Hoover U6485900 Support Question
Hoover U6485900 Support Question
Find answers below for this question about Hoover U6485900.Need a Hoover U6485900 manual? We have 1 online manual for this item!
Question posted by bonnie29535 on April 21st, 2013
My Windtunnel Series T Will Not Turn On The Beater Bar When Vacumming
The person who posted this question about this Hoover product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Hoover U6485900 Manual Pages
Manual - Page 3
... on data label on floor. Brushroll continues to rotate when in the upright position. • Turn off all parts of cleaner. • Do not leave appliance when plugged in. To avoid ... flow. • Keep hair, loose clothing, fingers, and all controls before operating. • Operate vacuum only at bottom of stairs on lower handle of body away from openings and moving parts.
Unplug from...
Manual - Page 4
... the risk of filter bag;
If the plug does not fit fully in any way. If it from images shown. 4 Do not change if needed. 3. Turn cleaner OFF and unplug it still does not fit, contact a qualified electrican to clean out hose as they can cause damage. If this appliance has...
Manual - Page 6
....
1.8
1.9 Snap dusting brush (H), crevice tool (I) and furniture nozzle (J) into storage area on back of cleaner.
1.10
1.10 Insert turbo tool into bottom of cord. To turn cleaner OFF, push switch down.
2.2
Actual model may be purchased separately by visiting www.hoover.com, or your local HOOVER® service center. To...
Manual - Page 7
...-propel feature
2.3 This feature allows you know that the 'Dirt FINDER' feature is ready the red light will come on when the cleaner is first turned on. To move your cleaner from you should take additional cleaning strokes in upright position, tilt cleaner back on rear wheels and push forward.
2.4
Carrying...
Manual - Page 8
... desired setting. To easily adjust the carpet height adjustment, lightly lift the front of cleaner, and use only forward strokes. Slide control to "Carpet" to turn brushroll ON for very deep pile carpet where easier pushing effort is in carpet near baseboards and furniture. Slide control to "Hard" to...
Manual - Page 9
... tool may be used for convenience in such places as dresser drawers, upholstered furniture, stairs and baseboards. E. G
H
Attach second wand or tool to another. CAUTION ! A
Turn cleaner OFF before disconnecting and connecting hose to tighten or loosen the connection. D. Use them with any tool or wand to the hose (G) by pushing...
Manual - Page 10
... completely red:
1.
IMPORTANT
All new carpet has loose fibers which can fill the bag quickly while vacuuming.
Actual model may cause it to burst even though it into (J) and twist hose to the ...red as proper use and care of the cleaner, in the hose, tools or at the front of your vacuum.
Any other end of hose.
2.16
I J
Check bag indicator
2.18 The indicator (K) will begin ...
Manual - Page 11
....
! To reduce the risk of bag compartment, protects the motor from moving parts, unplug vacuum before servicing. Do not operate cleaner without either the secondary or final filter in place.
3.4...for Hoover® Part No. 38765023.
11 Actual model may vary from moving parts, unplug vacuum before servicing.
Discard used filter bag. Removing Bag Door
3.1 To change filter bag, grasp ...
Manual - Page 12
... washable -
CAUTION ! Remove debris as follows: 1) Disconnect cleaner from moving parts, unplug vacuum before cleaning or servicing. Installing Bulb and Replacing Lens
3.8 Pull old bulb straight out of...the cleaner. Excessive force is pushed open the door on the side of cover with your WindTunnel™ cleaner picks up and suction.
! Do not operate cleaner without either the secondary or...
Manual - Page 13
... only genuine HOOVER® belts with a Phillips screw driver. Unplug cleaner before turning it is stretched, cut or broken.
If desired, additional belts can start suddenly. BeltS
The belts ...are in low position and turn cleaner over so bottom side is described below; The flat (wide) belt is up.
When...
Manual - Page 14
...replace brushroll if brushes do not touch card. V-belt
!
How to Inspect
The V-belt is turned over pulley (C). However, if V-belt is cracked, gouged or broken, now is not normally .... To install new belt (with lettering on side of a card across bottom plate while turning brushroll. If desired, additional belts can start suddenly. Brushroll
! When brushroll brushes are worn...
Manual - Page 15
... both sides of the front of tool.
3.20 Remove bottom plate (B).
3.21 Remove any debris and/ or hair from hose before turning it over.
3.22
When to Clean
3.19 Turn tool so bottom faces up. Powered Hand Tool
! Rotate the latches (A) on both old edge groomers and slide new edge groomers into...
Manual - Page 16
... cause damage. b. Check connection at end of the motor. Lubrication
The motor is found:
1. Disconnect powered hand tool from images shown. 16
Unplug cleaner before turning it over.
3.23
3.24 F
A
Low suction or pick up may vary from hose. Remove bottom plate, belt guard and turbine as follows:
1) Disconnect hose from...
Manual - Page 17
... bare floor position.
Change filter bag. Cleaner hard to tool.
Clear obstruction.
Replace brushroll.
Replace belt. Incorrect carpet height setting. Powered hand tool brushroll won't turn
Flat belt broken or worn Too much pressure being applied to Incorrect carpet height setting. Replace belt Continue using the checklist below.
No voltage in...
Manual - Page 18
...-7pm EST. Follow the service center link to Hoover®, Inc., Company in delay. This will only result in Glenwillow for service. Always identify your vacuum to find the service outlet nearest you need further assistance: To speak with a customer service representative call 1-800-944-9200. Customers) or hoover.ca (Canadian...
Similar Questions
My Vacuum Will Not Turn On Can You Help Me?
My vacuum will not turn on can you help me?
My vacuum will not turn on can you help me?
(Posted by Revalencia52 7 years ago)
Windtunnel U6485900 Beater Bar Won't Turn And Replaced Belts. What Else Can I Do
(Posted by mross3871 10 years ago)
Beater Bar Will Not Work Anymore On My Seven Month Old Vacuum.
Hello, I was vacuuming my camper out and turned it off to go into the next room. when I plugged it ...
Hello, I was vacuuming my camper out and turned it off to go into the next room. when I plugged it ...
(Posted by jennifermeade 11 years ago)
Beater Bar
Red light on my UH70400 is blinking and the beater bar will not turn on. What's the problem? Thanks.
Red light on my UH70400 is blinking and the beater bar will not turn on. What's the problem? Thanks.
(Posted by sphudson 11 years ago)
Beater Bar Belt
I have a hoover wind tunnel and have had it about 1-2 years. My belt does not turn the beater bar. I...
I have a hoover wind tunnel and have had it about 1-2 years. My belt does not turn the beater bar. I...
(Posted by emilyandryan01 11 years ago)