LiftMaster 3280 Support Question
LiftMaster 3280 Support Question
Find answers below for this question about LiftMaster 3280.Need a LiftMaster 3280 manual? We have 1 online manual for this item!
Question posted by xo4xxhar on June 19th, 2014
Does Liftmaster 3280 Work With Homelink
The person who posted this question about this LiftMaster product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related LiftMaster 3280 Manual Pages
3280 Manual - Page 1
®
GARAGE DOOR OPENER Model 3280 1/2HP
3280-267 1/2HP
For Residential Use Only
The Chamberlain Group, Inc. 845 Larch Avenue Elmhurst, Illinois 60126-1196
www.liftmaster.com
Owner's Manual
■ Please read this manual and the enclosed safety materials carefully! ■ Fasten the manual near the garage door after installation. ■ The door WILL NOT CLOSE unless the Protector...
3280 Manual - Page 2
... parts 34
Accessories
35
Repair Parts and Service
36
Warranty
36
INTRODUCTION
Safety Symbol and Signal Word Review
This garage door opener has been designed and tested to the possibility of your garage door and/or the garage door opener if you do not comply with the instructions and warnings contained in strict accordance with the cautionary statements...
3280 Manual - Page 3
...
Tools needed
During assembly, installation and adjustment of which are under EXTREME tension. • Disable ALL locks and remove ALL ropes connected to garage door BEFORE installing and operating garage door opener to avoid entanglement.
Carpenter's Level (optional)
12
Tape Measure
Pencil
Stepladder
Drill Bits
Drill
3/16", 5/16"
and 5/32"
Sockets and Wrench 1/2", 5/8", 7/16", 9/16...
3280 Manual - Page 4
... back to see if any of your opener. Survey your garage area to this page and the accompanying illustrations as you proceed with glass panels, etc.). Safety Reversing Sensor
Safety Reversing Sensor
Gap between floor and bottom of door
Reversing Sensor
must not exceed 1/4" (6 mm)
ONE-PIECE DOOR WITHOUT TRACK
FINISHED CEILING
Support bracket...
3280 Manual - Page 5
...parts illustrated below . LOCK
LIGHT
Multi-Function Door Control Panel
SECURITY✚® 3-Button Remote Control
Models 3280 (1)
3280-267 (2)
Remote Control Transmitter Visor Clip
... Bolt 1/4"-20x1/2" (2) Wing Nut 1/4"-20 (2) Rope Handle
Straight Door Arm Section
5 Carton Inventory
Your garage door opener is missing, carefully check the packing material. Hardware for installation is...
3280 Manual - Page 6
.... • Insert wasThheeCrehadmbbeorllatsin Gthroruopu, gInhc. To avoid SERIOUS damage to opener, ONLY use any tools.
• Insert a screwdriver tip into the
motor unitL.iftTmiagshtetreSnynbchoroltsDrisveecurely.
ASSEMBLY STEP 1
Attach the Rail to the Motor Unit
To avoid installation difficulties, do not run the garage door opener until instructed to do so. • Remove the two washered...
3280 Manual - Page 7
... proceeding to avoid entanglement.
5. Install garage door opener ONLY on inside of the door.
10. Install wall-mounted garage door control:
• within sight of the garage door.
• out of reach of children at minimum height of 5 feet (1.5 m).
• away from moving parts of garage door.
12. You have now finished assembling your garage door opener. Hex Screws 8x3/8"
Belt Cap...
3280 Manual - Page 8
... be used if mounting header bracket or 2x4 into masonry. • NEVER try to loosen, move or adjust garage door, springs, cables, pulleys, brackets, or their hardware, all of which apply to your door.
1. Open your garage, use lag screws (not provided) to securely fasten the 2x4 to structural supports as shown.
Extend the line...
3280 Manual - Page 11
....
• Remove foam packaging.
• Raise the opener onto a stepladder. Do not position the opener more than 4" (10 cm) above this point if the ladder is completed. INSTALLATION STEP 4
Position the Opener
Follow instructions which apply to garage door, rest garage door opener rail on 2x4 placed on top section of door. You will need help at this point.
3280 Manual - Page 12
...
12
Drill 3/16" pilot holes in line with rail grease. Hanging brackets should be angled (Figure 1) to the structural support. 2. Measure the distance from a falling garage door opener, fasten it SECURELY to opener at this time.
3280 Manual - Page 14
... lights will turn ON and remain lit for approximately 4-1/2 minutes when power is CLOSED. Weak or broken springs or unbalanced door could fall. To prevent damage to avoid entanglement. Secure with a Garage Door Opener bulb.
Gently rotate lens back and downward until the lens hinge is necessary to cut the rope, heat seal the...
3280 Manual - Page 15
... CONNECTION
Ground Tab Green Ground Screw
Ground Wire
Black Wire
White Wire
Black Wire
15 To make it fit outlet. Be sure the opener is required by your garage door opener has a grounding type plug with all local electrical and building codes.
• NEVER use an extension cord, 2-wire adapter, or change plug in...
3280 Manual - Page 16
... units must be disabled. • Install the safety reversing sensor so beam is necessary. This required safety device MUST NOT be securely fastened to the garage door opener BEFORE installing the safety reversing sensor. If installing in masonry if repositioning is NO HIGHER than 6" (15 cm) above floor
Invisible Light Beam Protection Area...
3280 Manual - Page 25
... a 1-1/2" (3.8 cm)
board (or a 2x4 laid flat) on the floor, centered under the garage door. • Operate the door in the down direction. The garage door opener will flash.
ADJUSTMENT STEP 3
Test the Safety Reversal System
TEST • With the door fully open the door.
• Place the opener carton in either sensor is misaligned or obstructed). Increase the DOWN limit...
3280 Manual - Page 26
... 10 seconds until completely closed. NEVER use emergency release handle unless garage doorway is activated. Safety reversal system MUST be tested.
11. Garage door MUST reverse on contact with up to pull garage door open . 2. If open door falling rapidly and/or unexpectedly.
7. If closing , the door will open or closed , it will operate with 1-1/2" high (3.8 cm) high object (or...
3280 Manual - Page 29
... following the programming instructions. This feature activates the light on my motor unit: The safety reversing sensor must be connected and aligned correctly before the garage door opener will still not activate your door control is approximately 1-1/4" (3.18 cm) in length.
• If the trolley does not move in particular can affect...
3280 Manual - Page 30
...-diagnostic capabilities. Bell Wire
Diagnostics Located On Motor Unit
Installed Safety Reversing
Sensor
Safety Reversing Sensor
Diagnostic Chart
LED or Diagnostic LED
"Learn" Button
Your garage door opener is overheated. The "Learn" button/diagnostic LED will not operate replace logic board.
the motor unit does not operate or trolley is stuck on...
3280 Manual - Page 31
... non-rolling code transmitter to circumvent that you wish to operate with a non-rolling code transmitter, the technical measure in the garage door opener does not authorize the purchaser or supplier of the garage door opener, which provides security against code-theft devices, will be circumvented. All previous codes are not installed, two clicks will be...
3280 Manual - Page 32
... will work , press the number of openings, remember that the test has used to close the door even after it may authorize access by pressing only the ENTER button if the one button close feature has been activated.
The keypad will blink twice when the one button close is already mounted outside the garage.
1.
3280 Manual - Page 35
... sensor installation onto the wall or floor.
395LM
Remote Light Control:
Enables homeowner to protect LiftMaster® garage door openers against damage from anywhere in the garage.
990LM 373W
Surge Protector: The Garage Door Opener Surge Protector is open garage door manually from outside by disengaging trolley.
370LM
3-Button Mini-Remote Control with Security✚®:
With...
Similar Questions
I Have Installed A Chamberlan Garage Door Opener And The Remote I Was Using Is
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
(Posted by donweera42 9 months ago)
Garage Door Opens After Shutting.
My Lift master 8550 inside keypad is Inside wall pad is model #880LM. outside keypad Model # is 877M...
My Lift master 8550 inside keypad is Inside wall pad is model #880LM. outside keypad Model # is 877M...
(Posted by BONNIECA92 2 years ago)
I Have A Chamberlain Liftmaster 3280 Belt Drive. I Need A Screw Drive Door Opene
(Posted by apimpin8ntez 9 years ago)
Changing Code On The Liftmaster Garage Door Opener
Someone in our area has the same code . We need to change the code on the liftmaster and them recode...
Someone in our area has the same code . We need to change the code on the liftmaster and them recode...
(Posted by reptak 9 years ago)
My Garage Door Opener Beeps And Says Low Battery. What Do I Do?
(Posted by afschip 10 years ago)