LiftMaster 3850 Support Question
LiftMaster 3850 Support Question
Find answers below for this question about LiftMaster 3850.Need a LiftMaster 3850 manual? We have 1 online manual for this item!
Question posted by Juvis on February 6th, 2014
How To Change Liftmastermodel 3850 Battery
The person who posted this question about this LiftMaster product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related LiftMaster 3850 Manual Pages
3850 Elite Series Manual - Page 1
®
GARAGE DOOR OPENER Models 3850
3850-267
For Residential Use Only
Com Details
The Chamberlain Group, Inc. 845 Larch Avenue Elmhurst, Illinois 60126-1196 www.liftmaster.com
patible with
See Page 29 for
Owner's Manual
■ Please read this manual and the enclosed safety materials carefully! ■ Fasten the manual near the garage door after installation. ■...
3850 Elite Series Manual - Page 2
... 25
Operation
26-33
Operation safety instructions 26
Using garage door opener 26
Using the wall-mounted door control 27
Using the remote control 28
Troubleshooting 28
The remote control battery 28
EverCharge® Standby Power System (optional 29
To open the door manually 30
Care of your opener 30
Having a problem? (Troubleshooting 31
Diagnostic chart 32
Smart...
3850 Elite Series Manual - Page 3
..., sticks, or is out of which are under EXTREME tension.
• Disable ALL locks and remove ALL ropes connected to garage door BEFORE installing and operating garage door opener to avoid malfunction and damage. Carpenter's Level (optional)
12 Tape Measure
Pencil
Stepladder
Drill Bits
Drill
3/16", 5/16"
and 5/32"
Sockets and Wrench 1/2", 5/8", 7/16", 9/16" ...
3850 Elite Series Manual - Page 5
... is also listed below . Carton Inventory
Your garage door opener is packaged in the foam.
Accessories will depend on the model purchased. LOCK
LIGHT
SLmCaDrtMCootniotrnolDPeatencetli®ng Door Control Console
SECURITY✚® 3-Button Remote Control
Models 3850 (1) 3850-267 (2)
SECURITY✚® Keyless Entry Model 3850-267 (1) ONLY
Motor Unit with Light Lenses...
3850 Elite Series Manual - Page 6
... the Rail to the Motor Unit
To avoid installation difficulties, do not run the garage door opener until instructed to door opener. • Position belt over belt pulley.
Washered Bolt 5/16"-18x1/2"
Rail Hole...releases and snaps the nut ring against the trolley (Figure 2).
• Place a 7/16" open end wrench on the square end. Rotate about 1/4 turn until it firmly against the trolley (...
3850 Elite Series Manual - Page 7
... with the three holes in garage door or opener mechanisms.
9.
READ AND FOLLOW ALL INSTALLATION WARNINGS AND INSTRUCTIONS.
2. Install wall-mounted garage door control:
• within sight of the garage door.
• out of reach of children at minimum height of 5 feet (1.5 m).
• away from electrocution, disconnect ALL electric and battery power BEFORE performing ANY service...
3850 Elite Series Manual - Page 11
... ceiling.
11 You will need help at this point.
Slide the outer trolley toward the motor unit. Header Bracket
Top of Motor Unit
Top of Door
2x4 is convenient for setting an ideal door-to garage door, rest garage door opener rail on 2x4 placed on the trolley release arm to disconnect inner and outer sections.
SECTIONAL...
3850 Elite Series Manual - Page 12
... brackets should be angled (Figure 1) to opener at this time. Measure the distance from a falling garage door opener, fasten it SECURELY to structural supports of the rail surface where the trolley slides with
5/16"-18x1-7/8" lag screws. 5. Check to the structural support. 2. Remove the 2x4. If the door hits the rail, raise the header bracket...
3850 Elite Series Manual - Page 13
... fully functional. SPECIAL NOTE: Only one end of bell wire and connect to the two screw terminals on screw head and slide down to each garage door opener. Strip 7/16" (11 mm) of insulation from one 398LM can be seen clearly, is slower at a minimum height of 5 feet (1.5 m) where small children cannot reach...
3850 Elite Series Manual - Page 14
...) Standard Light Bulb
Lens Hinge
14 Then the lights will turn OFF.
• Reverse the procedure to close the lens.
• Use A19, standard neck garage door opener bulbs for approximately 4-1/2 minutes when power is connected. Use ONLY incandescent. ALWAYS wear protective gloves and eye protection when changing the battery or working around the...
3850 Elite Series Manual - Page 15
...from electrocution or fire:
• Disconnect ALL electric and battery power BEFORE performing ANY service or maintenance.
• Garage door installation and wiring MUST be grounded.
• Reinstall the...your garage door opener has a grounding type plug with ALL local electrical and building codes.
• NEVER use an extension cord, 2-wire adapter, or change plug in an open door falling ...
3850 Elite Series Manual - Page 16
...®
The safety reversing sensor must be connected and aligned correctly before the garage door opener will move in masonry construction, add a piece of the garage door (or door tracks, springs, hinges, rollers or other across the door, no more than 6" (15 cm) above garage floor. IMPORTANT INFORMATION ABOUT THE SAFETY REVERSING SENSOR
When properly connected and aligned...
3850 Elite Series Manual - Page 24
....
• NEVER use force adjustments to compensate for the force to enter unit into the Force Adjustment Mode. The door will stop flashing when the force has been programmed. If the garage door opener cannot open (UP).
4. Push the purple button twice to ensure that it is balanced properly and is not stopping exactly where...
3850 Elite Series Manual - Page 25
...), remove the obstruction and run the opener through 3 or 4 complete travel cycles to test adjustment.
• If the unit continues to open , place a 1-1/2" (3.8 cm) board (or a 2x4 laid flat) on striking the obstruction.
The garage door opener will flash. The door must reverse on the floor, centered under the garage door.
• Operate the door in the down direction.
3850 Elite Series Manual - Page 26
... rapidly and/or unexpectedly, causing SEVERE INJURY or DEATH.
7. If opening , the door will open garage door. If the door has been stopped in an open , the door will operate with each use . If the sensor is not installed, or is clear of which changes with up to pull garage door open , the door will reverse.
3. However, you can be programmed before use...
3850 Elite Series Manual - Page 31
... remote will not activate the door: • Verify your door, check diagnostic LED for balance or any obstructions. My garage door opener beeps: • A solid LED with beep, sounding approximately every 2 seconds, indicates the motor unit is activating the door and is operating off when door is open: • The garage door opener is not lit properly: • Check battery connections.
8.
3850 Elite Series Manual - Page 32
...'t activate from the door control. • Inspect door control/wires for the sensors. Momentarily short across red and white terminals with self-diagnostic capabilities. Bell Wire
Safety Reversing Sensor
Diagnostic Chart
Diagnostics Located On Motor Unit
"Learn" Button LED or Diagnostic LED "Learn" Button
Installed Safety Reversing
Sensor
Your garage door opener is programmed with...
3850 Elite Series Manual - Page 34
... the non-rolling code remote control to operate other Security✚® garage door openers.
34 Your garage door opener has already been programmed at the factory to operate with additional 315 MHz...* that you wish to use.
1. PROGRAMMING
NOTICE: If this Security✚® garage door opener is factory programmed to operate it has learned the code. To Erase All Codes From...
3850 Elite Series Manual - Page 35
... PIN was set to a certain number of openings, remember that the test has used to 0 in step 3. The keypad will work , press the number of your garage door opener. The learn " button on the keypad. ...digit personal identification number (PIN) of times (up to confirm Learn Mode. It can be changed by visitors or service people with a temporary 4-digit PIN. Press and release the "learn ...
3850 Elite Series Manual - Page 38
...adding additional sensor modules.
485LM
395LM
Remote Light Control :
Enables homeowner to operate garage door opener from car, bedside, or anywhere in the garage.
Enables homeowner to the garage door opener.
Includes battery. ACCESSORIES
1702LM
Outside Quick Release:
Required for a garage with model 3850 only. Tells you if your home!
SECURITY✚® 3-Button Mini Remote...
Similar Questions
I Have Installed A Chamberlan Garage Door Opener And The Remote I Was Using Is
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
(Posted by donweera42 7 months ago)
How To Change Battery In Wall Control Garage Door Opener Model 3850 Liftmaster
(Posted by cjmanpiop 9 years ago)
How To Remove Backup Battery In Liftmaster Backup Battery Garage Door Opener
manual
manual
(Posted by Albdunca 10 years ago)
Where To Buy Batteries For A Model 3850 Elite Series Garage Door Opener
(Posted by NADGmark85 10 years ago)
How To Replace Battery In Lift Master Garage Door Opener Model 3850
(Posted by pinButter 10 years ago)