Hotpoint HDA3500NWW Support Question
Hotpoint HDA3500NWW Support Question
Find answers below for this question about Hotpoint HDA3500NWW - Dishwasher w/ 5 Wash Cycles.Need a Hotpoint HDA3500NWW manual? We have 2 online manuals for this item!
Question posted by bonnieboslem on March 11th, 2013
Hotpoint Aquarius Dishwasher
I have a Red Cross that stays on what does this mean?
Current Answers
Related Hotpoint HDA3500NWW Manual Pages
Installation Instructions - Page 1
...Hours.
Keep these instructions completely and carefully. Installation of the installer. If you received a damaged dishwasher, you have questions, call 800.GE.CARES (800.432.2737) or visit our website at...8226; Skill Level -
GE Consumer & Industrial Appliances
Installation Instructions
Built-In Dishwasher
If you should be
installed to allow for future removal from the enclosure if...
Installation Instructions - Page 3
...;�
��
���
Figure A
• Make sure the flo�o�r�is completely enclosed at the time of installation.
• The dishwasher must have a minimum width and depth of 24" and height of 34-1/2" ± 1/4" #fr2o82mFrtehncehfloor to the underside of the countertop.
• The back...
Installation Instructions - Page 4
...65533;�
or Disposer
Provide a method to attach the drain hose to the
underside of the dishwasher, which may be used . Failure to the air gap requirement determined above the floor level....is installed on an elevated platform, a high drain loop of drain installation depends on a pedestal lf the dishwasher is YES, an air gap (Method 1) must be used . Min.
32" Min.
18" Min....
Installation Instructions - Page 5
...maximum diameter hole to the equipment grounding terminal or lead on the right front of dishwasher. • For permanent connections, the cable must be 2 wire with the ... equipped with Power Cord Models Only)
Hole Diameter 1-1/2" Maximum
Electrical Connection to Dishwasher Electrical connection is on the appliance. Installation Preparation-Electrical Supply
PREPARE ELECTRICAL WIRING
...
Installation Instructions - Page 6
..., or cut an additional 1-1/2" diameter hole to leak and
cause water damage.
1-1/2" Dia. If a power cord with plug is on the left side of the dishwasher. CAUTION
The hot water supply line pressure must be at least 19" from either side, rear, or floor
within the shaded area shown in Figure...
Installation Instructions - Page 7
...Factory-equipped Power Cord
Models Only) -Appendix
STEP 2: CHECK DOOR BALANCE
• With the dishwasher on its back.
• Remove the four leveling
legs from the full open position.
•... in this step
Slide
panepl tuolltfhoerwleaftrdantodrtehmenovgeently
Toekick
This will occur.
• Move the dishwasher close to the installation
location and lay it on the wood base, check the ...
Installation Instructions - Page 8
... Valve Bracket
Fill Hose
Junction Box Bracket
Ground
White
Black
STEP 7: INSTALL DRAIN HOSE TO DISHWASHER DRAIN PORT
Skip this step you will need the drain hose and clamp set aside in ... 422 and/ or local codes and ordinances. The power cord and connections must comply with the dishwasher
Strain Relief
Figure L
Drain Hose Prevent drain hose damage
and possible leaks. Be sure wires are...
Installation Instructions - Page 10
... opening a few inches at a time.
If the insulation is "bunched up " and it is not kinked under the dishwasher. • The dishwasher tub flange should be level for
proper dish rack operation, wash performance, and door operation. They should close without hitting
• Replace the lower rack. Do not push against front...
Installation Instructions - Page 14
... the door. For dial models, unlatch the door and rotate the dial to 4 minutes.
Plug the red connector into the wall outlet.
■ Latch dishwasher door. ■ For electronic dishwashers, select the normal
cycle and press the start dishwasher. Check to be sure that the water is not plugged in, turn off electrical power to...
Use and Care Manual / Warranty - Page 1
... can find them on a label on the tub wall just inside the door.
165D4700P343 49-55023-1 04-07 JR Dishwashers
ge.com
Safety Instructions 2, 3
Operating Instructions
Care and Cleaning 12 Control Panels 6 Control Settings 4-5 Dial Cycles 7 Flashing Display Lights 8 Loading the Dishwasher Racks 10 Loading Place Settings 11 Optional Accessories 12 Using the...
Use and Care Manual / Warranty - Page 2
... maintenance.
Check with the circuit conductors and connect to the hot water system. I Connect the dishwasher/appliance to a wall switch, ensure that is on before handling. I Close supervision is properly grounded. NOTE: Turning the dishwasher off
between wash cycles, allow them to run an equipment-grounding conductor with a qualified electrician or service representative if...
Use and Care Manual / Warranty - Page 3
... if they are properly in this or any other appliance.
Safety Instructions
WARNING! RISK OF CHILD ENTRAPMENT PROPER DISPOSAL OF THE DISHWASHER
Junked or abandoned dishwashers are getting rid of the washing compartment
or remove the door latch keeper (as described in place. I Do not abuse, sit on or stand on or inside...
Use and Care Manual / Warranty - Page 4
... time to your wash cycle by touching pads with RINSE ONLY cycle.
Troubleshooting Tips
Consumer Support
4
HEAVY WASH This cycle will turn off . WATER SAVER For dishes with medium soils. LIGHT WASH
(on some models. PLATE WARMER
HOT PREWASH Preheats wash water to boost water temperature in all pads become inoperative.
Children cannot accidentally start dishwasher by 30...
Use and Care Manual / Warranty - Page 7
... the door is unlatched.
3 Slowly turn the Dial to RINSE ONLY. 4 Latch the door to start the cycle. There is a time delay between start-up to 6 hours.
1 Be sure the door is unlatched. 2 Select the wash cycle and option you will be warmed. 2 Select HEATED DRY ON. 3 Be sure the door is unlatched...
Use and Care Manual / Warranty - Page 8
... beeper and the dishwasher will be programmed. Also, if a power failure occurs, NORMAL and HEATED DRY will stay ON until the door is in the locked position, the control panel lights will attempt to turn off the beeper.
Clean This light is illuminated when a wash cycle is normal. If you start a new wash cycle. Operating Instructions...
Use and Care Manual / Warranty - Page 9
... OFF before adding detergent.
Adjust the maximum/minimum temperature of the water heater if necessary to the
dishwasher, your dishes will cause the dishwasher to place in the main cup and close.
All wash cycles require detergent in dishwashers. Be sure the Dial is recommended. Add detergent then close and latch properly. Don't put powder...
Use and Care Manual / Warranty - Page 10
...for glasses, cups and saucers.
The soiled side of the lower rack during the wash cycle.
Silverware Basket
Put flatware in the front right corner.
Troubleshooting Tips
Consumer Support
10... the upper rack wash tower. Secure larger dishwasher-safe plastics over two fingers when possible.
The lower rack is for dishwasher-safe plastics. Don't block the wash tower or load ...
Use and Care Manual / Warranty - Page 11
... rise out of racks and silverware baskets may vary from your model. Features and appearance of the dishwasher. 3 Add forgotten dish. 4 Close the door and push the latch to the far right. Tips... for loading 10 place settings. ge.com
Follow these guidelines for Loading and Good Wash Performance
I Don't let items fall through rack and block spray arms.
11
Consumer Support A forgotten ...
Use and Care Manual / Warranty - Page 13
...cycle for use your kitchen sink is clogged
• If you do so can be
this problem. Citric
acid (Part number: WD35X151) can result in the water supply line is provided through GE Parts.
Power is turned off
• In some installations, power to the dishwasher... Safety Instructions
Before you call for service.
in dishwasher. Add 1 gallon of stains. On Models with...
Use and Care Manual / Warranty - Page 14
...; Turn the Timer Dial to complete the cycle. To prevent this from the dishwasher.
2 Do not add detergent.
3 Select the longest cycle.
4 Start the dishwasher and allow to OFF. Dial is temporarily ...8226; Use HOT START and ADDED HEAT options. • Select a higher cycle, such as POTS & PANS or HEAVY WASH. Is water coming out more slowly than usual?
detergent cups
This is normal...
Similar Questions
Dishwasher Model: Hda2000tww
I put this Dishwasher in my rental. Has not been used much over the last year or so. My current rent...
I put this Dishwasher in my rental. Has not been used much over the last year or so. My current rent...
(Posted by Two4spurs 11 years ago)
Hotpoint Aquarius Fdw20 Dishwasher
machine not working and prewash light flashing whatever cycle is selected, filter cleaned pipes not ...
machine not working and prewash light flashing whatever cycle is selected, filter cleaned pipes not ...
(Posted by marlenrichards 11 years ago)
Dishwasher Racks Are Rusting. Are They Under Warranty Or Can They Be Replacerd
Dishwasher is 6 years old and works fine.
Dishwasher is 6 years old and works fine.
(Posted by 22stuart 11 years ago)
Dishwasher Runs Through Cycle But Makes A High Pitched Whining Noise.
Dishwasher is a Hotpoint, model HDA2000TBB
Dishwasher is a Hotpoint, model HDA2000TBB
(Posted by mgs61 12 years ago)
Installing A Ge Gsm2260nss Under Sink Dishwasher With Gpf97 Double Bowl Sink.
I am installing aNew GE GSM2260NSS Under Sink Dishwasherwith theGPF97 Double Bowl Sink. I am running...
I am installing aNew GE GSM2260NSS Under Sink Dishwasherwith theGPF97 Double Bowl Sink. I am running...
(Posted by myrthmaker 12 years ago)