LG WM2277HB Support Question
LG WM2277HB Support Question
Find answers below for this question about LG WM2277HB.Need a LG WM2277HB manual? We have 1 online manual for this item!
Question posted by Jdouglas11 on March 4th, 2018
My Washer Continues To Cycle When The Pause Button Is Depressed.
My washer contuse to cycle after I depress the pause button, and always spins on high even when its on low.
Current Answers
Answer #1: Posted by Odin on March 4th, 2018 5:31 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,710
Member since:
April 10th, 2010 Points: 41,236,710
See SPIN TROUBLE at https://www.manualslib.com/manual/409128/Lg-Wd-11270bd.html?page=32#manual. If you need professional help, you can get a referral from LG: use the contact information here--https://www.contacthelp.com/lg/customer-service.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related LG WM2277HB Manual Pages
Service Manual - Page 4
...steps (by sensor)
LAUNDRY LOAD SENSING
Incorporated
ERROR DIAGNOSIS
Incorporated
AUTO POWER OFF
Incorporated
CHILD LOCK
Incorporated
RLM ENABLE
Incorporated
-
3 1. REVOLUTION SPEED CYCLES
WASH SPIN
0-1320 rpm 9
42 rpm 0-1100 rpm
7
0-1000 rpm
WASH/RINSE TEMPERATURES
5
SPIN SPEEDS
5
OPTIONS
Prewash, Stain Cycle, Quick Cycle, Extra Rinse, Rinse+Spin, Delay Wash
CUSTOM PROGRAM...
Service Manual - Page 5
...washer and/or dryer. Tilted Drum and Extra Large Door Opening
Tilted drum and extra large door opening make it possible to enhance washing performance while maintaining fabric care. Automatic Wash Load Detection
Automatically detects the load and optimizes the washing time. Using the RLM (Remote Laundry...unit into any buttons to change the settings during the wash cycle. FEATURES
Direct Drive...
Service Manual - Page 6
... best washing performance, optimal time is determined by pulling the door handle whenever washer is locked/unlocked.
5 Spinning does not proceed until the water in the tub. The water supply is completed...water temperature, the selected washing temperature, and the size of the load. When the cycle is stopped when the water level reaches the preset level, the washing program then proceeds....
Service Manual - Page 7
... THE DOOR CAN NOT BE OPENED
While program is operating When a power failed and power plug is paused.
2-6. When Rinsing, it is lower than 40 °C)
2-7. 2-5. You can be canceled when the...buttons are disabled except the Power button. DOOR LOCKED LAMP LIGHTS
When the frequency of shower at first rinse.
6 When Child lock is not 25.5 kHz (It can lock the washer while it continuously...
Service Manual - Page 10
....
HOW TO CONNECT THE INLET HOSE
Verify that the hose is inside of the valve connector. CONNECT THE DRAIN HOSE
Make sure that the rubber washer is not twisted.
The end of the hose. CONNECT POWER PLUG
Connect the power plug to prevent leaks. Avoid connecting several electric devices, as doing...
Service Manual - Page 11
... the door is unlocking.
Listen for a click to the outlet. Connect the inlet hoses.
Press the START/PAUSE button. Press the Start/Pause button. If SVC is supplied through the detergent dispenser. Listen for washing. Check the drain and spin functions.
TEST OPERATION
Preparation for a click to determine if the door has locked.
Check the...
Service Manual - Page 13
.../Pause . b
• P
12
o
The Custom Program is set, C buttons are disabled exc can lock the washer whil
• Rotate the Cycle selector knob to select the cycle...button to Start/ Stop the washer.
• Allows you to turn the power On/Off.
• This display shows:
a) the estimated time remaining in the cycle when operating.
l
2) Select the other desired Wash/Rinse Temp., Spin...
Service Manual - Page 14
... ept the Power button. Automatically provides a rinse. • Quick Cycle: The Quick cycle offers a quick cycle time.
To change the soil level, press the Soil Level button repeatedly until the desired setting is locked.
• The door can be unlocked by pressing the Start/Pause button to stop the washer.
nt unwanted use of the washer is on the...
Service Manual - Page 18
...times the Start/Pause button is plugged in the off all lamps and locks the door.
1 time
Tumble clockwise.
2 times
Low speed Spin.
3 times
High speed Spin.
4 times
...SPIN SPEED and SOIL LEVEL buttons simultaneously. 2.
The voltage of electric shock when disconnecting parts while troubleshooting. Press the Start/Pause button repeatedly to cycle through the test modes. 7. The washer...
Service Manual - Page 19
ERROR DISPLAY
If you press the START/PAUSE button when an error is displayed, the drain pump will go into the drum.
• Not fully ...reach the preset water level within 25 minutes.
• The load is too small. • The appliance is tilted. • Laundry is gathered to
drain the water automatically.
• The SENSOR SWITCH ASSEMBLY is out of order.
• Door not all the ...
Service Manual - Page 20
Displayed only when the START/PAUSE button is out of order. Displayed only when the START/PAUSE button is first pressed in the QC Test Mode.
• EEPROM is first pressed in the MAIN PWB ASSEMBLY is bad or unstable.
•...(3-pin, male, white) in the MOTOR HARNESS and 4-pin, female, white connector in the QC Test Mode.
12
POWER
FAILURE
• The washer experienced a power failure.
19
Service Manual - Page 23
... detergent used as drain, water input, pause will operate, without rotating the drum.
Is liquid laundry product put in . Clean the compartment. LOW-SUDSING
This appliance has an automatic suds sensing function which prevents overflow.
SYMPTOM
Suds overflow from the appliance. (In this condition, wash and spin do not flow in the correct compartment...
Service Manual - Page 25
... perfectly level as follows:
Check the leveling of drum and start /pause button in high spin (Refer to 3 kg) of the washer. Put an unbalance part (rubber) inside of the washer with a Level and check that the washer is not stable, adjust feet accordingly. If you do not have the unbalance part, put 4.5 to 6.5 lbs (2 to section...
Service Manual - Page 26
... drum.
2) Start the QC test mode (Refer to section 7-2).
3) Press Delay Wash button, then '
' is displayed.
4) Press the Spin Speed button repeatedly to select Extra High.
5) Press the Quick Cycle button, the spin speed is displayed.
6) Press the Start/Pause button.
7) Press the Beeper button repeatedly to set spin speed (600, 900, 1020, 1120 rpm) and check if there is vibration...
Service Manual - Page 27
... INLET VALVE ASSEMBLY?
Check the AIR CHAMBER and the tube (clogged).
Is the detergent caked or hardened?
NO
YES
When you press both SPIN SPEED button and SOIL LEVEL button simultaneously, is 120 V AC. (Refer to the
NO
terminals of the inlet valve connector is the water YES level frequency below 246? Replace...
Service Manual - Page 29
...
Is the connector disconnected, disassembled?
When checking voltage between connectors during NO
spin, is the water level
frequency between two pins while pressing the POWER button.
YES Remove foreign material.
NO
Is the coil of the drain pump too high or low? (resistance of the drain pump clogged?
YES
Replace the SENSOR SWITCH ASSEMBLY...
Service Manual - Page 30
WASH HEATER TROUBLE
HEATING CONTINUOUSLY ABOVE THE SETTING WATER TEMPERATURE
Extra Hot: 70 °C 25
(1)
When checking the THERMISTOR on the tub, is the THERMISTOR loose?
29
Push the THERMISTOR tightly to the rubber.
Service Manual - Page 31
... repair the connector. Connector
NO
Is the coil of the right side of the drain pump clogged?
NO
When checking voltage between the
connectors during spin, is 18-30 Ω)
YES
Replace PUMP MOTOR ASSEMBLY.
WILL NOT CIRCULATE WATER
Is the impeller of drain pump open or short circuited? (Coil R is...
Service Manual - Page 32
Press the START/PAUSE button 2 times in QC Test mode, is pressed to start the cycle?
(Red 3 pin, Yellow 4 pin and
(1)
white 3 pin connector (1)). Check the ...twice when the
ASSEMBLY Connector and MAIN PWB ASSEMBLY
START/PAUSE button is the drum spinning at low speed? If the problem is 248 or more.
(1) (2)
SPIN TROUBLE
Check during spin if the frequency of the water level is on the ...
Service Manual - Page 47
... the safety precautions in this manual
¡Æ NOTE : S(Safety Parts), AL(Alternative parts)
LG MODEL: WD-11275BD.ABPEEUS
Run_Date : 2004-04-09
YOUR MODEL: WM2277HB
SPECIFICATION: 120V 60Hz
S AL LOC
DESCRIPTION
PARTS No.
LG Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Washing Machine: Unit is making noise - LG Consumer Knowledge Base
... such as buttons, clips, zippers etc could clank or scrape against the back of the stainless steel drum and cause noise. During the spin cycle as the water is drained sound comes from clothes before loading the washing machine This sound occurs when the drum reaches a high spin speed for on my LG washer Water... -
Washing Machine: Spin issues - LG Consumer Knowledge Base
... wetter. Does water remain inside after a cycle, or is the case, choose a higher spin speed to washing laundry. This is because the washer is designed to retain more water. Turn on a higher spin speed. If by mistake, a low spin speed was selected and the cycle has finished, a spin only can be replaced by the customer? Article... -
How to use your Air Conditioner features - LG Consumer Knowledge Base
The MODE operation selection button is used to run continuous cycles on the temperature setting selected. The OFF and ON timer button is used to set . The speed can be set and reset the timer for a long period of the cover with the prongs snaps in the ...
Similar Questions
Our Start/pause Button Isn't Starting Any Wash Load;please Help!
Lg steam washer model: WM2688HNMA. Over the past few weeks, it has been taking several pushes of the...
Lg steam washer model: WM2688HNMA. Over the past few weeks, it has been taking several pushes of the...
(Posted by mkparents1 9 years ago)
I Purchased A Pedestal For Old Lg Washer Wm2277hb, Doesn't Work. Any Suggestions
I just purchased a pedestal WDP4W to use on my old LG washer WM2277HB. However, my washer doesnt hav...
I just purchased a pedestal WDP4W to use on my old LG washer WM2277HB. However, my washer doesnt hav...
(Posted by mrettig 10 years ago)
Lg Front Loader Washer Wm0642hw Will Not Rotate Or Spin
(Posted by yourswhite 10 years ago)
