LiftMaster 3265 Support Question
LiftMaster 3265 Support Question
Find answers below for this question about LiftMaster 3265.Need a LiftMaster 3265 manual? We have 1 online manual for this item!
Question posted by sportifman33 on November 16th, 2012
Question About My Model Of Garage Door
Hi i have the book for liftmaster modeles 377lm, 377lmc, 315 mhz security + , but i don't know wath is the specific model , where i can see this ????
Current Answers
Related LiftMaster 3265 Manual Pages
3265M Manual - Page 1
.... 845 Larch Avenue
Elmhurst, Illinois 60126-1196 www.liftmaster.com
®
GARAGE DOOR OPENER Models 3265M 1/2 HP
3265M-267 1/2 HP
For Residential Use Only
Owner's Manual
■ Please read this manual and the enclosed safety materials carefully! ■ Fasten the manual near the garage door after installation. ■ The door WILL NOT CLOSE unless the Protector System®...
3265M Manual - Page 2
... 34
Accessories
35
Repair Parts and Service
Back Page
Warranty
Back Page
INTRODUCTION
Safety Symbol and Signal Word Review
This garage door opener has been designed and tested to your garage door and/or the garage door opener if you do not comply with the warnings that accompany it is installed, operated, maintained and tested in strict accordance...
3265M Manual - Page 3
..., pulleys, brackets or their hardware, ALL of balance. If your garage door is balanced and is out of which are under EXTREME tension.
• Disable ALL locks and remove ALL ropes connected to garage door BEFORE installing and operating garage door opener to avoid entanglement.
Preparing your garage door
Before you begin:
• Disable locks.
• Remove any binding...
3265M Manual - Page 5
... listed below . Carton Inventory
Your garage door opener is packaged in the foam. Parts may be stuck in two cartons which contain the motor unit and all parts illustrated below . LOCK LIGHT
Multi-Function Door Control Panel
SECURITY✚® Keyless Entry Model 3265M-267 Only
SECURITY✚® 3-Button Remote Control Model 3265M (1) Model 3265M-267 (2)
Chain
Sprocket...
3265M Manual - Page 6
... only the bolt previously removed from motor unit!
• Tighten both bolts securely through the rail into the motor unit as shown.
• Install the sprocket cover: Insert the back tab in the slot. To avoid SERIOUS damage to garage door opener, use ONLY those bolts/fasteners mounted in the top of the washered...
3265M Manual - Page 7
....
11. Check for proper tension and readjust chain if necessary. ALL repairs to secure the adjustment. NEVER wear watches, rings or loose clothing while installing or servicing opener. This is too loose.
NEVER connect garage door opener to power source until instructed to avoid entanglement.
5. Upon completion of SEVERE INJURY or DEATH:
1. Sprocket noise can...
3265M Manual - Page 10
... Header Bracket
• Position the opener on top section of door.
ENGAGED
Trolley Release Arm RELEASED
ONE-PIECE DOOR WITHOUT TRACK
A 2x4 on its side on the trolley release arm to garage door, rest garage door opener rail on 2x4 placed on the garage floor below the header bracket. SECTIONAL DOOR OR ONE-PIECE DOOR WITH TRACK
A 2x4 laid fl...
3265M Manual - Page 11
... with 5/16"-18x7/8" hex bolts, lock washers and nuts.
6. Measure the distance from a falling garage door opener, fasten it securely to structural supports of the hanging bracket to a support with the header bracket if the bracket is centered over the door (or in the structural supports.
4. To avoid possible SERIOUS INJURY from each bracket to...
3265M Manual - Page 13
... connected.
To prevent damage to cut the rope, heat seal the cut end with an overhand knot. Secure with a Garage Door Opener bulb.
• Use A19, standard neck garage door opener bulbs for approximately 4-1/2 minutes when power is necessary to the opener: • DO NOT use bulbs larger than 100W. • ONLY use A19 size bulbs.
100 Watt...
3265M Manual - Page 14
If the plug doesn't fit into a grounding type outlet. RIGHT
WRONG
PERMANENT WIRING CONNECTION
If permanent wiring is required by your garage door opener has a grounding type plug with ALL local electrical and building codes.
• NEVER use an extension cord, 2-wire adapter, or change plug in ANY way ...
3265M Manual - Page 15
...securely fastened to avoid drilling extra holes in masonry if repositioning is NOT connected to the receiving eye (with an amber indicator light) transmits an invisible light beam to the garage door opener...®
The safety reversing sensor must be connected and aligned correctly before the garage door opener will detect an obstacle in the path of its electronic beam. IMPORTANT INFORMATION ...
3265M Manual - Page 17
...reversing sensor wires and strip 7/16 inch (11 mm) of insulation from both sensors to the garage door opener. MOUNTING AND WIRING THE SAFETY REVERSING SENSORS
Mounting:
• Slide a 1/4"-20x1/2" carriage bolt...Figure 5).
• Finger tighten the wing nuts. Pre-Wired Installation:
If your garage already has wires installed for the safety reversing sensors, follow the instructions below:
•...
3265M Manual - Page 18
... wires sufficiently to connect to Quick-Connect Terminals
Bell Wire
1. The sending eye amber indicator light will glow regardless of wires. Connect to garage door opener:
• Strip 7/16" (11 mm) of insulation from each set of alignment or obstruction. Insert wires into quick-connect holes: white to white and white...
3265M Manual - Page 23
... release handle. See Adjustment Step 2.
23 If your door passes both of garage door travel limits
will interfere with the door's upward travel, it will stop when moving up travel...safety reversal system, persons (particularly small children) could be sure fully open and close ) force. Manually open door provides adequate clearance.
See Troubleshooting, page 18. ADJUSTMENT STEP 1
Adjust...
3265M Manual - Page 24
..., the safety reversal system MUST be SERIOUSLY INJURED or KILLED by turning the control clockwise. If the forces are located on garage door will stop , DECREASE UP (open and close ) force by a closing garage door.
• Too much force on the back panel of a complete turn. HOW AND WHEN TO ADJUST THE FORCES
1. If the...
3265M Manual - Page 25
...;at )
ADJUSTMENT STEP 4
Test The Protector System®
• Press the remote control push button to open the door.
• Place the opener carton in either sensor is off (alerting you to or adjustment of the opener. The garage door opener will flash. Safety Reversing Sensor 25
Safety Reversing Sensor Increase the DOWN limit by a closing...
3265M Manual - Page 26
... on ,
4. OPERATION
IMPORTANT SAFETY INSTRUCTIONS
WARNING
To reduce the risk of children. ALWAYS KEEP GARAGE DOOR PROPERLY BALANCED (see page 3). An improperly balanced door may be seen clearly, it must be tested every month. Using Your Garage Door Opener
6. Your Security✚® opener and hand-held remote. If you purchase a new remote, or if you can be...
3265M Manual - Page 27
... handle straight down and back (toward the opener). The trolley
LOCKOUT POSITION
will open or close the door.
After the opener lights flash, release all buttons. To Open the Door Manually
Lock feature
Designed to prevent operation of the door from a falling garage door:
• If possible, use handle to pull door open the door with the 3-Button
hand-held remote...
3265M Manual - Page 28
... a small layer of operation. To replace battery, use the visor clip or screwdriver blade to wipe away the existing grease from the garage door opener rail. Insert battery positive side up (+)
Dispose of limits or force. Care of Your Opener
LIMIT AND FORCE ADJUSTMENTS:
Weather conditions may cause FORCE CONTROLS some minor changes in...
3265M Manual - Page 29
..., Light Feature.
6. If the trolley re-engages with a security light feature. Refer to disengage.
• Decrease the UP travel limits. This feature activates the light on my motor unit: The safety reversing sensor must be connected and aligned correctly before the garage door opener will not close and the light bulbs blink on when...
Similar Questions
I Have Installed A Chamberlan Garage Door Opener And The Remote I Was Using Is
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
(Posted by donweera42 8 months ago)
I Need A Replacement Lens Cover For Garage Door Opener Liftmaster Model #1355- 1
I need a replacement Lens Cover for a garage door opener Model # 1355M- 1/2 HP Liftmaste
I need a replacement Lens Cover for a garage door opener Model # 1355M- 1/2 HP Liftmaste
(Posted by nskanson 1 year ago)
Garage Door Opens After Shutting.
My Lift master 8550 inside keypad is Inside wall pad is model #880LM. outside keypad Model # is 877M...
My Lift master 8550 inside keypad is Inside wall pad is model #880LM. outside keypad Model # is 877M...
(Posted by BONNIECA92 2 years ago)
Noise From Garage Door Opener
I have a liftmaster garage door opener. It makes a loud screeching noise when the door is lowered....
I have a liftmaster garage door opener. It makes a loud screeching noise when the door is lowered....
(Posted by tom19097 11 years ago)
Chamberlin Liftmaster Garage Door Opener Model # 3265-267
Where do I put the trolley before I attach the chain to the sprocket?
Where do I put the trolley before I attach the chain to the sprocket?
(Posted by garretmegan 11 years ago)