Hoover S1361 Support Question
Hoover S1361 Support Question
Find answers below for this question about Hoover S1361 - Portable Canister Cleaner.Need a Hoover S1361 manual? We have 1 online manual for this item!
Question posted by rdegrace on October 25th, 2011
Need To Remove The Top Removed 4 Screws From Inside Lid What Else Holds It On
The person who posted this question about this Hoover product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Hoover S1361 Manual Pages
Manual - Page 1
... Review this manual before being shipped from the factory.
Canister Cleaner
Owner's Manual
ENGLISH § pp. 1-9 ESPAÑOL § pág. 10-14 FRANÇAIS § p.15-19
Thank you for automated referral of authorized service outlet locations (U.S. If you should happen to need assistance during assembly or operation,
Visit our website...
Manual - Page 2
...loose clothing, fingers, and all controls before servicing the cleaner.
• Unplug cleaner when not in place. Index
Assembling Cleaner 3 How To Use
Canister Cleaner 4-5 Cleaner Descriptions 4 Cleaning Stairs 5 Cleaning Tools 5 Rug and .... Do not allow vacuum cleaner to be required for its intended use with wet hands.
• If cleaner has a cord reel, hold onto the plug while cord...
Manual - Page 3
...cleaner...cleaner...need assistance during assembly or operation,
Visit us online at www.hoover.com to tighten or loosen connection.
tighten. Remove... and dispose of authorized service outlet locations (U.S. Extra filter paper bag (one bag is stored on the "Service" button) OR Call 1-800-944-9200 for an automated referral of packing. Assembling cleaner...in cleaner)
D. Canister cleaner
...
Manual - Page 4
...12 10. Bag lid
14. Dusting brush/crevice tool 18.
Listed below are provided. 1. change the plug in the nozzle, hose, tools or at voltage specified on data plate on top of canister.
3. There is ...from one blade is about 2/3 red, the bag should be changed. Hold plug until cord is not full. 3. Operate cleaner only at the bag opening; The nozzle has a BARE FLOOR setting...
Manual - Page 5
Remove the brush and use the crevice tool in tight spaces, corners and along edges in heavily soiled areas.
Attaching tools
...the same manner. Wand storage clip
The wand storage clip (F) fits into the slot (G) at the rear of the cleaner or the slot (H) on the bottom of the cleaner. Push tool firmly onto hose; mum cleaning power in such places as shown. twist tool slightly to top.
5 ...
Manual - Page 6
... used bag. What bags to buy bags
Bags may cause it is important to remove material of dirt.
Close bag lid.
6 Filter bag
When to time.
HOOVER bags can be purchased from time to replace
Check bag from your cleaner. Place bag holder and new bag into holder.
When bag is used to...
Manual - Page 7
..." OR -
• checking the list of Factory Service Centers provided with this happens, turn cleaner OFF and disconnect cleaner from electrical outlet. Then disconnect nozzle and remove obstruction.
It is needed, contact The Hoover Company Consumer Response Center, North Canton, Ohio 44720, Phone: 330-499-9499. In Canada, contact Hoover Canada, Burlington, Ontario L7R...
Manual - Page 8
... warranty gives you specific legal rights, you have other surfaces before service is needed, or if there are covered by using the check list below.
Turn cleaner OFF and remove any blockages.
3. Hoover Factory Service Centers.
2.
Before attaching nozzle to state. Remove nozzle from hand grip.
4-1
2. This warranty only applies when the product is...
Similar Questions
How Do I Remove Clear Cover On Dirty Water Tank , After I Remove Screws On Sucti
I see there are screws at bottom suction edge and two under what I believe is float cap ? not sure h...
I see there are screws at bottom suction edge and two under what I believe is float cap ? not sure h...
(Posted by digitdeeper 8 years ago)
How Do I Take Reservoir Tank Apart? I Have Removed Screws
(Posted by shanna 12 years ago)
My Hoover Max Extract Carpet Cleaner Is Not Extracting Enough Water.
I full tank of water and detergent, 3/4 cup dirty water extracted. Have I assembled it wrong?
I full tank of water and detergent, 3/4 cup dirty water extracted. Have I assembled it wrong?
(Posted by jeannien 13 years ago)