Home » Husqvarna » Lawn Mowers » Husqvarna RZ5424

Husqvarna RZ5424 Support Question

Find answers below for this question about Husqvarna RZ5424.
Need a Husqvarna RZ5424 manual? We have 2 online manuals for this item!

Husqvarna Overview Questions Manuals Reviews Videos Research

Question posted by psonny9 on December 9th, 2019

Husqvana Rz5424 Flat Pulley Replacement

The flat pulley on my zero turn falling off the Lawnmover I had ordered new one and installed but don't how to install the spring for the flat pulley I need diagram how the drive belt install in to the flat pulley and position of the the spring

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by Odin on December 9th, 2019 6:23 PM

Odin

Member since:
April 10th, 2010

Points: 41,236,710

90
points

See https://www.youtube.com/watch?v=_l9kV_PrgsA and https://www.youtube.com/watch?v=x5Pe7h3_EIg.

Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.

Related Husqvarna RZ5424 Manual Pages

Owners Manual - Page 1

Operator Manual RZ4621 / 966659101 RZ4621 CA / 966659201 RZ5424 / 966659301 RZ4222F / 966659401 RZ4621 BF / 966676501 RZ4623 / 966678201 RZ4824F / 966678301 RZ5424 / 966691901 Please read the operator's manual carefully and make sure you understand the instructions before using the machine.

Owners Manual - Page 3

Contents INTRODUCTION 5 Driving and Transport on Public Roads 5 Towing 5 Operating 5 Good Service 6 Symbols and Decals 7 Safety 9 Safety ...Safety System 37 Fuel Pump Air Filter 37 Tire Pressures 38 Parking Brake 38 V-belts 39 Deck Belt 39 Cutting Blades 40 Blade replacement 40 Adjusting the Mower Deck 41 Leveling deck 41 Anti-scalp Rollers 42 Caster Wheels 43 Cleaning 43 ...

Owners Manual - Page 5

..., use extreme caution when towing. Make wide turns to the new owner. The weight of the towed equipment may.... A control panel easily accessible to the machine's normal driving direction. Read the contents carefully before transporting on sloped ground...special characteristics and who operate this machine on mower. Lawn mowers and all who are incorrect. Use only approved repair...

Owners Manual - Page 13

.... • Never overfill fuel tank. Replace gas cap and tighten securely. • Do not start the engine near spilled fuel. • Never use extreme care in fuel system, engine must not be started when the driver's floor plate or any protective plate for the mower deck's drive belt is risk for the fuel to...

Owners Manual - Page 14

... bolts tight to be sure the equipment is in good condition. 8011-515 Never drive the machine in an enclosed space WARNING! Acid on the battery when smoking or near...8226; Check grass catcher components and the discharge guard frequently and replace with manufacturer's recommended parts, when necessary. • Mower blades are properly tightened, torqued and that are considered to be ...

Owners Manual - Page 20

... On models with separate choke, the control should be pulled up. Choke control Fuses Fuses are flat pin fuses of the machine. They are located on models with the a throttle/choke, the ...Ignition switch Choke Control The choke control is used in order to provide the engine with ratings and functions: 20 Amp Primary fuse 7.5 Amp Mower deck coupling Fuses 20 8052-001 8052-001 8011-...

Owners Manual - Page 23

Hour meter Tracking Knob If the mower is one hour before and one hour after which the seat can be checked on a flat and level concrete or blacktop surface. The hour ...020 23 The flash duration is not tracking straight, check the air pressure in the full forward position. Lengthways adjustment Hour Meter The hour meter displays the total operating time. Recommended air pressure is ...

Owners Manual - Page 24

... speed by Hand" in the reverse position. 24 We also suggest first time users, or new users to Zero Turn mowers to become familiar with controls. Until operator becomes comfortable with the machine. First time users should push mower (see "Before Starting" in Operation section), adjust engine speed to an open, flat area, without other in the...

Owners Manual - Page 30

... not drive across slopes. • The slowest speed possible should be achieved by pulling out the blade switch. 7. In order, for example, to the outside of the mower and press forward to the right. Place controls in the "Safety Instructions". operation 6. Move throttle control to neutral when released. Turning on the spot (zero turn right while...

Owners Manual - Page 31

...twice. The lawn becomes more even and the grass clippings more than 10 degrees. The mowing result is poorer because the wheels sink into the transport position. When cleaning, the mower deck shall be...grass is not too long and dense, the driving speed can be increased without poor mowing results. • Avoid mowing wet lawns. Make sure the mower is cooled and the engine is not increased ...

Owners Manual - Page 34

... Start the engine and blades, listen for unusual sounds Check for damage Thoroughly clean around the engine Clean around belts, belt pulleys Check the tire pressures Before After Check battery connections Sharpen3)/ Replace mower blades Clean the engine's cooling air intake 2) Clean the air cleaner's pre-filter 2) (foam) Clean the air cleaner's filter cartridge 2) (paper...

Owners Manual - Page 35

...belts, belt pulleys Change the engine oil 1) Replace the engine oil filter Clean/replace the spark plugs Replace the fuel filter Replace air filter 2) (paper filter) Check the caster wheels (every 200 hours) Replace the air cleaner's pre-filter 2) (foam) Check/adjust the mower... the Blade-switch in the disengaged position. • Turn the ignition switch to "OFF" position and remove the key. •...

Owners Manual - Page 36

...need servicing. Reconnect RED battery cable to negative (-) battery terminal with bolt and hex nut. 9. Always wear eye protection when around batteries. Reinstall battery. Connect BLACK grounding cable to positive (+) battery terminal with remaining hex bolt and hex nut 10. Adding or checking level of charger IMPORTANT INFORMATION Do not attempt to replace... Install new ...

Owners Manual - Page 37

... hoses need be able to start the engine when one of the conditions is not met. Check that the fuel pump's air filter is free from dirt. Steering controls locked in the outer, locked neutral position. 3. Replace the filter on . MAINTENANCE Safety System The machine is equipped with a brush if necessary. The mower deck...

Owners Manual - Page 39

... deck into the lowest cutting position. 3. Place belt around the mandrel housings. 5. Belt routing 8058-088 8011-764 39 NOTE: The belt will show some small cracks in installing the deck belt, refer to tension belt. 6. Wrap the belt around the stationary idler pulley and around spring loaded idler pulley. 4. Wrap the deck belt around the electric clutch pulley that may have any...

Owners Manual - Page 41

... are equal. Turn any blade to raise. NOTE: This will lower the front. NOTE: To insure accuracy of leveling procedure, mower deck drive belt must be required...installed prior to -side measurements are under Transmission. The deck should be properly adjusted. With a 5/8 or adjustable wrench, turn the lift link adjustment nuts on the discharge side of mower deck is positioned...

Owners Manual - Page 47

... • Charging lead is disconnected • Parking brake on • Bypass valve on pump open • Drive belt for the transmission slack or has come off • Air trapped in hydraulic system • Drive belt for the mower deck has come loose • Contact for the electromagnetic coupling has loosened • Blade switch is faulty...

Parts Manual - Page 31

..., DECK 3.. 539 112238 1 BELT SHIELD, RH 4.. 539 112240 1 BELT SHIELD, LH 5.. 539 110731 1 DISCHARGE CHUTE 6.. 539 110735 1 SPRING, TORSION 7.. 539 112413 1 CONFINEMENT PLATE 8.. 539 112078 3 BLADE, 14 5/8 9.. 539 112198 1 ARM, IDLER 10.. 525 348501 3 PULLEY, MANDREL 11.. 539 132728 3 PULLEY, IDLER 12.. 539 112169 2 BUSHING, IDLER 13.. 532 176066 1 ROLLER, NOSE 14.. 532 179127...

Parts Manual - Page 33

...MOWER DECK / CUTTING DECK ITEM PART NO. QTY. QTY. DESCRIPTION 1.. 522 744301 1 DECK w/ SAFETY DECALS 2.. 539 117245 1 BELT, DECK 3.. 522 629701 1 KEEPER, BELT 4.. 532 405506 1 SHIELD, BELT RH 5.. 532 405507 1 SHIELD, BELT... 1 PULLEY, IDLER 10.. 539 132728 1 PULLEY, IDLER 11.. 539 113962 2 PULLEY, DECK 12.. 539 120920 1 SPRING, DECK BELT 13.. 539 107609 1 SPRING, TORSION...

Parts Manual - Page 35

...1 BELT SHIELD, RH 4.. 539 113413 1 BELT SHIELD, LH 5.. 539 110732 1 DISCHARGE CHUTE 6.. 539 110735 1 SPRING, TORSION 7.. 539 113247 1 CONFINEMENT PLATE 8.. 539 113425 3 BLADE 16¼ 9.. 539 112198 1 ARM, IDLER 10.. 525 348501 3 PULLEY, MANDREL 11.. 539 132728 3 PULLEY, IDLER...28.. 532 195161 2 STUD w/ ANTI-ROTATE ITEM PART NO. QTY. MOWER DECK / CUTTING DECK ITEM PART NO.