Kenmore 2718 Support Question
Kenmore 2718 Support Question
Find answers below for this question about Kenmore 2718 - High Efficiency 3.1 cu. Ft. Capacity Coin Op Front Load Washer.Need a Kenmore 2718 manual? We have 1 online manual for this item!
Question posted by knordan on May 28th, 2011
Washer Machine Won't Turn On!
We have a Kenmore 2718 coin-op, it consistently will work then not. We've been told to hold the on button for a few extra seconds as it requires time to reset. Did this..nothing. Checked the electrical outlet..working...Checked the balance....balanced...Checked hoses, any clogs, detergent compartments...nothing. What next?
Current Answers
Related Kenmore 2718 Manual Pages
Use and Care Guide - Page 1
Operated Commercial Tumble Action Washer
PIN 134837400A (0703)
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A. www.sears.com
Coin-
Use and Care Guide - Page 2
... are not followed. Purchase date
Record Coin Box Key Number Key number is very important. Installation
_Tlnis is call your Kenmore
installation for future reference. All safety messages... Requirements 4 Electrical Requirements 4 Grounding Requirements 4 Water Supply Requirements 4 Drain Requirements 4 Location Of Your Washer 4
Unpacking 6 Installation 7
Replacement Parts 8 Coin ...
Use and Care Guide - Page 3
... give off during this time. do not reach into a properly
grounded and polarized 3-prong outlet. Keep laundry products out of the washer must never be exposed to...the washer. This will
automatically restart after the washer is used for play on previous page. Failure to persons when using the washer, turn on all appliances. Follow instructions on or in I load ...
Use and Care Guide - Page 4
...Fault Interrupter) receptacle is not recommended. Check with gravity drain:
1. The washer MUST be :
ELECTRICAL REQUIREMENTS
CIRCUIT-Individual, properly polarized and grounded 15 amp. Models equipped with a ...in. time delay fuse or circuit breaker.
OUTLETRECEPTACLE- NOTE:
Drain hose attached to have a licensed electrician replace it will reduce the risk of your washer is ...
Use and Care Guide - Page 6
... supply cord to be transported at a later date, the shipping support hardware must be removed). Remove the following from the front of the washer.
8. From the rear of the washer:
3 bolts, 3 yellow plastic spacers, 2 or 3 metal "P" clamps.
/ // /
g. Removethe styrofoam base.
7. Remove and discard the yellow ribbon and label from the back side...
Use and Care Guide - Page 7
... marked "HOT" to lift washer.
. Do not accessible through a complete cycle. NOTE:
tighten another 2/3 turn with
the hose pointed toward the drain.
9. On machines equipped with pliers.
Plug the... drain hose in a laundry tub or a standpipe and secure
COLD water faucets tightly by hand, then tighten another 2/3 turn with a wrench.
. Tighten more the washer will insure that might ...
Use and Care Guide - Page 8
... and a 5/8-in place, guide the coin slide mechanism onto the threads and into place.
6. Turn coin slide mechanism upside down. Deposit coins in the front of the meter case....holding the bolt in . FIGURE 2
/
Slide Return Spring
STEP3 Remove coin slide from meter case (see FIGURE 2). Note: If the slide mechanism has already been installed, skip this step. Remove the access panel from coin...
Use and Care Guide - Page 9
...FIGURE 6):
block from coin receiver block.
FIGURE 4
STEP4 Turn coin slide upside down and remove screw that holds coin receiver block (see FIGURE B).
(1) Receiver Block Screw
FIGURE 5
Spare Parts Compartment
and Screw
STEP5 Remove coin receiver (see FIGURE4).
Keep coin receiver block in place with your fingers. Carefully lift coin slide from coin slide
Turn coin slide right side up...
Use and Care Guide - Page 10
... in if the anti-cheat gate in place with your washer, call 1-800-221-0982, Greenwald Industries. Reinsert and tighten mounting screws.
• Replace coin chute cover. REPLACEMENT PARTS
Block Screws
(2) Coin Sizing_
Coin Sizing Block
• Remove two screws that hold coin sizing block to upper coin chute cover cover (see FIGURE8). To remove block-out...
Use and Care Guide - Page 11
...32x5/16 SEMS SCREW MOUNTING BRACKET MOUNTING BRACKET
CABLE TIE GROUND WIRE
WASHER
Lift Adjusting Tab away from 1 to machine. Make sure Tab\ locks into cam notch (Fig. 1).
3. Reconnect power to 2. Turn Shaft & Cam Assembly in new
position.
4. ADJUSTMENT TAB
LEVERARM
... SC. Meter Case Instructions
INSTRUCTIONS TO CHANGE THE NUMBER OF COIN SLIDE INSERTIONS TO START APPLIANCE.
1.
Use and Care Guide - Page 12
... 20-1012
33 MAGNET
Opt. 00-9256
34 SHIELD
Opt. 20-2045
35 COIN RECEIVER BLOCK
1 .........
20-1012 00-9256 20-2045 20-2003
37 LOCK WASHER 38 SCREW (METRIC) 3c SCREW (METRIC) 4C SCREW 41 TOP HOUSING ASMY
...SHAFT
1 20-4004 20-4000
DECAL,CASTING
1 00-9905 00-9905
BODY CASTING
1 20-3020 20-3000
COIN SLIDE
1 20-3021
DECAL, SLIDE
1 00-9104 00-9104
CHUTE LOCATING SCREW 4 00-7483 61-55
...
Use and Care Guide - Page 13
...you may also have other rights which vary from the date of purchase, when the washer is in use in the Installation Instructions/Use & Care Guide, Sears will be ... warranty applies only while this tear-off. Existing Vend Price
Name
The coin chute has been pre-set at no extra parts required.
You will furnish replacement parts for labor. Quantity. Follow product information instructions...
Similar Questions
No Cold Water
I have a Kenmore 2982 - 800 4.0 cu. Ft. Capacity top-load Washer bought in 2009. All of a sudden, it...
I have a Kenmore 2982 - 800 4.0 cu. Ft. Capacity top-load Washer bought in 2009. All of a sudden, it...
(Posted by jethalhuber 9 months ago)
Kenmore Coin Operated Washer 27182 Does Not Start
(Posted by ctsdrman 9 years ago)
How Come The Clothes In The Washer Not Dry?
(Posted by Anonymous-109447 11 years ago)
Reset Button
Someone went inside the machine to do a free load of wash. They clicked the lever too many times and...
Someone went inside the machine to do a free load of wash. They clicked the lever too many times and...
(Posted by siko44 12 years ago)