2006 Infiniti FX35 Support Question
2006 Infiniti FX35 Support Question
Find answers below for this question about 2006 Infiniti FX35.Need a 2006 Infiniti FX35 manual? We have 1 online manual for this item!
Question posted by coshylto on March 15th, 2014
Where Is Shift Lock Overide On Fx35
The person who posted this question about this Infiniti automobile did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Manual Pages
Owner's Manual - Page 6
... - Remote keyless entry system - Intelligent Key (if so equipped) 12. Rear window wiper (P.8-23) 14. Rear combination light (P.8-33) 15. Child safety locks (P.3-5)
SSI0012A
0-2 Illustrated table of contents Headlight (P.2-21) and turn signal switch
3. Mirrors (P.3-30) 11. Windshield (P.8-21) 5. Tires - Wheel and tires (P.8-35, 9-10) - Flat tire (P.6-2) 10. ...
Owner's Manual - Page 15
... not be securely stored to attach the rear center seat belt connector. In a sudden stop .
This can be sure to prevent them from sliding or shifting. Do not unfasten the rear center seat belt connector except when folding down the rear seat. If the rear center seat belt connector and the...
Owner's Manual - Page 16
... 1 and push the head restraint down.
You could be thrown into it is securely locked.
you could also slide under the lap belt and receive serious internal injuries.
Check the adjustment after someone else uses the seat.
1-6 Safety - Seats, seat ...
Owner's Manual - Page 23
...should be upright. Adjust the seat. For the most effective protection when the vehicle is designed to lock during a sudden stop or on the hips as shown. 4. See "Seats" earlier in the seat... pull the belt out of the retractor. 3. The front passenger and rear seat belts have a locking mechanism for child re-
SSS0291A
Safety - Seats, seat belts and supplemental restraint system 1-13 Be ...
Owner's Manual - Page 24
... system It can also change the operation of the front passenger air bag. The retractor should lock and restrict further belt movement. WARNING
When fastening the seat belts, be injured in the latched... later in the seat belts, check the operation as the automatic locking mode.
It is activated it is referred to lock belt movement using two separate methods: when the belt is detached ...
Owner's Manual - Page 25
Release the adjustment button to the position best for you . The shoulder belt anchor height should be adjusted to lock the shoulder belt anchor into position.
Safety - Seats, seat belts and supplemental restraint system 1-15
The belt should be away from your shoulder. REAR CENTER ...
Owner's Manual - Page 31
...The restraint could tip over or otherwise be unsecured and cause injury to use the automatic locking mode will result in a rear outboard or center seat, follow the child restraint manufacturer... restraint to install the head restraint when the child restraint is interfering with an automatic locking mode retractor which must be secured.
Always follow these steps: 1. The back of ...
Owner's Manual - Page 32
... this time, the belt retractor is in the belt.
1-22 Safety - Seats, seat belts and supplemental restraint system Pull on the shoulder belt to emergency locking mode when the belt is fully extended. Pull up on the shoulder belt until you hear and feel the latch engage. Be sure to retract...
Owner's Manual - Page 33
... that the child restraint is in place. If the belt is securely held in the automatic locking mode by trying to another rear seating position and try again, or try a different child ...After the child restraint is removed and the seat belt is in all child restraints fit in the automatic locking mode. 7. Rear facing
Rear outboard seat
SSS0357
When you cannot pull any more than 1 inch (...
Owner's Manual - Page 34
... seat belt tongue through the child restraint and insert it into the buckle until all of the belt is fully extended. Be sure to emergency locking mode when the belt is in the automatic locking mode (child restraint mode). Pull on the shoulder belt until you hear and feel the latch engage.
Owner's Manual - Page 35
...restraint is removed and the seat belt is allowed to wind back into the retractor, the automatic locking mode (child restraint mode) is properly secured prior to each use force to push the child ...side to side, and tug it forward to make sure that the retractor is in the automatic locking mode by trying to further tighten the child restraint. Allow the seat belt to another rear seating...
Owner's Manual - Page 37
... the anchor attachments to the anchors, and then return the seatback to be secured properly if the LATCH system anchors are they to its normal, locked position. The child restraint will not be used for installation instructions. 2.
Owner's Manual - Page 130
... you turn it is pushed in the "5. For important safety information, see "Ignition switch" in , and turned to the LOCK position unless the shift lever is in P position. (It can be locked in the A position. LOCK (Normal parking position)
A B
range
:
The ignition switch can only be turned to the ON position. It will be...
Owner's Manual - Page 132
...Key may be sure to observe the following: Shift the selector lever to P. (In other positions, the ignition switch will not return to LOCK.) Securely return the ignition switch to severe ...corner pieces 31.5 in the outside the vehicle.
Set the parking brake. Failure to do so could lead to LOCK. If the Intelligent Key is in the operating range, it is shown in the illustration.
1 2 3
...
Owner's Manual - Page 170
... because a wide-angle lens is shifted into the R (Reverse) position, the monitor display shows view to do so before backing up. Select the "Intelligent Key lock response - Sound" key, then push...appear when selecting the "Language/Unit" key and pushing the ENTER " " button. Intelligent Key Lock Response - Sound (if so equipped): The sound pattern of the vehicle. Always turn and check...
Owner's Manual - Page 231
... from the registered key.
Visually inspect tires for example, each time you check engine oil. Lock all windows and lights are clean. It will not allow the engine to start , INFINITI ... Turn the ignition switch to do likewise. If this procedure allows the engine to the LOCK position unless the shift lever is in P position. (It can discharge the battery. Starting and driving 5-13...
Owner's Manual - Page 233
... cause a loss of control. Push the button to R (Reverse), N (Neutral), D (Drive), or Manual shift mode position. Starting and driving 5-15 Release the parking brake and foot brake, then gradually start the vehicle in...cause you to the LOCK, OFF or ACC position or if the key is moving rearward. Always depress the brake pedal until shifting is high, so use caution when shifting into a forward or ...
Owner's Manual - Page 234
... parking brake if the selector lever is in any position while the engine is completely stopped. Make sure the vehicle is not running.
You may shift to LOCK. M3
(3rd) and M2 (2nd):
Use for maximum engine braking on a hill, apply the parking brake first, then move unexpectedly or roll away and...
Owner's Manual - Page 235
..., move the selector lever, apply the parking brake, depress the brake pedal, and push the shift lock release button.
SSD0540
Shift lock release
If the battery charge is rapidly done, the second shifting may not be moved to the floor. Starting and driving 5-17 To move the selector lever to the + (up to its normal...
Owner's Manual - Page 382
... security system ...2-18 Selector lever, Shift lock release...5-17 Servicing air conditioner ...4-21, 4-24 Shift lock release, Transmission ...5-17 Shifting Automatic transmission...5-14 Shoulder belt height ...automatic transmission models ...5-14 Lane departure warning (LDW) system...2-30 Power door lock switch...3-4 Rear window and outside mirror defroster switch...2-23 Snow mode switch ...2-31...
