Hoover S3670 Support Question
Hoover S3670 Support Question
Find answers below for this question about Hoover S3670 - WindTunnel Bagged Canister Vacuum Cleaner.Need a Hoover S3670 manual? We have 1 online manual for this item!
Question posted by nccorgi on August 14th, 2014
Motor That Controls Brush Doesn't Work...belt Is Not Broken! Any Ideas?
I lightly bumped the leg of a table and the motor just stopped working...no smoke, no smell, no funny noise. I just stopped working. I took everything apart and it's not the belt and it's not jammed...so it's either the motor or the switch...my guess is the motor.
Current Answers
Related Hoover S3670 Manual Pages
Manual - Page 1
Hoover®
TM
WindTunnel Canister Cleaner with Powered Hand Tool
Owner's Manual
English ➜ pp. 1-14 Español ➜ pàg.15-21 Français ➜ p. 22-28
Review this manual before operating cleaner. www.hoover.com
Manual - Page 2
... clothing, fingers, feet and all controls before connecting or disconnecting hose, motorized nozzle or powered hand tool. • Do not use . Keep cord away from heated surfaces. • Always disconnect cord from electrical outlet before servicing the cleaner. • Always unplug cleaner when not in use without dust bag or filters in the spaces provided...
Manual - Page 3
... in cleaner) D. Carton contents
1-1
A
B
C E
D F
Unpack cleaner from the factory. Extra paper bag (one bag is locked in bag lid....9200 for connection to the power nozzle. Canister cleaner with the storage clip connects to the power...is
installed in our Consumer Response Center Mon-Fri 8AM-7PM EST. WindTunnel™ powered nozzle C. Hard Floor Tool
Connect hose, wands and nozzle...
Manual - Page 4
... thermal protector will stop running.
This cleaner is intended for storage. Note: The canister must remain unplugged during the 30 minute cooling period.
4 tom of the bag. Carrying handle
Operate cleaner only at the opening of cleaner. 5.Wand/release latch: Used to rewind cord for household use. When the blockage is rewound. 14. WindTunnel™ carpet and...
Manual - Page 5
... surface selector button on canister.
Turn cleaner on the power nozzle and pull handle back. There are three conditions that will find it is not full.
3. The bag is wider than the ...will show a red light as bag fills with the power nozzle: upright and operating.
Check bag indicator
The indicator will fit in the outlet, reverse the plug. change the bag, even if it ...
Manual - Page 6
...control
The variable speed control (F) is difficult to push, push the (-) button to clean lightly...loosen connection.
2-11
Slide combination tool apart to open (N).
Push the (+) ...used for carved furniture, table tops, books, lamps, lighting fixtures, venetian blinds, baseboards...cleaner underneath the tool lid (M). Cleaning tools
The cleaning tools are provided on the canister. Guide side ...
Manual - Page 7
... and care of the Filter Bag and may not light up fine materials, such as shown. Note: The canister bag lid will give satisfactory performance. Filtration Type S disposable filter bags. Filter bag
When to replace
Disconnect cleaner from bottom to the side, lift bag lid latch and open bag lid.
3-2
Carefully pull out used Filter Bag and replace with a new...
Manual - Page 8
... out. Use only a genuine HOOVER Belt part no. 40201180 when a belt replacement is important for Hoover part no . 59142009.
3-8
The high efficiency exhaust filter aids in the bag compartment, protects the motor from time to time to be sure it is stretched, cut, or broken.
3-9
How to replace
Disconnect cleaner from electrical outlet and disconnect power...
Manual - Page 9
... and 2 long screws at the front.
9 Push belt end forward, rotating end plate (F) until it rotates freely.
Replace 2 short screws at the back of agitator brush roll in place. Lift off brush roll cover (C).
3-13
D If belt is not broken but is stretched or cut, pull it off the motor pulley (D).
3-14
E
3-15
3-16
Lift up...
Manual - Page 10
... shown in Figs. 3-15 to 3-17.
Push old bulb into place. 3.
How to replace
Disconnect cleaner from electrical outlet.
1. What to buy
When purchasing edge groomers, ask for HOOVER part no . 39511004. Replace new brush roll and belt as shown in Figs. 3-9 to 3-12.
10
3-20
H G 2.
Push new bulb into socket and twist...
Manual - Page 11
..., making sure not to ensure that it rotates freely.
Inspect belt to pinch brush bristles in good condition. Press the latches on either side of bottom plate into slots (E) on front of tool. Replace belt guard (B) making sure it is cracked, gouged or broken, replace it so bottom faces up. To replace bottom plate...
Manual - Page 12
...authorized service outlet locations (U.S. Therefore, do not send your cleaner by :
• checking the Yellow Pages under "Vacuum Cleaners - Remove bottom plate, belt guard and brush roll as described in Figs. 3-21 through 3-23.
2. H G
4.
Powered hand tool Belt replacement
Inspecting the belt
The powered hand tool belt is designed to last a long time and is needed...
Manual - Page 13
.... • Replace paper bag.
• Blockage in .
• Plug firmly into receptacle on . Refer to the following steps to check for suction and remove any obstructions. 3. Remove any blockage from wand. Then check for 30 minutes before switching the vacuum back on cleaner base.
• Broken or worn belt. • Replace belt.
• Floor surface switch...
Manual - Page 14
...to you , to misuse, acts of God, nature, vandalism or other acts beyond the control of Hoover, owner's acts or omissions, use outside the United States, including its territories and...of Ohio. However, if you specific rights;
This warranty gives you mail your HOOVER® WindTunnel™ product is warranted against original defects in a commercial operation (such as warranted, take...
Similar Questions
Power Pedal Broken?
the power pedal on my Hoover won't stay down. How do I take it apart to see if something is broken
the power pedal on my Hoover won't stay down. How do I take it apart to see if something is broken
(Posted by Bassettcomeau 2 years ago)
Burning Smell In Hoover Uh72400 Vacuum. Brush Bar Is Working
burning smell from engine of hoover uh72400 vacuum. brush bar is working.
burning smell from engine of hoover uh72400 vacuum. brush bar is working.
(Posted by Anonymous-148261 9 years ago)
Brush Suddenly Stopped...why?
I lightly bumped the coffee table and the motor suddenly shutoff. What might be the cause?
I lightly bumped the coffee table and the motor suddenly shutoff. What might be the cause?
(Posted by nccorgi 9 years ago)
The Brushes Don't Work Wat Do It I Do
The brushes wont work wat do i
The brushes wont work wat do i
(Posted by eddieisaifranco 10 years ago)
Power Nozzle Shuts Off On S3670 Windtunnel
The power nozzle on our S3670 WindTunnel Bagged Canister Vacuum Cleaner often stops working. It seem...
The power nozzle on our S3670 WindTunnel Bagged Canister Vacuum Cleaner often stops working. It seem...
(Posted by bobintampafl 13 years ago)