Husqvarna ST131 Support Question
Husqvarna ST131 Support Question
Find answers below for this question about Husqvarna ST131.Need a Husqvarna ST131 manual? We have 1 online manual for this item!
Question posted by wzamplas on November 25th, 2021
Muffler Replacement St131 Snow Blower
How do I obtain step by step instructions for replacing the muffler on my ST131 single stage snow blower.
Current Answers
Answer #1: Posted by SonuKumar on November 26th, 2021 8:47 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,621,300
Member since:
May 9th, 2021 Points: 16,621,300
https://snowblowerhelp.com/husqvarna-s131-single-stage-snow-blower/
https://www.youtube.com/watch?v=Y_MWv3aHI0U
https://www.youtube.com/watch?v=Y_MWv3aHI0U&t=20
https://www.youtube.com/watch?v=Y_MWv3aHI0U&t=23
https://www.youtube.com/watch?v=Y_MWv3aHI0U&t=48
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Husqvarna ST131 Manual Pages
Owners Manual - Page 1
The use in this machine. Operator's Manual
ST 131
Gasoline containing up to 10% ethanol (E10) is acceptable for use of any gasoline exceeding 10% ethanol (E10) will void the product warranty.
115 68 50-27
Please read the owner's manual carefully and make sure you understand the instructions before using the machine. English
Owners Manual - Page 2
... shields during operation and remain hot after engine has stopped. The instructions will improve footing on the machine and in serious injury.
CAUTION: Muffler and other such structures or buildings. Please read and retain this unit.
It means CAUTION!!! WARNING: This snow thrower is highly flammable
(a) Use an approved fuel container.
(b) Never add...
Owners Manual - Page 3
...touch a hot engine or muffler.
Wait 10 seconds to vibrate abnormally, stop the engine (motor) and check immediately for an extended period.
4. Maintain or replace safety and instruction labels, as hot water ... your footing, and keep a firm hold on slippery surfaces. Never operate the snow thrower without proper guards, and other bolts at all moving parts have stopped rotating...
Owners Manual - Page 4
... future reference. IMPORTANT: Safety and instruction decals are located near areas of ...SNOW THROWER
READ THIS OWNER'S MANUAL AND ALL SAFETY RULES BEFORE OPERATING YOUR SNOW THROWER. These symbols may appear on your snow thrower to familiarize yourself with the product.
Replace damaged decals. KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
4 Compare the illustrations with your snow...
Owners Manual - Page 7
... use in the oil filler cap/dipstick.
7 Tighten oil fill cap / dipstick securely each five (5) hours of operation or at least once a year if the snow thrower is difficult to "FULL" on engine type. 3. Oil filler cap/dipstick
4. Remove either side mounted filler cap dipstick or high
oil fill dipstick and...
Owners Manual - Page 9
... "FULL" on dipstick with fresh, unleaded gasoline (minimum 87 AKI octane rating) (Figure 8). Always wear safety glasses or eye shields while operating your snow thrower or performing any snow thrower can cause engine damage. Always check the engine oil before start up . IMPORTANT: Do not use in the oil filler cap/dipstick...
Owners Manual - Page 10
...connect an extension cord to start button
1. Replace or repair the damaged cord immediately. Push key in the primer so that is equipped with your snow thrower is not longer than 10 times at ...you push in (Figure 10).
2. Thaw out the starter before releasing it to the snow thrower and plug the other end into a power source.
Unplug the power cord whenever you are not starting ...
Owners Manual - Page 11
...initial operation there may be wear between these two parts
(Figure 15).
1
During initial break-in the snow. Figure 13 1. Rub Area
Figure 15 2. Control bar
Figure 14
1. To disengage the auger blades,...
To stop the engine, pull key out (Figure 16).
1
1.
Maximum performance, both snow throwing and driving, occurs when there is zero clearance between the auger blades and the scraper...
Owners Manual - Page 12
...
your hand to be sure the auger blades have
stopped rotating. 3. To clear the chute: 1.
To raise or lower the angle of injury associated with snow throwers.
Owners Manual - Page 13
... a hose is completed, allow engine to run for a few minutes to melt snow and ice off the engine.
• Clean the entire snow thrower thoroughly after each use .
• Spraying off any control or part, start... the discharge chute left and right to free it from the area
of the snow thrower.
• The best time to remove snow is ready for next use and wipe dry so it run for a few minutes...
Owners Manual - Page 14
... to position 2 if you disengage the control bar for Loose Fasteners Clean / Inspect Snow Thrower Clean / Replace V-Belts Check / Replace Auger Blades and Scraper Bar Check Fuel Lines and Electrical Wires
Check Engine Oil Level Change Engine Oil Inspect Muffler Check / Replace Spark Plug Empty Fuel Tank
Adjusting the Control Cable
Checking the Control Cable...
Owners Manual - Page 15
...-150 in the oil fill cap/dipstick and hand tighten it . The engine oil will be replaced after extended use.
5. Max fill: 18 oz. (0.5 l), type: automotive detergent oil with the...oil properly at a local recycling
center.
15 NOTE: Dipstick location may have an Authorized Service Dealer replace the auger blades and the scraper bar (Figure 21). Clean around the oil filler cap/dipstick ...
Owners Manual - Page 16
...25
1. Shift top cover until all fuel has been depleted. 3. Rear upper cover
16 Move snow thrower to prevent foreign object from entering the engine.
11. Remove two screws in the side cover... by removing the three carriage bolts and three flange nuts (Figure 25).
6. Top cover 2. Run snow thrower until fuel tank is cool. 4. Plenum
Figure 26
3. Wait until engine is clear of the...
Owners Manual - Page 17
...in the side covers that attach to the spark plug (Figure 29).
21. Reinstall two screws in step 5.
17 MAINTENANCE
12.
Reattach primer bulb tube to 20-22 ft-lb (27-30 N-m).
20...the rear lower cover and side covers (Figure 31).
1
1
2
Figure 31
1. Spark plug wire
IMPORTANT: Replace a cracked, fouled, or dirty spark plug. Reattach two screws through the rear covers and into the rear upper ...
Owners Manual - Page 18
...Checking the Control Cable and Adjusting the Control Cable in Figure 33. MAINTENANCE
Replacing the Drive Belt
If auger V-belt becomes worn, oil-soaked, excessively cracked, frayed, or otherwise damaged, replace the belt.
1. Remove the drive side cover by removing the six screws....
1
2
3 2
1 3
2 Figure 32
1. Install the new auger V-belt and drive pulley, routing it as shown in step 1.
Owners Manual - Page 19
... protective cover that all dirt, grease, leaves, etc.
Inspect moving parts for a period of acids during storage. ENGINE OIL
Drain oil (with engine warm) and replace with gasoline in any enclosure.
IMPORTANT: Never cover snow thrower while engine/ exhaust area is important to rust. STORAGE
Storage
STORING THE SNOWTHROWER
Immediately prepare your...
Owners Manual - Page 20
...muffler.
6. Blockage in fuel.
4. Water in fuel line.
1. Ensure handles are not replaceable)
Rotator hard to a service center/department. Lights not On (If Equipped)
1. Choke in manual unless directed to move
1. Connect wire to carburetor. Stale fuel.
3. Contact an authorized service center/department.
6. Excessive
1. Clean snow... Prime as instructed in need of...
Owners Manual - Page 24
... the product at the Husqvarna Factory.
7. Husqvarna is offered instead of and replaces any further use of purchase. b. The product should be transferred to the original... the other components are excluded from . Consumer Wheeled Products - WARRANTY DISCLAIMER. To obtain transmission / transaxle warranty service, first contact the retailer who you require assistance or...
Owners Manual - Page 26
... Year Pro-rated
3 Years
No Warranty 1 Year Pro-rated
1 Year
Snow Throwers, Tillers, LE475 Edger Engine* Auger Gearbox Other Non-Expendable Components Tiller... Commercial
Exhibit A Rental (any commercial,
household use only)
professional, institutional,
Product/Component
Riding Lawn Tractors: Frame, Chassis, Front Axle Engine*
5 Years *
agricultural, or income producing use, other...
Owners Manual - Page 27
...warranty, parts & labor, with Hydro-Gear Distributor network.
*** "Limited Lifetime Warranty" on specific Snow Throwers & Tillers, warranty through
Husqvarna.
** See reference 4 (b) of two (2) decks within the...the complete unit's final production, whichever comes first. RZ -
Deck Shell replacement will be limited to left
Consumer
Commercial
Rental
* See Separate Engine Manufacturer's...
Similar Questions
Looking For A Bushing For The Wheels On My St330p Snow Blower
(Posted by drifter3 1 year ago)
Need Owner Manual For A Husqvarna 924-hvx Snow Blower Can You Help?
(Posted by steffeseven 1 year ago)
Why Doesn't The Auger Engage On My St131?
Auger will not engage when pulling back on bailer.
Auger will not engage when pulling back on bailer.
(Posted by rjohnson37 2 years ago)
My St227 Husqvarna Snow Blower Only Moves Reverse
my ST227 Husqvarna nowblower only moves forward in 6th gear and very slowly I might add. All other g...
my ST227 Husqvarna nowblower only moves forward in 6th gear and very slowly I might add. All other g...
(Posted by PeteN 2 years ago)
How To Check And Clean Drive Train On Snow Blower Model#5524ste
(Posted by POCONO1CODYDOG 11 years ago)