Hoover S3590 Support Question
Hoover S3590 Support Question
Find answers below for this question about Hoover S3590 - Duros Power Nozzle Canister Vacuum Cleaner.Need a Hoover S3590 manual? We have 1 online manual for this item!
Question posted by pat2luci on September 5th, 2013
Cord Replacement On A Hoover Duros S3590
how do I replace the cord? what type of screws are used beside philips head?
Current Answers
Related Hoover S3590 Manual Pages
Manual - Page 1
Hoover®
™
Canister Cleaner
®
Owner's Manual
English § pp. 1-10 Español § pàg.11-16 Français § p.17-22
www.hoover.com
Review this manual before operating cleaner.
Manual - Page 2
..., nozzle 3 Cleaner Description 4 How To Use Canister Cleaner 4-6 Powered Nozzle 4 Cleaning Tools 5 Cleaning Stairs 5 Storage 5,6 Maintenance Filter bag replacement 6 Cleaning filters 7 Replacing power nozzle belt ..........7-8 Replacing agitator brush roll 8 Replacing headlight 8 Lubrication 8 Service 9 If You Have a Problem 9 Clearing Blockages 9 Warranty 10
© 2004 The Hoover...
Manual - Page 3
... and nozzle
1-2
A
B
1-3 F
G E
Unpack cleaner from the factory. A. Canister cleaner B. Crevice tool E.
Push the opposite end of the wand into the power nozzle (I
J
D C
H
KL
Connect hose
Push the hose connector end (A) into the hose grip (F), making sure the prongs (C) on the end of cleaner.
1-4
I ), aligning the prongs (J) on the power nozzle with a representative in the Hoover...
Manual - Page 4
..., step on the ON/OFF pedal (A). Extension wand release buttons
4. Power nozzle
10. Power cord
24. Turn cleaner ON by sliding the control (B) towards MIN or MAX. Power nozzle
Handle positions
The handle has two positions when used with the power nozzle: upright and operating. Suction control slide switch
18. If the plug does not fit fully in a polarized outlet...
Manual - Page 5
...Power nozzle ON/OFF switch
The power nozzle ON/OFF switch (A) provides power to tighten or loosen the connection.
Round swivel brush (stores on the cleaner.
Upholstery tool (stores on extension wand) may be used...I ), located on end.
To set the power nozzle for use in the "FLOOR" position.
Twist tool slightly to the nozzle.
The head of the wand.
How to -reach spaces...
Manual - Page 6
..., it is imperative that your cleaner, use only genuine HOOVER filter bags distributed by these trademarks --
® ®
3-4
D
How to burst even though it is only partially full of dirt. CAUTION: Very fine materials, such as shown.
3-2
B
3. Discard used bag. To assure that you use only Genuine Hoover® Allergen Filtration Type SR disposable filter bags (package...
Manual - Page 7
.... Replace brush roll cover (B) over and unscrew the 2 recessed screws. Do not operate cleaner without secondary filter in the filtration process to return clean air to snap into position. Allow to the inside of the cleaner body, aids in place.
3-10
3-9
J
H
I
H B
G
If belt (E) is not broken, but are not designed for the HOOVER Duros™ power nozzle. Use only...
Manual - Page 8
... toward the center as shown in Figs. 3-10 to 3-13. 2.
Position hood on top of nozzle base. Use only HOOVER part no . 59134225. Replace 2 screws.
3-18
Agitator brush roll replacement
When to replace
Turn cleaner off and disconnect from extension wands.
1. Replace four screws. Remove hood, headlight assembly, brush roll cover, belt and brush roll as shown. The addition of...
Manual - Page 9
... with water, allow to dry and
replace in cleaner.
• Power set to "FLOOR". • Set rug/floor pedal to "RUG". • Power nozzle switch "OFF". • Turn switch to The Hoover Company in North Canton for service, this cleaner OR -
• checking the Service section of The Hoover Company online at www.hoover.com OR -
• calling 1-800...
Manual - Page 10
... period. Warranty service can only be paid one way. S.
Full One Year Warranty
(Domestic Use)
Your HOOVER® appliance is warranted in normal household use in the country or territory in the U.S.A., phone 1-800-944-9200 OR
visit The Hoover Company online at no cost to you, all labor and parts to one of...
Similar Questions
How To Change Belt For Power Nozzle?
How to change belt for power nozzle?
How to change belt for power nozzle?
(Posted by Missionnews777 1 year ago)
Switch Position For The Power Nozzle On A Sh40050 Hoover Cannister.
(Posted by NamDocPoet 12 years ago)
Power Nozzle Shuts Off On S3670 Windtunnel
The power nozzle on our S3670 WindTunnel Bagged Canister Vacuum Cleaner often stops working. It seem...
The power nozzle on our S3670 WindTunnel Bagged Canister Vacuum Cleaner often stops working. It seem...
(Posted by bobintampafl 13 years ago)