Husqvarna K 760 Support Question
Find answers below for this question about Husqvarna K 760.Need a Husqvarna K 760 manual? We have 2 online manuals for this item!
Question posted by thefirebird8 on December 6th, 2017
K760 Saw.starts And Idles Fine.q
the saw run fines but when you give it full acceleration it sounds like its running lean and sputters then will shut down. Fuel is mixed fine and clean air filter. On the carb i can only see one screw that is black. Being the idle screw on the right side. Any suggestions and where can i get a service manuel for this saw to see how to repair further. Im thinking of buying a new carb but not sure that is the issue compared to everone else. I rent this tool and need it up running.
Current Answers
Answer #1: Posted by Odin on December 6th, 2017 7:03 PM
I can't locate q service manual. You may be able to purchase one from Husqvarna: use the contact information here--https://www.contacthelp.com/husqvarna/customer-service. Have you considered the suggestions at https://www.manualslib.com/manual/1159961/Husqvarna-K760.html?page=29#manual?
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Husqvarna K 760 Manual Pages
Similar Questions
580 Bfs Will Not Start.
Changed fuel filter, spark plug and cleaned air filter(s). Previously problem was it would start up ...
Changed fuel filter, spark plug and cleaned air filter(s). Previously problem was it would start up ...
(Posted by prynshall 6 years ago)
K760 No Start When Cold No Fuel On Spark Plug .
k760 no start when cold pull spark plug out not wet. Pour gas in sperk plug hole starts and runs fin...
k760 no start when cold pull spark plug out not wet. Pour gas in sperk plug hole starts and runs fin...
(Posted by billdeegan68 7 years ago)
Have The K760 Concrete Saw. Wont Start,
have the k760 concreate saw , wontstart ive found oil in the de compreshion switch bore, and spark p...
have the k760 concreate saw , wontstart ive found oil in the de compreshion switch bore, and spark p...
(Posted by nevjones2010 9 years ago)
Husqvarna K760 Saw
Saw runs but dosnt rev up properly checked fuel filter in tank use husqvarna oilguard In mix
Saw runs but dosnt rev up properly checked fuel filter in tank use husqvarna oilguard In mix
(Posted by Ctrav73 9 years ago)
440 X-torq Saw Starts But When Engaging Gas Seems To Die Out And Seems Clutch Is
Seems when putting the throttle down the chain seems binding like a clutch tightens up and will kill...
Seems when putting the throttle down the chain seems binding like a clutch tightens up and will kill...
(Posted by Meredithclark 9 years ago)