LiftMaster 3585 Support Question
LiftMaster 3585 Support Question
Find answers below for this question about LiftMaster 3585.Need a LiftMaster 3585 manual? We have 1 online manual for this item!
Question posted by dkieffer579 on November 4th, 2011
Why Are My Lights Not Working On The Liftmaster 3585?
I can hear the switch go on and off, but even new light bulbs do not light.
Current Answers
Related LiftMaster 3585 Manual Pages
3585 Elite Series Manual - Page 1
®
GARAGE DOOR OPENER Model 3585 3/4 HP
For Residential Use Only
The Chamberlain Group, Inc. 845 Larch Avenue Elmhurst, Illinois 60126-1196
www.liftmaster.com
Owner's Manual
■ Please read this manual and the enclosed safety materials carefully! ■ Fasten the manual near the garage door after installation. ■ The door WILL NOT CLOSE unless the Protector System®...
3585 Elite Series Manual - Page 2
...bracket 9
Attach the rail to the header bracket 10
Position the opener 11
Hang the opener 12
Install the door control 13
Install the light 14
Attach the emergency release rope and handle . . . ... your garage door opener 26
Using the wall-mounted door control 27
Using the remote control 28
To open the door manually 29
Care of your garage door and/or the garage door opener if ...
3585 Elite Series Manual - Page 3
... under EXTREME tension.
• Disable ALL locks and remove ALL ropes connected to garage door BEFORE installing and operating garage door opener to make sure your door binds, sticks, or is out of the opener, instructions will call a trained door systems technician. Release the
door. An unbalanced garage door may not reverse when required.
• NEVER try to avoid malfunction and...
3585 Elite Series Manual - Page 5
... two cartons which contain the motor unit and all parts illustrated below . Carton Inventory
Your garage door opener is packaged in the foam. Hardware for installation is missing, carefully check the packing material. LOCK
LIGHT
SmLCarDt CMoontitoronl DPeatneecltTMing Door Control Console
SECURITY✚® 3-Button Remote Control Model 373P (1)
Remote Control TVrisaonrsmCliitpter Visor...
3585 Elite Series Manual - Page 6
...until the spring releases and snaps the nut ring against the trolley (Figure 3).
Liftmaster Synchro Drive
• Cut tape from the top of the motor unit.
&#... STEP 1
Attach the Rail to the Motor Unit
To avoid installation difficulties, do not run the garage door opener until instructed to do so.
• Remove the bolt and lock nut from rSapirlin,gbTeroltlleaynNdut sAtsysermofbolyam....
3585 Elite Series Manual - Page 7
...WARNING
To reduce the risk of installation, test safety reversal system. An improperly balanced door may
9. Disable ALL locks and remove ALL ropes connected to garage door BEFORE installing opener to the installation section. You have now finished assembling your garage door opener. Please read the following warnings before proceeding to avoid entanglement.
5. HARDWARE SHOWN ACTUAL SIZE...
3585 Elite Series Manual - Page 11
INSTALLATION STEP 4
Position the Opener
Follow instructions which apply to garage door, rest garage door opener rail on 2x4 placed on top section of door. You will need help at this point. To prevent damage to your door type as illustrated. Slide the outer trolley toward the motor unit. ENGAGED
Trolley Release Arm
RELEASED
ONE-PIECE DOOR WITHOUT TRACK
A 2x4...
3585 Elite Series Manual - Page 12
...each bracket to provide rigid support. Attach one end of each side of the garage. Fasten the opener to required lengths.
3. Remove the 2x4.
This bracket and fastening hardware are...16"-18x7/8" Lock Washer 5/16" Nut 5/16"-18
12 Operate the door manually. Measure the distance from a falling garage door opener, fasten it SECURELY to structural supports of the motor unit to make sure...
3585 Elite Series Manual - Page 13
... wires. DO NOT connect power and operate the opener at this time.The trolley will travel . • ALWAYS keep garage door in new home construction), it may damage the LCD screen....
LOCK
LIGHT
24 Volt Bell Wire
LOCK
LIGHT
Figure 2
2-Conductor Bell Wire
Push Bar
Quick-Connect Terminals
R
W
1
2
(BACK VIEW)
Door Control Terminal Screws
LOCK
Lock Button
LOCK
Light Button
Door Control...
3585 Elite Series Manual - Page 14
... Handle
Trolley Release Arm Rope
NOTICE
Overhand Knot
14 Do not remove the lens.
• Install a 100 watt maximum light bulb in the fully open or closed. The use of all vehicles to close the lens.
• Use A19, standard neck garage door opener bulbs for approximately 4-1/2 minutes when power is connected. To prevent damage to the...
3585 Elite Series Manual - Page 15
... a third grounding pin. PERMANENT WIRING CONNECTION
Ground Tab Green Ground Screw
Ground Wire
Black Wire
White Wire
Black Wire
15 Be sure the opener is required by your garage door opener has a grounding type plug with all local electrical and building codes.
• NEVER use an extension cord, 2-wire adapter, or change plug in...
3585 Elite Series Manual - Page 16
... shines directly into the receiving eye lens. If an obstruction breaks the light beam while the door is NO HIGHER
than 6" (15 cm) above floor
Invisible Light Beam Protection Area
Facing the door from a closing , the door will stop and reverse to the garage door opener BEFORE installing the safety reversing sensor. Either can be installed on the...
3585 Elite Series Manual - Page 25
...door fully open the door.
• Place the opener carton in the path of the opener. The door will not move more than 1" (2.5 cm), and the opener lights will not close the door. If the opener closes the door...call for a trained door systems technician. The garage door opener will flash. Safety Reversing Sensor
25
Safety Reversing Sensor ADJUST • If the door stops on striking the...
3585 Elite Series Manual - Page 26
... billion new codes. The opener lights will operate with up to move . • The Keyless Entry (See Accessories): If provided with the opener lights on contact with each use . To restore this feature may also need adjustment.
10. WARNING
OPERATION
IMPORTANT SAFETY INSTRUCTIONS WARNING
To reduce the risk of children. NEVER permit children to garage door opener BEFORE...
3585 Elite Series Manual - Page 30
... my motor unit: The safety reversing sensor must be connected and aligned correctly before the garage door opener will not close and the light bulbs blink on when the safety sensor beam has been obstructed. My door will move away from the arrow. The trolley should travel .
• Refer to Operation section; If the trolley re...
3585 Elite Series Manual - Page 31
...
1
9
1
7
3
7
3
5
5
KG
KG
Motor Unit
Safety Reversing Sensor
"Learn" Button LED or Diagnostic
LED
Diagnostic Chart
Installed Safety Reversing
Sensor
Your garage door opener is programmed with jumper wire. Symptom: Sending indicator light glows steadily, receiving indicator light is dim or flashing. • Realign receiving eye sensor, clean lens and secure brackets. • Verify...
3585 Elite Series Manual - Page 33
... Unit Memory
To deactivate any Security✚® 3-Button remote or compact remote can be circumvented. If light bulbs are instructions for 30 seconds.
2. Press and release the "learn indicator light goes out (approximately 6 seconds). Your garage door opener has already been programmed at the factory to operate with a non-rolling code transmitter, the technical measure...
3585 Elite Series Manual - Page 34
...openings, remember that the test has used to 255), then press #. USING THE "LEARN" BUTTON
USING THE SMART CONTROL PANELTM
1. LOCK
LIGHT
3. Release the button when the motor unit lights blink. Press the new... and hold the ✽ button. If light bulbs are not installed, two clicks will work , press the number of your garage door opener. Press the four buttons for the present ...
3585 Elite Series Manual - Page 37
... to a programmable number of your garage door is designed to protect LiftMaster® garage door openers against damage from anywhere in the garage.
990LM
Surge Protector:
The Garage Door Opener Surge Protector is open garage door manually from outside radio signals while you if your home! Wireless Door Control: Push bar, light feature and auxiliary button. ACCESSORIES
1702LM...
3585 Elite Series Manual - Page 40
...OR REPLACED UNIT, REPLACEMENT OF BATTERIES AND LIGHT BULBS OR UNITS INSTALLED FOR NON-RESIDENTIAL USE....liftmaster.com
For professional installation, parts and service, contact your area.
Technical Support Group 6050 S. Failure to comply strictly with new... INFORMATION TOLL FREE NUMBER:
1-800-528-9131
LIFTMASTER® GARAGE DOOR OPENER FIVE-YEAR LIMITED WARRANTY
LIFETIME MOTOR AND BELT ...
Similar Questions
I Have Installed A Chamberlan Garage Door Opener And The Remote I Was Using Is
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
(Posted by donweera42 8 months ago)
Garage Door Opens After Shutting.
My Lift master 8550 inside keypad is Inside wall pad is model #880LM. outside keypad Model # is 877M...
My Lift master 8550 inside keypad is Inside wall pad is model #880LM. outside keypad Model # is 877M...
(Posted by BONNIECA92 2 years ago)
Liftmaster Elite Garage Door Opener Manual
i have a 3585s opener. always workusing inside control. it has been failing to open at times useing ...
i have a 3585s opener. always workusing inside control. it has been failing to open at times useing ...
(Posted by lgwinnjr 10 years ago)
Programming My Car To Garage Door Opener
I am unable to program garage door to 2012 Acura, is my system to old.
I am unable to program garage door to 2012 Acura, is my system to old.
(Posted by Vherd84 11 years ago)