Won't Turn On Stays On Stand By

Check that:

R26;

The speaker system's impedance is not too low. See Chapter One of

the Connections and Setup Guide.

R26;

The speaker wires are not short-circuited. Test the wires as follows to

find the shorted wire and replace it:

1 Turn off the receiver, disconnect the positive and negative speaker

wires of the RIGHT FRONT speaker from the receiver, and turn

the receiver back on.

2 If the STANDBY indicator stops flashing, replace this wire.

3 If the STANDBY indicator does not stop flashing, turn off the re-

ceiver, reconnect the speaker wires, and repeat the first step for the

next speaker.

4 Continue until you have isolated and replaced the shortedwire.

5 See Chapter One of the Connections and Setup Guide.

If none of the above solutions work, reset the microprocessor:

1. Turn the receiver off. (The Power button is OFF position.)

2. Press ON/STANDBY button while pressing and holding the Power

button.

The following settings are cleared:

R26; The device set as input (Tuner is selected by default)-see "How

Do I Operate Devices?" on page 35 of this manual.

R26; The volume setting (-48dB is selected by default)-see "Adjusting

the Volume" on page 11 of this manual.

R26; The tuner's receiving band (FM is selected by default)- see "Tuner"

on page 57 of this manual.

R26; The tuner's frequency (87.5MHz is selected by default)- see

"Tuner" on page 57 of this manual

R26; The tuner's preset memory-you will need to reset your stored

radio stations (see Chapter Two of the Connections and Setup Guide