Question posted by tonyfp231 on October 5th, 2016
Tracking Screw On Makita 9910 Belt Sander
How can I keep the tracking adjustment screw from backing out during use? It causes the sanding belt to drift into the housing and has sliced into the housing close to 5/16 inch. This is on my Makita 9910 3 X18 inch belt sander.
Current Answers
Similar Questions
Cant Adjust Pressure
I just put 2 new gauges and a regulator on my mac5200. I replaced the regulator because it was leaki...
I just put 2 new gauges and a regulator on my mac5200. I replaced the regulator because it was leaki...
(Posted by crfridered 3 years ago)
Valve Adjustment
can you tell me what the valve adjustment specs. are on ek7651h is
can you tell me what the valve adjustment specs. are on ek7651h is
(Posted by terry16744 7 years ago)
Sander Base
I have to replace the base on my sander. How is it held on to the machine?
I have to replace the base on my sander. How is it held on to the machine?
(Posted by sailored66 7 years ago)
Screws Came Out Of Starter Pull Cord Panel Replaced But Wont Start
(Posted by mariann43 8 years ago)
How To Adjust Carburetor Speed On Makita G 1100
Engine running too fast, how do I adjust the speed?
Engine running too fast, how do I adjust the speed?
(Posted by sacourville 9 years ago)