Home » Husqvarna » Lawn & Garden » Husqvarna ST 227P

Husqvarna ST 227P Support Question

Find answers below for this question about Husqvarna ST 227P.
Need a Husqvarna ST 227P manual? We have 1 online manual for this item!

Husqvarna Overview Questions Manuals Reviews Videos Research

Question posted by Edlutkus on February 1st, 2021

St227p Drive Locks Wheels But Goes Forward If Steering Levers Are Used.

Is there a fix for the above? Sometimes one side will lock. Put in reverse and will back up like its in 5th gear. Traction wheel and drive plate are good. Belts are good.

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by waelsaidani1 on February 15th, 2021 11:34 AM

This answer was accepted by the poster of the original question.

waelsaidani1

Member since:
May 12th, 2013

Points: 19,501,797

1,100
points

If the wheels are not engaging here is video guide on how to solve it: https://www.youtube.com/watch?v=vPvo0SWge1A

Related Husqvarna ST 227P Manual Pages

Owners Manual - Page 1

Operator's Manual ST 227P Gasoline containing up to 10% ethanol (E10) is acceptable for use of any gasoline exceeding 10% ethanol (E10) will void the product warranty. 115 68 34-27 Rev. 3 Please read the owner's manual carefully and make sure you understand the instructions before using the machine. English The use in this machine.

Owners Manual - Page 2

... any adjustments while the engine (motor) is for use a nozzle lock-open device. (g) Replace gasoline cap securely and wipe...improve footing on a truck or trailer bed with electric drive motors or electric starting motors. 6. YOUR SAFETY IS ...or under rotating parts. Training 1. it cannot contact plug in reverse. Exercise extreme caution when operating on sidewalks, driveways and other...

Owners Manual - Page 3

... be sure the equipment is transported or not in reverse. 13. Never touch a hot engine or muffler....slippery surfaces. Look behind and use care when operating in use a clean-out tool, not...Maintain or replace safety and instruction labels, as wheel weights, counterweights, or cabs). 15. SERIAL NUMBER.... Never operate the snow thrower without good visibility or light. We have stopped....

Owners Manual - Page 5

... CARRIAGE BOLT LOWER HANDLE HANDLE KNOB FIG. 3 FIG. 1 5 Remove snow thrower from skid plate if equipped. 4. Remove all accessible loose parts and parts boxes from carton. 2. ASSEMBLY / PRE...to snow thrower and making adjustments to the skid plates. Remove the two (2) screws securing the auger housing to desired position using the appropriate mounting holes. HOW TO SET UP YOUR...

Owners Manual - Page 6

...levers. Correct and equal tire pressure is important for shipping purposes. ASSEMBLY / PRE-OPERATION INSTALL DISCHARGE CHUTE / CHUTE ROTATOR HEAD (See Fig. 4) NOTE: The multi-wrench provided in your snow thrower were overinflated at the factory for best snow throwing performance. • Reduce tire pressure to the lower handle using...ROTATOR CABLES FIG. 5 CONTROL LEVER FIG. 7 CHECK TIRE ...

Owners Manual - Page 7

... MANUAL WATCH FOR THROWN OBJECTS OPERATE AT A SAFE DISTANCE FROM OTHER PEOPLE DANGER, KEEP HANDS AWAY DISENGAGED DOWN FORWARD ENGAGED TRACTION DRIVE CONTROL SNOW DISCHARGE CHUTE DEFLECTOR TRACTION DRIVE CONTROL SNOW DISCHARGE UP REVERSE STEER LEFT STEER RIGHT ROTATE LEFT 7 CHUTE ROTATION ROTATE RIGHT These symbols may appear on your snow thrower to familiarize yourself with...

Owners Manual - Page 8

... Skid plate - pumps additional fuel from the ground. 8 used to the engine. Auger control lever - used to the standards of snow thrower. SAFETY REQUIREMENTS Our snow throwers conform to STOP the engine. used to engage powerpropelled forward or reverse motion of the American National Standards Institute. used for shutting off valve - LIGHT TRACTION DRIVE CONTROL LEVER LH...

Owners Manual - Page 9

... the chute and/or auger. Be sure lever springs back and locks into desired position. We recommend standard safety glasses or a wide vision safety mask worn over spectacles. Move lever back to stop . Use the choke control whenever you are starting a cold engine. STOPPING TRACTION DRIVE • Release traction drive control lever to raise the deflector and increase the...

Owners Manual - Page 10

... blockage. CAUTION: Do not move lever to assist in the engaged position. This will lock the auger control lever in steering your right hand from the spark plug to stop the forward or reverse movement of the snow thrower. Damage to release your snow thrower. TRACTION DRIVE CONTROL LEVER DRIVE SPEED CONTROL LEVER AUGER CONTROL LEVER DISCHARGE CHUTE CLEAN-OUT TOOL...

Owners Manual - Page 12

.... If you and be removed. • Throw snow downwind whenever possible. • Adjust the skid plates to warm up for current snow conditions. COLD START - Push the primer three (3) times. NOTE: Over... to warm up for a few minutes before attempting to start and DO NOT push the primer. 5. Use the drive speed control, NOT the ON / OFF switch, to adjust speed. • It is easier and ...

Owners Manual - Page 14

...using a garden hose to slow leaks, tire sealant may be replaced by original equipment manufacturer (OEM) belts...is on the gear case. • If lubricant is not used above components can harm rubber... expected operating temperature. TRACTION DRIVE SYSTEM DO NOT lubricate the drive components inside the snow... sprockets, hex shafts, drive disc and friction wheel require no maintenance. Remove...

Owners Manual - Page 15

...move throttle control to STOP position. Use only original equipment shear bolts as ... wire from spark plug. Install 1/4-20 lock nut and tighten securely. Disengage all moving...BELT COVER Disconnect spark plug wire from the operator. SNOW THROWER TO ADJUST SNOW THROWER HEIGHT See "TO ADJUST SKID PLATES...augers do not turn when auger control lever is engaged, check to direct discharging ...

Owners Manual - Page 16

... both the auger and traction drive belt be raised and discharge chute to secure the snow thrower in the operating position and hold the snow thrower handles. The V-belts on both sides of the frame assembly. 3. Drain gasoline from fuel tank into a suitable container, outdoors, away from the engine pulley. 4. Loosen lock nut securing chute...

Owners Manual - Page 17

... pulley bolt and washer, engine pulley, and drive belt from axle. Place drive belt onto drive pulley. Tighten securely. 3. Lbs. / 41-47 Nm). 5. INSTALL DISCHARGE CHUTE - TO INSTALL DRIVE BELT 1. Tighten securely (30-35 Ft. Install return spring onto swing plate. 7. Install tensioner spring onto tensioner arm. 8. TO REMOVE WHEELS (See Fig. 23) • Remove the...

Owners Manual - Page 18

... adjustment by loosening the jam nut next to lengthen the adjuster. 3. SERVICE AND ADJUSTMENTS TO ADJUST SPEED SELECT AND DRIVE ENGAGEMENT CABLE TENSION (See Fig. 24) After many hours of use, if first gear seems to slip or seems too slow, adjustments may create an unsafe machine condition. If it is still too...

Owners Manual - Page 20

... wire. 2. Clean or replace muffler. Move choke to ON position). Empty fuel tank & carburetor, refill with fresh, clean gasoline. 4. Loss of traction drive / slowing of swath. 3. Friction drive wheel is worn. 3. Auger belt is worn. 1. Motor not running. 1. Turn fuel shut-off of this manual. Fill fuel tank with fresh, clean gasoline. 5. Primer not...

Owners Manual - Page 21

...manufacturer's warranty or any further use and maintenance from defects in...(including Drive Systems) are excluded from defects in such ..., bulbs, filters, lubricants, starter cords, belts, blades, and blade adapters. (d) Emissions... Limited Warranty. (b) Transmissions. Consumer Wheeled Products - This Limited Warranty may ...Hydro-Gear, Tuff-Torq provide a warranty for commercial,...

Owners Manual - Page 22

...engines above specified and recommended engine speeds as belts, pulleys, spindle housings, bearings, blades, rods, height adjusters, caster/anti scalp wheels etc... Proof of purchase rests solely with you...fuel E15 or E85 is not a condition of lubrication or engine failure, due to the use in material or workmanship. The following : (e) Failure to provide or perform required maintenance ...

Owners Manual - Page 23

... (any commercial, household use only) professional, institutional, agricultural, or income producing use, Product/Component other than Rental Use) Riding Lawn Tractors: Frame, Chassis,... No Warranty No Warranty * 1 Year ** 2 Years ** No Warranty Fabricated Deck shell. Consumer Wheeled Limited Warranty Chart 2013 Consumer (personal, Commercial (any rental usage) No Warranty * No Warranty *...

Owners Manual - Page 24

...Manufacturer's warranty. One (1) Year Commercial warranty, parts & labor, with Hydro-Gear Distributor network. Two (2) Year Consumer warranty, parts & labor, with Husqvarna. Consumer Wheeled Limited Warranty Chart 2013 Exhibit A Consumer (personal, Commercial (any commercial, Rental (any household use only) professional, institutional, rental usage) agricultural, or income producing...