over and over - with about 5 min's between attempts..e.g., starts to fill up, slowly spins (seemingly normal), then stops (I think drains) and repeats the cycle again!Checked brushed. Replaced main control board, and didn't see a "motor" control board -- which is what I was going to replace next.
Current Answers
Answer #1: Posted by Odin on October 15th, 2020 5:31 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,690
Member since:
April 10th, 2010 Points: 41,236,690
See https://www.repairclinic.com/RepairHelp/Washing-Machine-Repair/11-4-92325-/New/Maytag-Washing-Machine-MAH3000AWW-ModelTroubleshooting, and consider "Washer won't spin." If that doesn't seem to apply, consider the other options on that page.
If the issue persists or if you require further advice, you'll have to consult the company; use the contact information at https://www.contacthelp.com/maytag/customer-service.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Maytag MAH2400AWW Manual Pages
Owners Manual - Page 1
MAH-24
Use & Care Guide
Table of Contents
Important Safety Instructions 1-2
Operating Instructions 3
Load the Clothes Washer Start the Washer Water Use
Using the Controls 4-6
Turn the Washer On Select the Cycle Select Wash/Rinse Temperature Select Spin Speed Select Soil Level Select Cycle Options Changing a Cycle Canceling a Cycle Cycle Indicator Lights
Features 7-8
Automatic Dispenser ...
Owners Manual - Page 2
...improve the quality and performance of our appliances, it will be placed in the clothes washer until all instructions before using it.
3. HYDROGEN GAS IS EXPLOSIVE. Common sense, caution ... codes. Always contact your washer, follow basic safety precautions, including the following:
1. To avoid the possibility of Purchase
If you have been previously cleaned in, washed in, soaked in a ...
Owners Manual - Page 3
... not sit on top of the appliance or attempt any accumulated hydrogen gas.
Due to service your clothes washer.
8. As the gas is used near children.
10. Do not wash or dry items that you understand and have the skills to play on or in following loads and cause skin irritation.
16. Do not...
Owners Manual - Page 4
...; DO NOT attempt to assure good cleaning results.
• To add a forgotten item in the display.
Press the Start/Pause pad. 7. To add a forgotten item, see pages 7-8). 5.
This will appear in the Normal, Colors, Heavy Duty or Quick Wash cycles, press Start/Pause, wait for efficient cleaning performance and conservation of the cycle. Load the washer loosely...
Owners Manual - Page 5
....
• Handwash - Note • To minimize wrinkling of loads, select the Wrinkle Control cycle.
4 For bright fabrics or fabrics that may bleed.
• Wrinkle Control -
To drain water from tub without starting the washer, the power automatically turns off . For best results, use liquid detergent.
For "wash and wear" and synthetic fabrics and lightly to...
Owners Manual - Page 6
... level settings. The light next to scroll through the spin speed settings. Normal - Whites and heavily soiled color-fast items. ATC Warm/Warm - Use for cleaning lightly soiled loads.
5 Press the pad repeatedly to the Soil Level pad will illuminate. Use for jeans, wrinkle free or "wash-and-wear" items and synthetics. Moderately soiled, color...
Owners Manual - Page 7
... children.
1. Press the Start/Pause pad. Child Lock
The washer controls can be locked to 19 hours in one hour increments.
1. Set the desired options for your load.
2. The Wash indicator lights stops flashing and the new cycle starts.
Cycle Indicator Lights
The Wash, Rinse and Spin lights at the end of the cycle to Drain or Spin. 3. The delay...
Owners Manual - Page 9
... 2. Features Special Fteuares
Bleach Compartment (Liquid ChloriCnyecleBs,loepaticohnlsOi,gnhltys)
1. The washer automatically dispenses bleach into the softener compartment. It is not recommended with warm....
Notes
dishwasher use
• Never pour undiluted liquid chlorine bleach
directly onto the load or into the bleach
Controlst aa glance
compartment. Do not pour color-safe bleach ...
Owners Manual - Page 10
... up all detedrigsehnwat,shbelreaucshe or other spills as recommended:
Control Panel - Repeat the wash cycle if necessary. clean with soap and water.
Leave the door open...can & canneot b
washed
y
Turn off the waoteperrastunigpptilypsto the
Cleaning the Interior
clothes washer and prevent the unlikely possibility of
Clean the interior of the washer periodically to remove
damage ...
Owners Manual - Page 11
...washer through the cycle without any water left over in the
washer. For information on the dinisshidwaeshoefrthusee dispenser and pull out. Run a Rinse & Spin cycle without a load...Wash all of your washer during extreme cold temperatures,
call 1-800-688-2080. Storing the Clothes Washer
Washers can & canneot b
washed... to laundry additive buildup.
1. loading
DETERGENT
SOFTENER BLEACH Controlst ...
Owners Manual - Page 12
...
Meaning
Solution
Unbalanced loadDrpyerrevEexhnatuesdt tthieps
Redistribute the load, press Start/Pause.
Water temperature control problem.
Problem with the washer. Make sure the door is open all...Information codes may be displayed to help you better understand what is not draining. er
washer from spinning.
If the code reappears, call Maytag Customer Service at 1-800-688...
Owners Manual - Page 13
... pad.
See Installation Instructions.
• Make sure the washer is not touching any other object.
• Make sure the laundry load is not activated, see page 6. Continued...
12
For your safety, the washer will not start
• Make sure door is firmly closed .
Stops
• Plug cord into live electrical outlet.
• Check fuse or reset...
Owners Manual - Page 14
... clean screens. This is normal.
• While the washer is filling, you may become
unbalanced and not spin out completely.
• Make sure door is filling, the water temperature may take a few moments for service. • Close the door and press the Start/Pause pad. The washer does not drain and/or spin
Load is closed. • Use...
Owners Manual - Page 15
... dispenser to tub movement during the wash cycle as it sounds like an out-of wash.
The spin speed slows down to redistribute the load more water during the spin cycle, air is added after the washer has been tumbling for maximum performance.
Washer maintains a slightly
reduced spin speed after cycle has started . Water is transferred in and out...
Installation Instructions - Page 2
...20-120 pounds per square inch. CABINET DIMENSIONS
WASHER DIMENSIONS
A. With Washer Door Open 90° E.
Width D. READ THIS BEFORE YOU START... For more detailed information refer to serial plate ...leg out an additional 7\8" for installation: Cable tie to secure drain hose to standpipe, inlet hose or laundry tub
ELECTRICAL
Refer to section on Electrical Requirements. Height - Tools ...
Installation Instructions - Page 4
...washer never be installed on a platform or weakly supported structure.
The drain hose must be installed in areas where water may need to be routed through the drain hose clip to move slightly during the spin cycle. The drain... . Never install the washer on a solidly constructed floor. This can cause damage to minimize vibration and/or unbalanced load situations.
Standpipe must have...
Installation Instructions - Page 5
... accessories, contact Maytag Customer Service, toll-free 1-888-4-Maytag for use on top of the washer. Proper installation is manufactured for shipping damage and have you do not have received all of the items, contact your washing machine and inspect it for operation on 50 Hz products, write:
MMAAYYTTAAGGIINNTTEERRNNAATTIOIONNAALL,,IINNCC.. 18477050 EBaRsYtNWMooAdWfieRldARVoEa...
Installation Instructions - Page 6
... does not stand on a carpeted floor.
6 Keep the shipping bolts and spacers for each bolt.
3.
Repeat for future use. IMPORTANT TO INSTALLER
Please Read The Following Instructions Carefully Before Installing The Washing Machine.
Fill the holes with spacer through the hole in the rear wall of the unit.
1. These Instructions Should Be...
Installation Instructions - Page 7
... the leveling legs in various lengths up against the base of the washer. Level washer by a 15-amp fuse or comparable circuit breaker. When the washer is in the drain facility. NOTE: If drain standpipe is level, tighten the leveling leg lock nuts up to be.... 18" MIN.
96" MAX. 18" MIN.
3. It's a good idea after the first dozen washes to avoid collapsing or damaging the drain hose.
Installation Instructions - Page 8
... leg extension at faucet and water valve connections on and checked for proper operation by
selecting a warm water setting. Place the end of the washer.
o Washer is plugged into drain facility and is sufficient to empty the inlet hoses. 3.
All legs should be firmly on the floor and leveling leg lock nuts tightened...
Maytag Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Washer will not fill or start - Top-load HE washer with Dispensers in Corners
...;Spin or Spin Only to start a new cycle. If the lid is lined up with a cycle? You may not start after the last cycle? Press Start to drain the load. Reinstall the hoses, turn the Cycle Control knob to the load once the washer started . Is the Delay Wash status light on? (on the water and check for up to pause the washer... -
How do I clean my Epic® or Neptune® front-load washer?
... the inserts (the siphon from the main wash detergent compartment. After the clean-out cycle is complete, leave the door slightly open . Let stand 5 minutes. Select the additional or 2nd Rinse option (if available). Replace the detergent compartment divider. My front load washer has an odor Not draining, not spinning out water, wet loads - Use mild soap and water... -
Do I use my load-sensing Energy Star top-load washer with agitator differently than conventional washers?
...;Do you start the washer. Opening the lid will stop the washer and cause it to lose the ability to sense the size of water near the washer to slightly adjust your load. See: My Energy Star top-load washer is on the clothes load and cycle you use my load-sensing Energy Star top-load washer with...
Similar Questions
How To Replace Door Latch On A Maytag Compact Front Load Washer
(Posted by trabibil 9 years ago)
Maytag Mah2400aww Front Load Washer Won't Drain Or Spin
(Posted by wljohjiw 9 years ago)
If Motor Is Burned, I Will Think Thar Rinse Cycle Will Not Work Also But That
is not the case. Is there any other thought?
is not the case. Is there any other thought?
(Posted by doshichetan 11 years ago)
New Maytag Top Load Washer Model Mvwc300vw1, Gentle Cycle Question?
Hello, I have a new maytag top load washer model MVWC300VW1, we notice the gentle cycle seems to be ...
Hello, I have a new maytag top load washer model MVWC300VW1, we notice the gentle cycle seems to be ...
(Posted by hopkins9241 13 years ago)