Husqvarna LGT2654 Support Question
Husqvarna LGT2654 Support Question
Find answers below for this question about Husqvarna LGT2654.Need a Husqvarna LGT2654 manual? We have 2 online manuals for this item!
Question posted by jimmcdo48 on February 21st, 2016
Wheel Weights
what wheel weights do I use for the lgt 2654 960450047
Current Answers
Answer #1: Posted by Odin on February 21st, 2016 7:50 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,670
Member since:
April 10th, 2010 Points: 41,236,670
The complete wheel assembly is available for $7 at http://www.repairclinic.com/Shop-For-Parts/i1065-x6c677432363534/Lgt2654-Wheel-Assembly-Parts for $7, where you'll see both the seller's item number and the manufacturer's part number. If you need more information either phone the seller (see the number at the top of the page) or the manufacturer (see the contact information here: https://www.contacthelp.com//customer-service).
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Husqvarna LGT2654 Manual Pages
Owners Manual - Page 2
...to protect themselves and others from serious injury. • Follow the manufacturer's recommendation for wheel weights or counterweights. • Keep machine free of the discharge opening at the lowest possible ... turn off engine and wait for traffic when operating near or crossing roadways. • Use extra care when loading or unloading the machine
into a trailer or truck. • Always...
Owners Manual - Page 3
...; Follow the manufacturer's recommendation for weight
limits for towed equipment and towing on a water
•
heater or other sources
of ignition.
•
• Use only approved gasoline container.
•... the watchful care of 15°. Repair, if necessary, before operating a riding lawn mower. IV.
If machine stops while going uphill, disengage blades, shift into reverse...
Owners Manual - Page 5
... (1) Oil Drain Tube
Keys
(2) Keys
(1) 1-1/4 O.D. UNASSEMBLED PARTS
Mower
Mower Front Wheel
(5) 1-3/16 O.D. Washer
(1) 3/8-16 Locknut
Slope Sheet
(2) Hex Bolts (2) Nut Keps
*Installed by Dealer
*Brush Guard Kit
(1) Quick Connect
5 Washers
(2) Rear Lift Link Assemblies
(1) Small Retainer ...
Owners Manual - Page 6
...section of this manual. Standard
wrench sizes are in the operating position (seated behind the steering wheel). Follow the instructions below to raised position. WARNING: Before starting, read, understand and follow .... and hardware you are listed.
Continue with exception of those parts left hand is used to ensure proper tightness. PARKING BRAKE LEVER
Fig. 3 • The attachment lift...
Owners Manual - Page 7
...side suspension arms (A) are pointing forward before sliding mower under tractor. • Slide mower under
tractor.
RETAINER SPRING C. LOCKING BRACKET M. DEFLECTOR SHIELD S. FRONT GAUGE WHEEL WASHER
Z. 3/8-16 LOCKNUT
Fig. 5
3.
FRONT SUSPENSION BRACKET H. BELT TENSION ROD L. ENGINE CLUTCH PULLEY Q. SLIDE MOWER UNDER TRACTOR (See Fig. 8) • Bring belt forward and...
Owners Manual - Page 8
.... • Lift rear corner of bar into hole in link as shown. HOLE
Fig. 13
8 ATTACH FRONT LINK (E) (See Fig. 14)
• Turn steering wheel to position wheels straight forward.
• From front of tractor, insert rod end of front link (E) through front hole in tractor front suspension bracket (F).
• Move to...
Owners Manual - Page 9
...engage slowly.
• Raise attachment lift to highest position. • If necessary, adjust gauge wheels before operating your tractor, check to -rear for best cutting results. (Tires must be properly ...under mandrel covers. • Engage belt tension rod (K) on tires.
WHILE LEARNING HOW TO USE YOUR TRACTOR, PAY EXTRA ATTENTION TO THE FOLLOWING IMPORTANT ITEMS:
✓ Engine oil is at ...
Owners Manual - Page 10
...avoided, will result in death, serious injury and/or property damage.
The safety alert symbol is used without the alert symbol, indicates a situation that could result in literature supplied with the product. ... AWAY
KEEP AREA CLEAR
SLOPE HAZARDS
(SEE SAFETY RULES SECTION)
FREE WHEEL (Automatic Models only)
Failure to identify safety information about hazards which , if not avoided...
Owners Manual - Page 13
... performance, grass over 3" during hot months.
Make the first cut position, gauge wheels should be assembled so they are approximate and may vary depending upon soil conditions, height of grass and types of grass being mowed. • The average lawn should be cut with the engine running . Fig. 22
TO OPERATE MOWER...
Owners Manual - Page 14
.... 24) Only use of the ROS is no children or other bystanders will flash for two hours.
Do not mow in the "STOP" position when engine is dangerous. Free wheel control is located ...should only be done when the operator decides it is held in freewheeling position. Use common sense when towing.
Use an appropriate means of your tractor, be sure key remains in reverse unless absolutely...
Owners Manual - Page 15
... control to the
fast position.
• The attachments and ground drive can be used . Never use gasoline near an open flame.
If the engine does not start after the transmission has...high altitude (above ) • When engine starts, move fuel from the factory already filled with summer weight oil.
• Check engine oil with the throttle control in the choke position until "FULL" mark on...
Owners Manual - Page 16
... performance of the drive wheels.
4.
Move lever to assure better mowing performance and proper discharge of manual).
3. MOWING TIPS
• Tire chains cannot be used when the mower housing is..., move throttle control to the right of mower should be movement of the attachment being used for five (5) seconds. This procedure will result in a more uniform cutting.
• ...
Owners Manual - Page 17
...BEARINGS. See Cleaning in this manual. IF YOU FEEL THEY MUST BE LUBRICATED, USE ONLY A DRY,
POWDERED GRAPHITE TYPE LUBRICANT SPARINGLY.
17 Change more often when ...➀ SPINDLE ZERK
➀ FRONT
WHEEL BEARING ZERK
➀ STEERING
SECTOR GEAR TEETH
➀ FRONT
WHEEL BEARING ZERK
➁ ENGINE
➀ MANDREL
ZERKS
BEFORE EACH USE
• Check engine oil level.
02501...
Owners Manual - Page 20
...
STEERING SYSTEM, DASH, FENDER AND MOWER NOT SHOWN
Fig. 32 • Keep finished surfaces and wheels free of your tractor unless the engine and transmission are reinstalled. FUEL FILTER
Fig. 31
00667
20...to keep water out. We do not recommend using a dirty air filter. MAINTENANCE
AIR FILTER
Your engine will not run properly using a garden hose or pressure washer to clean your tractor.
Owners Manual - Page 21
... and push the adapter onto the deck washout port at the left end of the nozzle adapter to using mower again. • Plug any holes in mower with the blade. • Replace broken or missing... putting the tractor away.
Drive the tractor to a level, clear spot on your lawn, near enough to a water spigot for your garden hose to lock the adapter on its surface as part of your house, garage, ...
Owners Manual - Page 33
...
*
Other Non-Expendable Components
2 Years
Tiller Tines
***
Walk Behind Mowers, High Wheel Trimmer
Engine*
*
Battery
1 Year Pro-rated
Other Non-Expendable Components
3 Years
Hovering...:
Engine*
*
Pump
2 Years
Other Non-Expendable Components
2 Years
All other than Rental Use)
Riding Lawn Tractors:
Frame, Chassis, Front Axle
5 Years
No Warranty
Engine*
*
*
Transmission (if...
Parts Manual - Page 9
LGT2654 (96045004000), PRODUCT NO. 960 45 00-40
DRIVE
KEY PART NO. Bolt Hex Flghd 5/16-18 3.75 Screw 1/4 x 1/2... Pulley Idler Reflector RH Retainer Spring Clip Handle Keeper Belt Trans. TRACTOR - MODEL NO. inches 1 inch = 25.4 mm
9 Wheel Rear 22" TX GT .06 Bolt Hub Wheel Rear Washer 13/32 x 13/16 x 16 Ga. Bracket Mount Torque Screw 5/16-18 x 3/4 Washer Hardened Idler V-Groove ...
Parts Manual - Page 13
... 68 873 90 07-00 69 532 19 91-62 70 532 19 61-97 122 532 44 49-62
DESCRIPTION
Wheel, Steering Axle Asm., Front Spindle Asm., LH Spindle Asm., RH Bearing, Race Thrust Harden Washer 25/32 x 1-5/8...NO. Washer, Lock Hvy Hlcl Spr 3/8 Nut, Crown Lock 3/8-24 unf Shaft Steering Plate Steering Adapter, Wheel Steering Supt. LGT2654 (96045004000), PRODUCT NO. 960 45 00-40
STEERING ASSEMBLY
KEY PART
NO.
Parts Manual - Page 15
...41 82-29
DESCRIPTION
Baffle Center Washer Hardened Spring Drive Bolt Rdhd Sqnk 5/16-18 x 3/4 Rod Tension Relief Bolt, Shoulder Gauge Wheel Washer 13/32 x 1-1/4 x 12 Ga. Mower Rear Bolt Shoulder Keeper Belt Idler Bolt Carr Sqnk 7/16-24 x 2 Bolt...) Replacement Mower, Complete
NOTE: All component dimensions given in U.S. LGT2654 (96045004000), PRODUCT NO. 960 45 00-40
MOWER DECK
KEY PART NO.
Parts Manual - Page 18
... Bypass Pad, Footrest, LH Pad, Footrest, RH Manual, Operator's (English/Spanish) Manual, Parts (English/Spanish)
WHEELS AND TIRES
1
2
11 3
4
7
10
6
wheel_art_1-tex
5 9 8
KEY PART NO. MODEL NO.... Decal, Mower Decal, Eng B&S HP Decal, Fender Decal, Caution Decal, E85 Warning Decal, Mower Sch. LGT2654 (96045004000), PRODUCT NO. 960 45 00-40
DECALS
16
15
17 16
4
14
1
14
9
8
...
Similar Questions
I Need A Diagram Of V Drive Belt For Husqvarna Lgt2654 Not The Deck Belt.
Is there a Diagram anywhere that shows the routing for the Ground Drive Belt or V Drive Belt not the...
Is there a Diagram anywhere that shows the routing for the Ground Drive Belt or V Drive Belt not the...
(Posted by anthony8908 1 year ago)
Husqvarna Lgt2654 Riding Mower
what would cause the mower to shut down when the pto is engaged? have already replaced the pto and a...
what would cause the mower to shut down when the pto is engaged? have already replaced the pto and a...
(Posted by markw1960 2 years ago)
Scalp Wheels
does this model come with scalping wheels for the deck? How many if it does
does this model come with scalping wheels for the deck? How many if it does
(Posted by Datchuk2020 2 years ago)
St227p Drive Locks Wheels But Goes Forward If Steering Levers Are Used.
Is there a fix for the above? Sometimes one side will lock. Put in reverse and will back up like its...
Is there a fix for the above? Sometimes one side will lock. Put in reverse and will back up like its...
(Posted by Edlutkus 3 years ago)
How Much Oil Does My Husqvarna Lgt2654 Transaxle Hold
(Posted by wsalma 9 years ago)