Mackie SRM150 Support Question
Mackie SRM150 Support Question
Find answers below for this question about Mackie SRM150.Need a Mackie SRM150 manual? We have 1 online manual for this item!
Question posted by cjwiii44821 on August 5th, 2021
Srm 150 Up And Quit.
My units produce a clicking noise when on, and volume turned up. No other sound. One quit last year, the other two days ago. Had them, worked fine for about 4-5yrs. Just the clicking sound once the volume pot is turned up to about 10 O'clock position and produces same clicking noise, into the speaker when turned down. ??? diode ? chip ?
Current Answers
Answer #1: Posted by SonuKumar on August 5th, 2021 10:47 PM
SonuKumar
Member since:
May 9th, 2021 Points: 16,621,300
Member since:
May 9th, 2021 Points: 16,621,300
https://mackie.com/sites/default/files/PRODUCT%20RESOURCES/MANUALS/Owners_Manuals/SRM150_OM.pdf
Please follow reset process -Page 8-9-10
If not the worked -It needs to be serviced by expert .
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Mackie SRM150 Manual Pages
User Manual - Page 1
SRM150 Compact Active PA System USer's manual
SRM150
COMPACT ACTIVE PA SYSTEM
MAIN
EQ
U
OFF
MAX
LEVEL
HIGH 12kHz
-15 +15 U
PHANTOM POWER 48V
INSTRUMENT (CH 1)
MID 2.5kHz
-15 +15 U
LOW 100Hz
-15 +15
1
2
3
MIN MAX
MIC/LINE
MIN MAX
MIC/LINE
MIN MAX L
R
User Manual - Page 2
...set forth here:
Duration, per day in hours 8 6 4 3 2 1.5 1
Sound Level dBA, Slow Response 90 92... (OSHA) has specified the permissible noise level exposures shown in the radio ...cart is used as this type of producing high sound pressure levels use caution when moving the...tripod, bracket, or table PORTABLE CART
WARNING
specified by turning the equipment off your waste equipment for a Class ...
User Manual - Page 3
......10
PLACEMENT...11 THERMAL CONSIDERATIONS...11 AC POWER CONSIDERATIONS...12 CARE AND MAINTENANCE...12 CONNECTIONS...13 SERVICE INFORMATION...14
Troubleshooting...14 Repair...15
SRM150 SPECIFICATIONS...16 SRM150 BLOCK DIAGRAM...18 SRM150 LIMITED WARRANTY...19
Don't forget to visit our website at www.mackie.com for more information about this and other Mackie products...
User Manual - Page 4
...
Thank you the best performance of any distortion, turn down the input (MIC/LINE) gain control, or turn down the MAIN LEVEL control.
• The amplifiers are designed specifically for the speaker load impedance.
The Active Advantage
4. The SRM150 is designed to produce the best possible sound.
4 The SRM150 cabinet was to build a compact PA system with...
User Manual - Page 5
... Turn up the MAIN LEVEL control (or the input source volume control, if it was with the correct voltage for your particular model. (The SRM150 ...Turn the POWER [8] switch off . connections from mixers, preamplifiers, CD players, tape decks, etc., and accepts direct
9. Plug the other mic-
Slowly turn down (counterclockwise) before investigating. If there is no sound, always turn...
User Manual - Page 6
...
Vocal Mic Electric Guitar
Boom Extender (Included) Mic Stand Adapter (Included)
SRM150
1
2
3
THRU Out
Power Cord
SRM450
To Input
Power Cord
Here the SRM150 is the main PA speaker.
SRM150: SMALL CLUB SETUP WITH SRM450
6
Connect the microphone and an instrument to the SRM150 (Channels 1 and 2), and a playback device like an MP3 player to the...
User Manual - Page 7
...
MUTE
MUTE
MUTE
MUTE
MUTE
MUTE
MUTE
1
2
3
4
5
7
9
11
6
8 10 12
TALKBACK
MAIN MIX
SOLO
SOLO
SOLO
SOLO
SOLO
SOLO
SOLO
SOLO
Mic Stand Adapter (Included)
SRM150 COMPACT ACTIVE PA SYSTEM
MAIN
EQ
U
HIGH 12kHz
LEVEL PHANTOM POWER
48V
INSTRUMENT (CH 1)
U MID 2.5kHz
U LOW 100Hz
1
2
3
MIC/LINE
MIC/LINE
L
R
Audio
Power Cord...
User Manual - Page 8
... requires phantom power. Normally, you may need to turn the gain control up noise over 20 feet), it is pushed in, the... 1 and 2 have a particularly high line-level signal connected to the SRM150, you are running a long cord between a guitar and a mixer's or...the loss of gain, especially at high frequencies, resulting in a dull sound. or cold)
2. When the button is unbalanced, so if you...
User Manual - Page 9
... for setting the MAIN LEVEL control.
7.
This is turned on. Check the manual for your microphone to 15 ...or cut of the loudspeaker.
However, phantom power will brighten the sound of up or down in while the phantom power is a ...older ribbon microphones.
The HIGH EQ provides a boost or cut of the SRM150. These frequencies are located in the mid-range frequencies, so this can...
User Manual - Page 10
... the MAIN LEVEL [6] control. The SRM150 has a universal power supply that produces the main signal just prior to "Repair" on . No... the front of the speaker glows to let you know that you're ready to turn the SRM150 on page 15.
10...LINE MIC
MAIN IN
SRM150
10 When the POWER switch is turned on, and the linecord is a standard 3-prong IEC connector. It will work virtually anywhere in (MIC...
User Manual - Page 11
...thermal switch will reset and the SRM150 will activate, placing the SRM150 amplifier into standby.
When the ...SRM150 compact active PA systems are designed to sit on the floor, a tabletop, or to do need to reinforce the low frequencies, this case, you to overheat. This, too, increases the low frequency output, though not as much as a floor monitor.
A hollow stage can cause the sound...
User Manual - Page 12
... cord of your toolbox so you can be safely operated at its maximum level. When turning off . This allows each SRM150 to power the lights from your system, turn -off the SRM150s first. These testers will help minimize noise from your speakers. Don't use an outlet if it is wired improperly! This will prevent any of...
User Manual - Page 14
... Start" section to the active speakers are good.
• Make ...sound!
• Is it 's coming from the signal source. Noise
• Make sure all connections to verify that all the way down .
Try some of the signal cables are properly adjusted.
• Is the signal source working...SRM150? No sound!
• Is the input gain control [3] or the MAIN LEVEL [6] control turned all the volume...
User Manual - Page 15
... Mackie products living outside the United States can call our Tech Support department at a factory-authorized service center.
Need Help?
• Visit www.mackie.com and click Support to find: FAQs (....com. • Telephone 1-800-898-3211 to the warranty information on page 19.
com, click "Support" and select "Locate a Service Center." Repair
For warranty service, refer to speak with...
User Manual - Page 16
... finish
Handle
Top mounted
Grille
Perforated metal with the supplied adapter. All Rights Reserved. SRM150 SPECIFICATIONS
System Specifications
Frequency Response (-3 dB) Frequency Range (-10 dB) Max SPL Long... change these specifications at unity
Noise (20 Hz to 20 kHz BW, 150 ohm source impedance) Equivalent Input Noise (EIN) -129 dBu Residual Output Noise (Line out, channel and master...
User Manual - Page 17
... POWER 48V
INSTRUMENT (CH 1)
MID 2.5kHz
-15 +15 U
LOW 100Hz
-15 +15
1
2
3
MIN MAX
MIC/LINE
MIN MAX
MIC/LINE
MIN MAX L
R
8.0 in/ 20.3 cm
SRM150 COMPACT ACTIVE PA SYSTEM
MAIN
EQ
HIGH
LEVEL PHANTOM POWER
48V
INSTRUMENT (CH 1)
MID LOW
1
2
3
MIC/LINE
MIC/LINE
11.2 in/ 28.4 cm
6.8 in/ 17...
User Manual - Page 18
Gain
+
- Gain
+
-
Line Mic (-30 dB)
+
-
2
1 THRU
3
3-Band EQ Main Level
LO MID HI 100 2.5K 12K
Limiter
Power Amplifier
Loudspeaker SRM150 BLOCK DIAGRAM
18
Channel 1
2
Mic 1
3
Line
48V Phantom
Channel 2
2
Mic 1
3
Line
Channel 3
2 1
3
Main In
Line Instrument
Hi-Z
Gain
+
-
User Manual - Page 19
... notice of the product (hereinafter, "Customer," "you" or "your").
and Canada) during the Warranty Period. Mackie Limited Warranty
Please keep your sales receipt in the United States or Canada through a LOUD-authorized reseller or dealer. If the product fails to conform to obtain any such nonconforming product, provided that the product...
User Manual - Page 20
16220 Wood-Red Road NE • Woodinville, WA 98072 • USA United States and Canada: 800.898.3211 Europe, Asia, Central and South America: 425.487.4333 Middle East and Africa: 31.20.654.4000 Fax: 425.487.4337 • www.mackie.com E-mail: [email protected]
Similar Questions
My Speaker Lid Doesn't Come On It Just Makes A Zaping Noise When I Turn Power On
(Posted by Tyreejohnson939 11 months ago)
Nothing Comes Out Of The Speaker.
Lights come on and I can hear the hum of the speakers. I have my guitar plugged into channel 1 no so...
Lights come on and I can hear the hum of the speakers. I have my guitar plugged into channel 1 no so...
(Posted by Joeantonucci 2 years ago)
Why Won't My Fairly New Srm 650 Powered Speaker Turn On?
I went to a gig plugged it in and it no longer turns on
I went to a gig plugged it in and it no longer turns on
(Posted by Jarrodamanzi 2 years ago)
Leds Pulsate
SRM150 powers on, no sound and LEDs continually pulsate. help
SRM150 powers on, no sound and LEDs continually pulsate. help
(Posted by 4pacific 9 years ago)