Kenwood KDC-X995 Support Question
Find answers below for this question about Kenwood KDC-X995.Need a Kenwood KDC-X995 manual? We have 2 online manuals for this item!
Question posted by aplushandymanserv on October 1st, 2021
No Display
Current Answers
Answer #1: Posted by techyagent on October 1st, 2021 6:52 PM
2 screws holding it in at the front corners at the bottom of the CD deck. Use a number 2 phillips and take out the gold screws holding the CD deck in place. Then you can pull out the CD deck, and be careful not to damage the ribbon cable connected from the CD deck to the main board. The deck can just sit up and over to the left to get it out of the way for what needs to be soldered.
Thanks
Look inside the main unit on the board and you will see in the front right corner a series of surface mount resistors all connected in series. Just reflow that solder on them with a small amount of new solder added and the display will once again work perfectly. That solder is very heat stressed, that is the problem. I have fixed dozens of these over the last few years. Make sure you put it back together the same as it came apart, and you are done.
Techygirl
Related Kenwood KDC-X995 Manual Pages
Similar Questions
The Message Protect show`s up on the KDC-X395 system. Nothing will work on it. Had it sense 2011.Ken...
How do I unlock the Protection code on my Kenwood KDC-MP 342U car radio???? I am not able to downloa...
Auxiliary output makes connection on galaxy s3 but doesn't register on kdc-x995