Husqvarna RZ46i Support Question
Husqvarna RZ46i Support Question
Find answers below for this question about Husqvarna RZ46i.Need a Husqvarna RZ46i manual? We have 2 online manuals for this item!
Current Answers
Answer #1: Posted by TechSupport101 on April 7th, 2016 7:23 AM
TechSupport101
Member since:
May 24th, 2013 Points: 12,171,285
Member since:
May 24th, 2013 Points: 12,171,285
Related Husqvarna RZ46i Manual Pages
Owners Manual - Page 3
... 24 Bypass Linkages 24 OPERATION 25 Training 25 Steering 25 SmartSwitch Ignition 26 Before Starting 27 Starting the Engine 28
Ignition System Faults 31 Running 32 Stopping the Engine 33 Operating...V-belts 43 Deck Belt Removal 43 Cutting Blades 44 Blade replacement 44 Adjusting the Mower Deck 45 Leveling deck 45 Cleaning 46 Hardware 46 LUBRICATION 47 Lubrication Schedule 47 Wheel...
Owners Manual - Page 5
...road traffic regulations before using or servicing the machine. DO NOT operate this machine on mower. Towing
If machine is important for the safety of the machine and increase its ...considerably increase the life span of the operator and others in or on public roads. Lawn mowers and all who are used improperly. Unauthorized modifications to maintain this operator manual provides a ...
Owners Manual - Page 9
... of the discharge opening at all instructions on the machine and in the manual before starting the machine
Clear the area of objects before and while backing.
• Never direct...engine before dismounting.
8011-512
Read the operator manual before starting .
• It is recommended that someone be aware that important safety instructions need to operate the machine.
• Clear the area ...
Owners Manual - Page 12
... over by putting a foot on slopes
Children
Tragic accidents can occur if the operator is not alert to the presence of age before operating a riding lawn mower.
Owners Manual - Page 13
...exhaust system become very hot during operation. Replace gas cap and tighten securely.
• Do not start the engine near spilled fuel.
• Never use and leave space for the fuel to cool ...the ground.
The engine must not be started until fueling is spilled on a truck or trailer bed with the engine running. There is risk for the mower deck's drive belt is extremely flammable ...
Owners Manual - Page 16
... is on.
• The motion control levers are disengaged.
• The park brake is started when:
• The mower blades are in the Operation section.
The engine can only be started , the engine will continue to run for starting or driving under the following conditions. SAFETY
Safety System
The machine is equipped with a safety...
Owners Manual - Page 20
...-push forward to the snowflake symbol.
Once the engine has started, slowly move the throttle control forward past the start 20
8058-187 8058-247 8058-286 Cold Weather start detent to release it. For best mower performance and battery charging, USE FULL THROTTLE WHEN STARTING OR MOWING. Release the park brake before dismounting.
Park...
Owners Manual - Page 21
... control panel and is placed on /off the headlights.
Ignition Switch
The ignition switch is used to start and stop the engine. Button 1 can be used to check the battery condition. Headlights indicator Courtesy lights
8058-239
21 The mower blades are disengaged when the knob is below the normal operating power.
Owners Manual - Page 24
...muffler. Bypass linkages are located on each side of the rear of the seat.
See Before Starting in the Operation section. IMPORTANT INFORMATION
To obtain an even cutting height, it is important ...should be shut off and allowed to 4" (102 mm) in ½" (13 mm) increments. Mower deck lifting lever
Bypass Linkages
The levers are located close to the blade tip with the engine not running...
Owners Manual - Page 25
... the rotation of the right wheel and cause the machine to the neutral position and the mower should push the mower (see Before Starting in the Operation section). Push the control levers forward to the neutral position and mower should be reviewed in a forward direction pull the left lever, this time.
This section should...
Owners Manual - Page 26
... starting at the factory. Start/Stop Button 2. Numbered buttons Press buttons to five digits and then press the S/S button. Wait for three seconds. OPERATION
SmartSwitch Ignition
NOTES: The default passcode... Using the lower buttons, enter a desired code of numbers from one to enter new passcode
3. To initialize the ignition system, press the START/ STOP (S/S) button on the ignition switch...
Owners Manual - Page 28
... release button in and pulling the lever fully upwards.
8058-019
Pull park brake upwards to the locked (transport) position.
Mower deck lifting lever
3. Sit on the top of the lifting lever. OPERATION
Starting the Engine
1. Raise the mower deck by pressing the blade switch downwards.
8058-187
Blade switch
8058-247
28
Owners Manual - Page 33
...Move the steering controls outward. 3. Press and release the S/S button to -start mode with a blinking green light. OPERATION
Stopping the Engine
1. Unexpected Engine Stoppage
If ... for two seconds.
The electrical system will automatically shut down .
8058-249
Disengage the mower deck and move throttle to attain a normal operating temperature before stopping. When the machine...
Owners Manual - Page 34
..., pull steering controls into the neutral position and push to the outside of the mower and press forward to the center of the unit. Do not drive across slopes.
• The slowest speed possible should be used before starting up or down hills.
• Avoid stopping or changing speed on Slopes in...
Owners Manual - Page 36
... Cables Use 1. Remove BLACK cable first from chassis and then
from the fuel tank and battery. Do not use your mower to start other vehicle must also be recharged. (See Battery in start the engine, it should be a 12-volt negative grounded system. The other vehicles.
36
When the engine is too weak...
Owners Manual - Page 37
...bypass linkage, EZT engaged
8058-239 8058-032
WARNING! If the battery is low when a start attempts as long as remaining charge is the possibility of cranking the engine. The button can indicate... keyhole slots. It will not prevent additional start attempt is below the rear engine guard.
1. Moving Machine By Hand
When pushing or pulling the mower, engage the EZT bypass linkages. WARNING!...
Owners Manual - Page 38
...) Check the safety system Check for fuel and oil leakages Check/clean the engine's cooling air intake Check the mower deck Check for loose hardware (screws, nuts) Clean under the mower deck Start the engine and blades, listen for unusual sounds Check for damage Thoroughly clean around the engine Clean around belts, belt...
Owners Manual - Page 41
... starting or driving under the following conditions.
Park brake
8058-187
41 the steering controls are in neutral
8058-026
Park Brake
Visually check that the engine stops if the mower ... brake is found on .
Steering controls locked in the outer, locked neutral position,
3.
the mower deck is not met, turn the machine off the drivers seat.
WARNING!
To adjust the park...
Owners Manual - Page 51
...the carburetor if you have become loose.
3. Never use for longer than 30 days. Start the engine and allow it to avoid corrosion.
2. Turn over the engine so that... spare parts. Use a degreaser and warm water instead. Thoroughly clean the machine, especially under the mower deck. Touch up at an authorized service workshop is very flammable and can leave sticky residues that ...
Owners Manual - Page 56
... Fill with fuel and open the fuel shut off valve Start the engine Check that there is drive to both wheels Check the mower deck adjustment Check:
The safety switch for the park brake... speed Check the engine high idle speed Inform the customer about:
The need and advantages of following the service schedule The need and advantages of leaving the machine for service every 300 hours The effects...
Similar Questions
Husqvarna Riding Lawn Mower Starts, Blade Spins, Won't Go Forward Nor Reverse
(Posted by shywolfalways82 3 years ago)
Smart Switch On Husqvarna Rz46i, Stays Blue. Resetting Code Does Not Help.
I'm in the seat, mower deck up. blades off, handles out. No indicator lights saying there is a probl...
I'm in the seat, mower deck up. blades off, handles out. No indicator lights saying there is a probl...
(Posted by rlwatty1 4 years ago)
How Do I Reset And Change Start Code
need to know how i can reset and change my start code
need to know how i can reset and change my start code
(Posted by kmlong2u 8 years ago)
My Husqvarnarz4623 Lawn Mower
My husqvarna lawn mower will not start. It wont even try to turn over or click.
My husqvarna lawn mower will not start. It wont even try to turn over or click.
(Posted by teresaandbryancates 9 years ago)