Husqvarna YT48CS Support Question
Husqvarna YT48CS Support Question
Find answers below for this question about Husqvarna YT48CS.Need a Husqvarna YT48CS manual? We have 1 online manual for this item!
Question posted by Anonymous-169810 on November 11th, 2021
Tractor Moving Slow Going Forward But Normal In Reverse
when transporting or mowing, my lawn tractor is moving slow despite throttle placement (high or low), however moves normal while in reverse.
Current Answers
Answer #1: Posted by SonuKumar on November 13th, 2021 7:18 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,621,300
Member since:
May 9th, 2021 Points: 16,621,300
Why is my riding mower running slow?
Maintenance lapses become evident when the mower turns over slowly or begins to falter at start-up. The fault could be a dirty spark plug, air filter or carburetor, or it could be related to the quality of the gasoline used. Slow starting can also be the result of a failure to clean the blades.
https://homeguides.sfgate.com/mower-engine-turning-over-very-slowly-95004.html
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Answer #2: Posted by itasklive on November 11th, 2021 12:10 PM
itasklive
Member since:
October 21st, 2021 Points: 257,510
Member since:
October 21st, 2021 Points: 257,510
Related Husqvarna YT48CS Manual Pages
Operation Manual - Page 2
...mowing area and in place and working. • Slow down for small children.
• Never carry children, even with specifications of the manufacturer of bystanders before operating a riding lawn mower... other objects that may lose control of the tractor. WARNING: Tow only the attachments that children be picked up , transporting, adjusting or making repairs, always disconnect spark...
Operation Manual - Page 3
...going down the slope. • Keep all slopes requires extreme caution. Operation on all movement on the slopes slow...mow on clothing, change clothing immediately. • Never over accidents, which can hide obstacles. • Choose a low...for weight limits for Ride-On Mowers
III.
GENERAL SERVICE • ... when going uphill, disengage blades, shift into reverse and back down ...
Operation Manual - Page 6
... depressing clutch/brake pedal.
• Place freewheel control in "TRANSMISSION DISENGAGED" position. (See "TO TRANSPORT" in the Service and Adjustments section of this manual.)
• Roll tractor forward off the skid. ASSEMBLY
NOTE: You may now roll your tractor were overinflated at the factory for shipping purposes. CHECK DECK LEVELNESS
For best...
Operation Manual - Page 7
...injury. REVERSE
NEUTRAL
HIGH
LOW
CHOKE
FAST
SLOW
IGNITION SWITCH
ENGINE OFF
ENGINE START
ENGINE ON
DIFFERENTIAL LOCK
CLUTCH/ BRAKE PEDAL
PARKING BRAKE
MOWER HEIGHT
MOWER LIFT
REVERSE REVERSE FORWARD OPERATION ...FREE WHEEL (Automatic Models only)
Failure to the tractor and/or engine. OPERATION
These symbols may appear on your tractor or in serious injury or death. CAUTION when ...
Operation Manual - Page 8
... the mower blades or other powered attachment while in reverse.
(H) LIGHT SWITCH - Used when starting and stopping the engine.
(G) REVERSE OPERATION SYSTEM (ROS) "ON" POSITION -
H
P
Z
D
B
N
E
G
F A
C
J
K
M
L
Fig. 3
Our tractors conform to set forward movement of operation.
(Z) AMMETER - Locks clutch/brake pedal into the brake position.
(D) THROTTLE/CHOKE CONTROL...
Operation Manual - Page 9
....
9
Fig. 4
STOPPING (See Fig. 5)
MOWER BLADES -
• To stop engine when stopping tractor on grass areas.
TO MOVE FORWARD AND BACKWARD (See Fig. 7)
The direction and ... any attempt by the forward and reverse drive pedals. • Start tractor and release parking brake. • Slowly depress forward (K) or reverse (L) drive pedal to move throttle control between half and full...
Operation Manual - Page 10
...mowed. • The average lawn should be mowed twice.
A
Fig. 8 • Put attachment lift lever in height should only be used while mowing or transporting on a flat level surface. • Adjust mower...
• With forward drive pedal depressed to over 6" (152,4 mm) in desired cutting height slot.
Fig. 9
TO OPERATE MOWER
Your tractor is at slow speeds may vary ...
Operation Manual - Page 11
... slope, is dangerous. ROS "ON" POSITION
ENGINE "ON" POSITION (NORMAL OPERATING)
02828
Fig. 11
TO OPERATE ON HILLS
CAUTION: Do not ...mow in the reverse direction with a Reverse Operation System (ROS). TRANSMISSION ENGAGED
TRANSMISSION DISENGAGED
Fig. 12 NOTE: To protect hood from damage when transporting your tractor.
OPERATION
REVERSE OPERATION SYSTEM (ROS) (See Fig. 11)
Your tractor...
Operation Manual - Page 12
...in operating position, depress brake pedal and set parking brake.
• Move attachment clutch to "DISENGAGED" position.
• Move throttle control to gasoline in fuel tank or storage container.
Do not run ...choke control in until
the engine begins to warm up as follows:
• Be sure the tractor is on level ground.
• Release the parking brake and let the brake slowly return ...
Operation Manual - Page 13
...: Never engage or disengage freewheel lever while the engine is running , move throttle control to half (1/2) speed.
Disengage parking brake.
8. Depress forward drive pedal to full forward position, hold for normal operation. Shut- Engage transmission by selecting a low enough gear to the right of your tractor. Make first cut area to give best performance of the...
Operation Manual - Page 15
..." POSITION (NORMAL OPERATING)
Fig. 14
15 If your tractor is in the disengaged position.
Adding or checking level of tires for normal use. To prevent possible damage to seals, do not use high pressure water ...not attempt to open . • Recharge at tires due to slow leaks, tire sealant may cause tire damage. CHECK REVERSE OPERATION (ROS) SYSTEM
• When the engine is suf&#...
Operation Manual - Page 18
...lawn, near
enough to remove grass, leaves and trash from the nozzle washout port.
10.Move the tractor to a dry area, preferably a concrete or paved area.
Turn the water on the tractor,
re-start the engine and place the throttle...CLUTCH/BRAKE PEDAL CLEAN TOP SIDE
STEERING PLATE
STEERING SYSTEM, DASH, FENDER AND MOWER NOT SHOWN
Fig. 25
• Keep finished surfaces and wheels ...
Operation Manual - Page 19
... parking brake lever up and hold tractor secure. TO REMOVE MOWER (See Fig. 27)
• Place attachment clutch in contact with plug. remove retainer
spring and washer. • Go to other side of mower and disconnect mower suspen- remove retainer springs and washers. • Go to either side of mower and disconnect the suspension arm and rear...
Operation Manual - Page 20
... small retainer spring as it is centered under tractor until it will be in
all mower pulley grooves. RIGHT SIDE REAR MOWER BRACKET
S. WASHER
Z. 3/8-16 LOCKNUT
Fig. 30
3. SLIDE MOWER UNDER TRACTOR (See Fig. 32) • Bring belt forward and check belt for anti-sway bar will go and position mower on right side of transaxle.
SERVICE AND...
Operation Manual - Page 21
... Fig. 38)
• Turn steering wheel to position wheels straight forward.
• From front of tractor, insert rod end of front link (E) through front hole in tractor front suspension bracket (F).
• Move to highest position. • If necessary, adjust gauge wheels before operating
mower as - U
C
M
F
G
E
H J
E. REAR LIFT LINK(S) D.
FRONT LINK LOCATION
B A D
A. ATTACH REAR LIFT...
Operation Manual - Page 22
... necessary until you can raise the low side of mower or lower the high side.
• Go to lower the front mower. CAUTION: Blades are sharp. Readjust, if necessary, until both sides. • If adjustment is 1/8 to 1/2" (3,1 to 12,7 mm) lower than the rear tip, go to the front of tractor.
• With an 11/16" or...
Operation Manual - Page 24
...washers to affect the factory set at tires due to slow leaks, tire sealant may also check brake by placing ... you try to manually push the tractor forward. If the rear wheels rotate, ...ALSO BE A 12 VOLT SYSTEM. TO REMOVE CABLES, REVERSE ORDER • BLACK cable first from chassis and... TOE-IN/CAMBER
Your new tractor front wheel toe-in and camber is normal. Contact a qualified...
Operation Manual - Page 25
...8226; Close hood.
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
The throttle control has been preset at sides, tilt toward
engine and lift off of tractor. TO ADJUST CHOKE CONTROL
The choke control... should be necessary.
TO REPLACE FUSE
Replace with terminals in front of tractor. • To replace, reverse above procedure.
Tighten securely. • Connect BLACK grounding cable to run...
Operation Manual - Page 26
... Be sure that does not retain moisture.
WARNING: Never store the tractor with new spark plug(s). When mower is an acceptable alternative in the Maintenance section of fuel gum deposits ...8226; Pour one season to another.
• Replace your gasoline can starts to rust. Inspect moving parts for a few seconds to distribute oil.
• Replace with gasoline in your gasoline will...
Operation Manual - Page 28
.../clean all connections. 3. Move throttle control between half and full speed (fast) position before mowing.
4. CAUTION: DO NOT operate machine until problem is not "ON" 1. Replace blade. Engine speed too slow.
1. Allow grass to open vent holes. Replace alternator. Freewheel control in "disengaged" position. 2.
See
while mower or other attachment is shifted into reverse...
Similar Questions
Husqvarna Riding Lawn Mower Starts, Blade Spins, Won't Go Forward Nor Reverse
(Posted by shywolfalways82 3 years ago)
The Mower Will Not Go Forward Or Backward
the mower will not go forward or backward
the mower will not go forward or backward
(Posted by bigred00 7 years ago)
Won't Go Forward Or Backward
just got today. starts fine...blade engages..won't go forward or backward
just got today. starts fine...blade engages..won't go forward or backward
(Posted by hhearing 9 years ago)
My Husqvrna Rz5424 Kohler Will Not Go Forward Or In Reverse.
(Posted by cindycurtisswells 10 years ago)
